a. Determine the temperature of the product leaving the heater when the initial temperature is 45 ° C. = Answer ° C. b. Determine the total solids fraction of the product after heating. = Answer %

Q: 1) For a concentric counter-flow heat exchanger, hot oil is coming in the tube of the shell/tube…

A: The oil inlet and outlet temperatures are given as, The water inlet and outlet temperatures are…

Q: Milk is flowing through a heat exchanger at a rate of 2000 kg/h. The heat exchanger supplies 111,600…

A: Given Data m= 2000 kg/h Q= 111,600 kJ/h. To=95°C C=3.9 kJ/kgK

Q: In an heat exchanger of parallel flow type, water enters at 60°C and leaves at 80°C while oil of…

A: Given Data Tw1=60°C    Tw2=80°C   Sg=0.8 To1=250°C T02=100°C   CpO=2.5 Kj/KgK T∞=300K   mO=1Kg

Q: -1 Oil with speed 7260 kg / h and heat capacity c (oil) = 2.07 kJ kgrK cooled from 394.3 K to 338.9…

A:

Q: Water (Cp = 4200 J/kg. °C) is used cool %3D an unknown fluid (with a given Cp = 3810 J/kg-°C) using…

A: The overall heat transfer coefficient is a measurement of a series of conductive and convective…

Q: A fluid is flowing through a heat exchanger (HEX) at a rate of 2500 kg/h. The heat exchanger…

A: Mass flow rate of fluid, m = 2500 kg/h Heat supplied in heat exchanger, Q = 115600 kJ/h Inlet…

Q: In a two-pipe heat exchanger, 2950 kg/h flowing through the ring section The water in the flow rate…

A:

Q: The diameter of the tube is 25 mm. The specific heat of water is 4.18 kJ/kg.°C. The overall heat…

A: There is a coma in mass flow rate data instead of point. I am considering it as 1.8 kg/s. If it is…

Q: QUESTION 8 A concentric-tube, counter-flow heat exchanger, as shown below, is used to cool mercury…

A:

Q: A double-width centrifugal blower supplies flow to a system whose resistance is dominated by the…

A: given; pressure rise (P2-P1)=1KPasectional area(A)=1m2volume flow rate(Q)=?

Q: An engineer designed a double pipe heat exchanger where the hot fluid (c,=2400 J/kg.K) enters at a…

A:

Q: Water at 30 °C flows on the inside of a steel tube with 25 mm inner diameter and 0.8mm wall…

A:

Q: - In a heat exchanger, steam of 0.08 bar and a specific steam content of 95% is condensed. 381.6…

A: a.

Q: counter-flow heat exchanger, water entering at 1 kg/s is heated from 23°C to 69°C as it flows thru…

A:

Q: To cool the lubricating oil, a concentric counter-flow heat exchanger  is utilized, with the water…

A:

Q: The radiator in an automobile is a cross-flow heat exchanger (UAs = 10 kW/K) that uses air (cp =…

A: Given data To determine exit temperature of cold fluid..??

Q: Hot water at 90°C flows on the inside of a 2.5-cm-ID steel tube with 0.8-mm wall thickness at a…

A:

Q: As a process engineer, you are given the task to design a heat exchanger to cool a tank for mixing…

A: given data;for stream 1;⇒temperature(T1)=300K⇒mass flow rate(m1)=2kg/s⇒for stream…

Q: Used to cool the cockpit of a refrigerated aircraft (33 tons of simple air refrigeration). The…

A:

Q: A shell-and-tube heat exchanger with 2- shell passes and 12-tube passes is used to heat water (Cp =…

A:

Q: Water flows through a shower head steadily at a rate of 8 kg/min. The water is heated in an electric…

A: Write the given information.

Q: What are the classifications of the heat exchanger, what are it applications, and what are the…

A: Complete information about heat excahanger given below: Heat exchanger defined as a device which…

Q: To cool the lubricating oil, a concentric counter-flow heat exchanger  is utilized, with the water…

A:

Q: Problem 1.6 A heat exchanger is being designed as a component of a geothermal power system in which…

A:

Q: Oil Inner tube d, = 40 mm d; = 20 mm Water Oil Figure Q1

A:

Q: Water at 90C is being pumped from a large storage tank at 1 atm abs at a rate of 0.189 m3/min by a…

A:

Q: A shell and tube heat exchanger is designed as a counter flow type. Water (cp = 4182 J/kg.o C)enters…

A:

Q: A waste heat exchanger is used to absorb the energy from the complete combustion of hydrogen sulfide…

A:

Q: Automobile air-conditioner gives up 18 kW at 65 km/h if the outside temperature is 35°C. The…

A: let C1 and C2 are constant V= velocity of air m˙a=C1VU=C2V-0.7U=200=C2650.7C2=10.76

Q: 3- What are the classifications of the heat exchanger, what are it applications, and what are the…

A:

Q: Write about of the following related to shell and tube heat exchanger: (i) Tube sheet and tube pitch…

A: Given Shell and tube exchanger To find Relation Tube sheet and tube pitch Baffle and baffle spacing…

Q: In a double-pipe, counter-flow heat exchanger, water entering at 1 kg/s is heated from 23°C to 69°C…

A: For solution refer  below images.

Q: Milk is flowing through a heat exchanger at a rate of 2000 kg/h. The heat exchanger supplies 111,600…

A: Given Data  Mass flow rate= 2000 kg/h Q=111600 kJ/h To=95°C C=3.9 kJ/kg.K

Q: Single-shell, two-tube pass heat exchanger with surface area 0.4 m2 and overall heat transfer…

A: TS=110°CT1=17°CT2 =?m˙=0.35kg/secCp=4179j/kg-kU= 1800w/m2-k∆T= log  mean temp difference

Q: As a thermo-fluid engineer working for an energy startup located at Greentown Labs, you are tasked…

A: Given      Inlet temperature of hot gas, Ti = 52oC Inlet temperature of cold water, T1 = 4oC…

Q: QUESTION 5 The mass flowrate, specific heat, and inlet temperature of the tube-side stream in a…

A:

Q: It is proposed to build a 1000 MWelectric power plant with steam as the working fluid. The…

A:

Q: Separate streams of steam and air flow through the turbine and heat exchanger arrangement shown in…

A: Mass flow rate of air = 1000 kg/min = 16.67 kg/s Work of turbine 1 = 12000 kW Note ; As per…

Q: A counter flow single body single pass heat exchanger is used to cool the lubricating oil of an…

A:

Q: In a shell and tube heat exchanger _________________________ a.The relationship between temperature…

A: In a shell and tube heat exchanger ,it is feasible to turn off the ports and instead assume a…

Q: 34. Fully developed air flows inside the ¼ in tubes of an air-cooled heat exchang- er at a rate of…

A:

Q: A local brand of water heater has offered a counterflow concentric tube heat exchanger, consisting…

A:

Heat Exchangers

Heat exchangers are the types of equipment that are primarily employed to transfer the thermal energy from one fluid to another, provided that one of the fluids should be at a higher thermal energy content than the other fluid.

Heat Exchanger

The heat exchanger is a combination of two words ''Heat'' and ''Exchanger''. It is a mechanical device that is used to exchange heat energy between two fluids.