(a) What is the relationship between surface tension andtemperature? (b) What is the relationship between viscosityand temperature? (c) Why do substances with high surfacetension also tend to have high viscosities?

Q: Suppose you shade a square of side 1.0 cm with a pencil that leaves a layer of graphite 315 nm…

A: The square of side 1.0 cm is shaded with pencil. The thickness of graphite layer is 315 nm.

Q: Explain the significance of the triple point?

A: In thermodynamics, a material's triple point is the temperature and pressure at which its three…

Q: The viscosities of five liquids at 25°C are given in the following table. Explain the observed…

A: Following factors affects the viscousity of a liquid .

Q: 5 if the viscosity of Nacl = 664.256 mpa.s viscosity of NaOH= 1.00979 cp viscosity of water= 0.6531…

A: We have to calculate the viscosity of the entire mixture. The given data is:\ Viscosity of NaCl=…

Q: What are all the different types of phase transitions ? Classify based on diffusion and sub types.

A:

Q: Graphically show the variation of viscosity (h) of a liquid with temperature (T)

A: Viscosity (h) of a liquid decreases with increase in the temperature (T).

Q: 3. Calculate the melting point of ice under a pressure of 50 bar. Assume that the density of ice…

A: Water has three phases. They are ice, liquid water and vapour phase. These phases convert to each…

Q: 7. Another phase change is the denaturation of a protein from a normal, folded state to a disrupted,…

A: A question based on chemical thermodynamics that is to be accomplished.

Q: In terms of their bulk properties, how do liquid and solid differs? How are they similiar?

A: There are mainly three physical states in which matter exist- solids, liquid, and gases. A substance…

Q: Explain how molecular weight of a polymer can be determined by dilute viscosity measurements?

A: Polymers are composed of multiples of simpler chemical units i.e. monomers or we can say polymers…

Q: Estimate the thermal diffusivity of butter at 20 degrees Celsius

A:

Q: Give the nature of the phases found in the following phase diagram in the numbered areas and degrees…

A: The above diagram is phase diagram of CaO-ZrO2 system.

Q: What is the relationship of viscosity to the rate of flows of liquids?

A: Viscosity is a measure of a fluid's resistance to flow. It describes the internal friction of a…

Q: Explain the differences in the viscosities of toluene and nitrobenzene relative to water. What…

A: Viscosity of the fluid substance is defined based on the resistance a liquid faces while flowing…

Q: Describe the process occurring at the molecular level thataccounts for the property of viscosity.

A: Viscosity of a liquid is the measure of its resistance to flow and this resistance to flow is caused…

Q: What is the Miller index of the plane intersecting the crystal axes (2a, 1b, -3c)?

A: In crystal Lattices, Miller index is a notation system to represent crystallography of planes (…

Q: See attached picture. Viscosities of five liquids at 25°C are given in the following table. Explain…

A: Viscosity of a liquid is defined as the resistance of a liquid to its flow and shear due to gravity.…

Q: (4) The following plot corresponds schematically to the behavior of the chemical potential for the…

A: The explanation is given below-

Q: Calculate the surface tension of ethanol at 0 and 70 °C. Let the critical temperature of ethanol be…

A: Surface tension of the concerned liquid can be calculated from Eotvos equation.

Q: The viscosity of a multigrade motor oil (such as one rated10W-40) is less temperature dependent than…

A: The resistance to flow property of a fluid is known as its viscosity. SI unit of viscosity is…

Q: Polymer PXX has a glass transition temperature of 49°C. Describe the viscoelastic behaviour of the…

A: Glass transition temperature(Tg) It is the temperature at which a polymer coverts into its soft form…

Q: The viscosity of carbon dioxide gas at 1 atm is 436 µP at 850°C. Calculate the apparent hard sphere…

A:

Q: - Camper between Sorption and Surface tension

A:

Q: What is the density of nitrobenzene at 30 degree centigrade and How can you describe the viscosity…

A:

Q: 2. A sample of dry ice (solid CO2) is cooled to 173 K (-100.0 °C) and is set on a table at room…

A: Phase diagram is curve that indicates the physical state of a substance when temperature and…

Q: At 25 °C, how high will water rise in a glass capillary tube with an inner diameter of 0.25 mm? For…

A: Given that: Diameter, d = 0.25 mm Tension, T = 71.99 mN/m Density, ρ = 1.0 g/cm3 To find the…

Q: which of the following would have the highest viscosity at a temperature and pressure where all are…

A: The viscosity of the any liquid is proportional to the strength of molecular interactions between…

Q: Which is NOT a factor affecting the viscosity of liquids? Group of answer choices Molecular mass…

A: In the given question we have to select the correct choice for not affecting the viscosity of…

Q: Define the following terms: a. salt bridges b. ionic interactions c. van der Waals forces d.…

A: Hello. Since your question has multiple sub-parts, we will solve the first three sub-parts for you.…

Q: The temperature dependence of the vapor pressure is given by the equation: ΔΗp Inp = In A – RT…

A: The relation of p with T is given by the above equation. Write the expression of the given equation.…

Q: 1. The viscosities of five liquids at 25°C are given in the following table. Explain the observed…

A:

Q: B A T On the phase diagram shown above, segment substance are in equilibrium. corresponds to the…

A: The phase-diagram is :

Q: xplain the variation in viscosity with concentration. Does it become more or less viscous? Explain…

A: Given Explain the variation in viscosity with concentration. Does it become more or less viscous?…

Q: Describe the physical origins of linewidths in the absorption and emission spectra of gases. liqu…

A: Spectral line arises from the emission or absorption of light. It is used to identify atoms or…

Q: liquid nitrogen has a density if 875.4 kg/m^3 at its normal boiling point. what volume does a ballon…

A:

Q: What factor(s) influence the viscosity of a polymer solu-tion? What factor(s) influence the…

A: Viscosity is a measure of the resistance of a fluid to flow. It defines a moving fluid's internal…

Q: what is Formality and for which types of solids it is mainly used?

A: Solution stoichiometry is mainly based on the calculation of moles and volumes. These two values are…

Q: The masses of benzene and an unknown liquid droplets falling off from the same stalagmometer at 20 °…

A: A stalagmometer is a device for measuring the surface tension of an unknown liquid using the…

Q: The surface tension of isopropyl alcohol in air has a value of 22.39 units and the surface tension…

A: Substances with strong intermolecular forces will generally have a greater surface tension than…

Q: What determines the type and strength of intermolecular attraction between particles?

A: The differences in the properties of a solid, liquid, or gas determine the strengths of the…

Q: The density of nitrogen at its critical point is 0.3131 gcm-3 . At a very low temperature, 0.3131 g…

A: Critical temperature is the point at and above which the gas cannot be further liquified no matter…

Q: Which of the following is most likely to have the highest viscosity at 25°C?   HOCH2CH2OH C5H12 C7H8…

A: Viscosity is an internal property of a fluid.   HOCH2CH2OH C5H12 C7H8 C5H11OH We have to select the…

Q: HOW DO INTERMOLECULAR FORCES RELATE WITH THE ASSUMPTIONS OF THE KINETIC MOLECULAR THEORY?

A: Kinetic theory:  The behaviour of gases based is explained on the idea that the gas consists of…

Q: Classify the relationship of the the following variables in each item either as “Direct” or…

A: 1. When high pressure is applied on a gas, it gets converted into liquid form. Similarly, if more…

Q: 1. Arrange the following compounds in increasing viscosity at 25°C

A:

Q: 5. To vaporize 1.75 g of acetone, (CH;),CO, at 298K, 767 J of heat is required. What is the enthalpy…

A:

Q: Calculate the height in meters of a column of liquid glycerol (d = 1.26 g/cm3) required to exert the…

A: Pressure will remain same then we can write dHg×g×hHg = dalc×g×halc Where dHg = density of mercury g…

Q: Which of the following forms of viscosity does not vary with concentration?  a. relative b.…

A: The intrinsic viscosity of the polymer solution depends on the type of polymer and the solvent and…

Q: Give mathematical explanation for the effect of temperature on viscosity.

A: The property of the liquids which determines their resistance to flow is called viscosity.…