(a) What is the internal resistance of a voltage source if its terminal potential drops by 2.00 V when the current supplied increases by 5.00 A? (b) Can the emf of the voltage source be found with the information supplied?

(a) What is the internal resistance of a voltage source if its terminal potential drops by 2.00 V when the current supplied increases by 5.00 A? (b) Can the emf of the voltage source be found with the information supplied?

College Physics

1st Edition

ISBN:9781938168000

Author:Paul Peter Urone, Roger Hinrichs

Publisher:Paul Peter Urone, Roger Hinrichs

Chapter21: Circuits And Dc Instruments

Section: Chapter Questions

Problem 63PE: The timing device in an automobile’s intermittent wiper system is based on an RC time constant and...

See similar textbooks

Related questions

Q: Consider an initially uncharged capacitor in an RC circuit. The resistance is 22,489 Ohms and the…

Q: If you wish to take a picture of a bullet traveling at 500 m/s, then a very brief flash of light…

A: A Flash tube is an electric lamp which is used to produce extremely intense white light for a very…

Q: In the circuit shown in the figure, the S switch is closed at t = 0 and the capacitors, which are…

Q: If E = 7.50V and r=0.45Ω, find the minimum value of the voltmeter resistance RV for which the…

A: The voltmeter reading is found to be,

Q: A parallel plat capacitor is being charged by a battery of E=12 V. If the total resistance of the…

Q: Using the exact exponential treatment, determine how much time is required to charge an initially…

A: Write the given values with suitable variables. R=75 MΩ=75×106 ΩC=100 pF=100×10-12 FVV0=0.9 Here, R…

Q: How much electrical energy is transferred to thermal energy in 2.00 hrs by an electrical resistance…

A: The potential difference,

Q: Using the exact exponential treatment, find how much time is required to discharge a 270 µF…

Q: ain car battery with a 12.0 V emf has an initial charge of 162 A·h. Assuming that the potential…

Q: Te-Learning Portal Courses - Reports e-Services - Academic Departments - ETC - CIMS - Salim During…

A: a) R = 14/3.1 = 4.52 Ohm b) fractional uncertainty ∆R/R = (∆V/V+∆i/i) = (0.5/14) + (0.2/3.1) =…

Q: If you try and measure the voltage of a battery with a voltmeter connected in series, you won't get…

Q: Using the exact exponential treatment, find how much time is required to discharge a 250-μF…

Q: In the circuit given below, G= 8 S. Find io and the power dissipated in each resistor using nodal…

Q: Consider the circuit shown in the figure, with resistance 948 N and and capacitance 0.0847 µF. Vin…

A: GivenResistance ,R=948 ohmCapacitance, C=0.0847 μF

Q: Ideal voltmeters are set to read five effective values and connected as shown. Let R = 200 N, L =…

A: Step 1: In RLC circuit, Impedance is given by: Z = sqrt (R^2 + (XL - Xc)^2) XL = w*L, and Xc =…

Q: If the voltage drop for the 100 resistor is 2 V, calculate the total current I and the Voltage of…

A: Q 3: Given: Resistance, R1 = 10 ohm Resistance, R2 = 40 ohm Voltage in 10 ohm is 2 V.

Q: in the curcuit shown in the figure , the S switch is closed at t = 0 and the capacitors, which are…

Q: A voltage ΔV is applied to a series configuration of n resistors,each of resistance R. The circuit…

A: Formula to calculate the resistance across the circuit when resistors are connected in series…

Q: How much electrical energy is transferred to thermal energy in 2.00 h by an electrical resistance of…

Q: Consider a capacitor C that is tully charged by a 10 V power supply. Loter on the resistor R, shown…

Q: Using the exact exponential treatment, find how much time is required to charge an initially…

A: Resistance , R = 73 MΩ = 73 x 106 Ω . Capacitance , C = 132 pF = 132 x 10-12 F Rate of final voltage…

Q: What is the value of the unknown R if the voltage across the 500 resistances is 4.00 V?

A: This circuit can be analysed by using ohm's law, kirchoff's voltage and current law. Ohm's law -…

Q: What value resistor will discharge a 2.90 μF capacitor to 20.0% of its initial charge in 2.60 ms?

A: Formula for the discharging of a capacitor is:

Q: An ECG monitor must have an time o less than 2.00 x 102 us to be able to variations in voltage over…

A: A capacitor is an electrical component that is used to store the energy. Answer C max =1 × 10- F

Q: How much electrical energy is transferred to thermal energy in 2.50 hrs by an electrical resistance…

Q: Given the function: V(t) = 10 sin (2n 50t). Sketch the voltage time graph that shows this function.

A: Required : Graph of the given voltage function.

Q: A high tension (HT) supply of, say, 6 kV must have a very large internal resistance. Why?

A: Given: V = 6 kV

Q: A battery with an emf of 12.0 V has a terminal voltage of11.5 V when the current is 3.00 A. (a)…

A: a)Terminal voltage is given by

Q: What voltage drop will be there across a 1 kw electric heater element whose resistance when hot is…

A: The electric power in terms of voltage and resistance is P =V2R

Q: Power P0 = I0 ∆V0 is delivered to a resistor of resistance R0.If the resistance is doubled (Rnew =…

A: Given,

Q: A uniform 2-wire d.c. distributor 600 meters long is loaded with 0.1 ampere/ meter and is fed at one…

Q: Find the value of the node voltage V. V 10A BA 10 ohm O a. -60V O b. 20V Oc. 40V O d. -40V

Q: A 3.02 resistor is connected to a non-ideal source with internal resistance r = 1.0N and EMF E = 16…

A: Given data :- R = 3 ohm r = 1 ohm EMF E = 16 V Reading of voltmeter V' = 12 V

Q: Consider the circuit shown in (Egure 1) The battery has emf 72.0 V and negligible internal…

Q: An ECG monitor must have an RC time constant less than 1.00 × 102 μs so it can measure variations in…

A: Time constant (T) = 100μs= 100×10-6 s = 10-4 s Resistance of circuit (mainly due to patient's chest)…

Q: Consider 3 resistors with resistances 1.15 × 102 Ω, 2.1 kΩ, and 3.8 kΩ. What would be their…

Q: Find the value of R so that the power of 10k2 load resistor is 10mW, by assuming the source voltage…

A: This is an op-amp and the given circuit is a noninverting amplifier. Given(s): The input voltage,…

Q: Suppose you measure the terminal voltage of a 3.200-V lithium cell having an internal resistance of…

A: The terminal voltage is V=E-Ir where E= Emf, I= Current, and r= Internal Resistance.

Q: Is it possible to connect a group of resistors of value R in such a waythat the equivalent…

A: If two or more number of resistors of different or equal resistances is connected in parallel…

Q: Consider an initially uncharged capacitor in an RC circuit. The resistance is 20,000 Ohms and the…

Q: How many time constants must elapse if an initially charged capacitor is to discharge 55% of its…

A: The expression for the energy stored in the resistor at time t is: E=E'e-2t/RC As per the problem,…

Q: What is true in general about the voltage (potential) supplied by the battery compared with the drop…

Q: The switch on an RC circuit is closed at t = 0. Given thate = 6.0 V, R = 92 Ω, and C = 28 mF, how…

A: Given: Resistance R=150 Ω Capacitance C=28×10-6F Time t=4.0 ms=4.0x10-3 s Emf E=6V

Q: In the circuit, using source transformations, calculate the voltage Va 8 V 100 N + 10 V Va 100 2 100…

Q: The capacitance in the curcuit is C = 0.3μF, the total resistance is R=20kQ and the battery emf is…

A: Capacitance of the capacitor (C) = 0.3 μFResistance (R) = 20000 ohm Emf (E) = 12 volts Initial…

Q: Consider the circuit shown in Fig.T 8.3. The termi- nal voltage of the 24.0-V battery is 21.2 V.…

Concept explainers

Ohm's law

Ohm’s law is a prominent concept in physics and electronics. It gives the relation between the current and the voltage. It is used to analyze and construct electrical circuits. Ohm's law states that the voltage across a conductor is directly proportional to the current flowing through it.

Path of Least Resistance

In a series of alternate pathways, the direction of least resistance is the actual or metaphorical route that offers the least resistance to forwarding motion by a given individual or body.

Question

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

This is a popular solution!

SEE SOLUTION Check out a sample Q&A here

Part (a)

Step 2

Step 3

Part (b)

Trending now

This is a popular solution!

Step by step

Solved in 4 steps with 5 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, physics and related others by exploring similar questions and additional content below.

Similar questions

The timing device in an automobile’s intermittent wiper system is based on an RC time constant and utilizes 0.5.00F capacitor and available resistor. Over what range must R be made to vary to achieve time constants from 2.00 to 15.0 s?
Suppose you wanted to charge an initially uncharged 110 pF capacitor through a 55 MΩ resistor to 90.0% of its final voltage. How much time (in s) would be required to do this?
A Christmas light is made to flash via the discharge of a capacitor. The effective duration of the flash is 0.21 s (which you can assume is the time constant of the capacitor), during which it produces an average 35 mW from an average voltage of 2.85 V. What is the resistance, in ohms, of the light?
Using the exact exponential treatment, find how much time is required to charge an initially uncharged 100-pF capacitor through a 75.0-M Ω resistor to 90.0% of its final voltage.
The capacitance in the curcuit is C = 0.3μF, the total resistance is R=20kQ and the battery emf is 12 V. Determine the time is takes for the charge the capacitor could acquire, to reach 99% of max value.
What is the internal resistance of a voltage source if its terminal voltage drops by 2.00 V when the current supplied increases by 5.00 A?
Using the exact exponential treatment, find how much time is required to charge an initially uncharged 50-uF (micro-Farad) capacitor through a 75 M-Ohm (mega-ohm) resistor to 60.0% of its final voltage.
An ECG monitor must have an RC time constant less than 1.00 × 102 μs so it can measure variations in voltage over small time intervals. If the resistance of the circuit (due mostly to that of the patient’s chest) is 0.85 kΩ, what is the maximum capacitance of the circuit in F?
A high tension (HT) supply of, say, 6 kV must have a very large internal resistance. Why?
Consider an initially uncharged capacitor in an RC circuit. The resistance is 20,000 Ohms and the capacitance is 500 x10• F. If the source potential being used to charge the capacitor is 15 V, how long after charging begins will the power delivered to the resistor be 25 % of its maximum value?
What is true in general about the voltage (potential) supplied by the battery compared with the drop in potential across the resistor? What can you conclude about the drop in potential because of the wires, switch and ammeter?
Consider an initially uncharged capacitor in an RC circuit. The resistance is 22,489 Ohms and the capacitance is 420 x 10^-6 F. If the source potential being used to charge the capacitor is 15 V, how long after charging begins will the power deliver to the resistor be 25% of its maximum value?