A wire (mass = 50 g, length = 40 cm) %3D %3D is suspended horizontally by two vertical wires which conduct a current | = 9 A, as shown in the figure. The magnetic field in the region is into the paper and has a magnitude of 60 mT. What is the tension in either wire ( in units of N)? X X X X X Xx X X X X,X 40 cm

A wire (mass = 50 g, length = 40 cm) %3D %3D is suspended horizontally by two vertical wires which conduct a current | = 9 A, as shown in the figure. The magnetic field in the region is into the paper and has a magnitude of 60 mT. What is the tension in either wire ( in units of N)? X X X X X Xx X X X X,X 40 cm

Physics for Scientists and Engineers: Foundations and Connections

1st Edition

ISBN:9781133939146

Author:Katz, Debora M.

Publisher:Katz, Debora M.

Chapter31: Gauss’s Law For Magnetism And Ampère’s Law

Section: Chapter Questions

Problem 31PQ

See similar textbooks

Similar questions

Figure CQ19.7 shows a coaxial cable carrying current I in itsinner conductor and a return current of the same magnitudein the opposite direction in the outer conductor. Themagnetic field strength at r = r0 is B0. Find the ratio B /B0 at(a) r = 2r0 and (b) r = 4r0.
Two long, parallel wiresseparated by a distance 2d carryequal currents in the same direction.An end view of the two wiresis shown in Figure P19.54, wherethe currents are out of the page.(a) What is the direction of themagnetic field at P on the x - axisset up by the two wires? (b) Find anexpression for the magnitude of thefield at P. (c) From your result to part (b), determine the fieldat a point midway between the two wires. Does your resultmeet with your expectation? Explain.
What is the total energy transported per hour along a narrow cylindrical laser beam 1.80 mm in diameter, whose B-field has an rms strength of 1.10×10−101.10×10−10 T ?
an electron accelerated from rest through potential difference V1 1.00 kV enters the gap between two parallel plates having separation d =20.0 mm and potential difference V2 =100 V.The lower plate is at the lower potential. Neglect fringing and assume that the electron’s velocity vector is perpendicular to the electric field vector between the plates. In unit-vector notation, what uniform magnetic field allows the electron to travel in a straight line in the gap?
In Figure P19.2, assume in each case the velocity vector shownis replaced with a wire carrying a current in the direction ofthe velocity vector. For each case, find the direction of themagnetic force acting on the wire.
An ideal toroidal solenoid has an inner radius of 14.5 cm and outer radius of19.0 cm. It carries a current of 0.500 A and has 9500 number of turns. Find themagnetic field strengths at distances 15.0 cm and 20.0 cm from the center of the solenoid.
A sinusoidally oscillating current ?(?)I(t) with an amplitude of 7.55 A7.55 A and a frequency of 775 cycles per second775 cycles per second is carried by a long, straight wire. A rectangular loop of copper wire with dimensions ?=72.2 cmb=72.2 cm by ?=32.5 cmc=32.5 cm is located ?=80.2 cma=80.2 cm from the straight wire, and is coplanar with it. Calculate the average power ?avgPavg dissipated by the loop if its resistance is 24.3 Ω.
A long soleniod of radius 3.41 m is wound with 24.1 turns/rn and carries a current that changes at the rate of 22.9 A/s in the figure below. What is the magnitude of the ernf induced in the square conducting loop surrounding the centre of the selenoid. The induced ernf is = _____________ mv (note: 1 mv = 10-3V)
A proton moving at speed v = 1.00 x 106 m/s enters a region in space where a magnetic fi eld givenby B = (–0.500 T) z exists. The velocity vector of the proton is at an angle θ = 60.0° with respect tothe positive z-axis. a) Analyze the motion of the proton and describe its trajectory (in qualitativeterms only). b) Calculate the radius, r, of the trajectory projected onto a plane perpendicular to themagnetic fi eld (in the xy-plane). c) Calculate the period, T, and frequency, f, of the motion in thatplane. d) Calculate the pitch of the motion (the distance traveled by the proton in the direction ofthe magnetic fi eld in 1 period).
A certain commercial mass spectrometer is used to separate uranium ions of mass 3.92 × 10-25 kg and charge 3.20 × 10-19 C from related species. The ions are accelerated through a potential difference of 107 kV and then pass into a uniform magnetic field, where they are bent in a path of radius 0.961 m. After traveling through 180° and passing through a slit of width 0.766 mm and height 1.48 cm, they are collected in a cup. (a) What is the magnitude of the (perpendicular) magnetic field in the separator? If the machine is used to separate out 0.795 mg of material per hour, calculate (b) the current of the desired ions in the machine and (c) the thermal energy produced in the cup in 1.07 h.
) In the figure below, the current in the long, straight wire is I1 = 6.00 A and the wire lies in the planeof the rectangular loop, which carries the current I2 = 10.0 A. The dimensions are c = 0.100 m, a =0.150 m, and l = 0.500 m. Find the magnitude and direction of the net force exerted on the loop by themagnetic field created by the wire.a) find the force on the left hand side of the loop firstb) find the force on the right hand side of the loop secondc) find the net force (be careful about the directions)
A 0.5m long straight conductor wire placed on the z-axis carries a current of 10A. If B=-r0,1T in the region where the conductor is located, find the amplitude of the force on the conductor.