äbäi 35 The frame A B C shown in the Fig. below, the frame is attached with cable at D and E. Determine the following: 1- Draw F.B.D for the frame 2- Find the reaction at surface A and hinged C 3-Find the tension at D and E 4- Draw F.B.D for AB and BC B 1.5m 1.5m Cable 3.5m 2m | 60 30 2000 N C

äbäi 35 The frame A B C shown in the Fig. below, the frame is attached with cable at D and E. Determine the following: 1- Draw F.B.D for the frame 2- Find the reaction at surface A and hinged C 3-Find the tension at D and E 4- Draw F.B.D for AB and BC B 1.5m 1.5m Cable 3.5m 2m | 60 30 2000 N C

Principles of Heat Transfer (Activate Learning with these NEW titles from Engineering!)

8th Edition

ISBN:9781305387102

Author:Kreith, Frank; Manglik, Raj M.

Publisher:Kreith, Frank; Manglik, Raj M.

Chapter1: Basic Modes Of Heat Transfer

Section: Chapter Questions

Problem 1.23P: Using the information in Problem 1.22, estimate the ambient air temperature that could cause...

See similar textbooks

Similar questions

5.2 Evaluate the Prandtl number from the following data: , .
Using the information in Problem 1.22, estimate the ambient air temperature that could cause frostbite on a calm day on the ski slopes. 1.22 In order to prevent frostbite to skiers on chair lifts, the weather report at most ski areas gives both an air temperature and the wind-chill temperature. The air temperature is measured with a thermometer that is not affected by the wind. However, the rate of heat loss from the skier increases with wind velocity, and the wind-chill temperature is the temperature that would result in the same rate of heat loss in still air as occurs at the measured air temperature with the existing wind. Suppose that the inner temperature of a 3-mm-thick layer of skin with a thermal conductivity of 0.35W/mKis35C and the air temperature is 20C. Under calm ambient conditions the heat transfer coefficient at the outer skin surface is about 20W/m2K (see Table 1.4), but in a 40-mph wind it increases to 75W/m2K. If frostbite occurs when the skin temperature drops to about 10C, do you advise the skier to wear a face mask? What is the skin temperature drop due to the wind?
(a) A very important component of a system has a mean time between failures of 100 hr and a mean time to repair of 10 hr. Determine the inherent availability of the system. (b) If the equipment in Q7 (c i) above is required to meet an inherent availability requirement of 0.985 and a mean time between failures of 100 hr. Calculate the permissible mean time to repair and if the system as a mean of the time intervals between corrective maintenance actions of 900 hrs and the sum of the mean corrective maintenance time intervals including supply downtime and administrative down time of 10 hrs Determine the operational availability of the system
MECHANICAL ENGINEERING UPVOTE WILL BE GIVEN. PLEASE WRITE THE COMPLETE SOLUTIONS LEGIBLY. SHOW THE STEP-BY-STEP PROCESS WITH SHORT COMMENT/EXPLANATION. ANSWER IN 4 DECIMAL PLACES. Two gaseous streams containing the same fluid enters a mixing chamber and leaves as a single stream. For the first gas the entrance conditions are A1=500 cm², v1=230 m/s, p1=1.60 kg/m³. For the second gas the entrance conditions are A2= 300 cm³, m2=8.84 kg/s, v2=0.502 m³/kg. The exit stream conditions is v3=130 m/s and v3=0.437 m3/kg. Determine the following: (a) the total mass flow leaving the chamber (kg/sec) (b) the velocity of the gas at 2. (m/sec)
The marketing research department of a large manufacturing company has determined that the demand equations for two major items it produces are given by p = 2,000 - 5x + 8y and q = 4,000+ 9x - 7y where p is the price of item A. is the price of item B , x is the monthly demand for item A , and y is the monthly demand for item B. Find the total monthly revenue from items A and B when x = 15 and y = 5 .
The data provided by a company for the year 2020 – 2021 to carry out Break Even Analysis and provide them the results, complete analysis and suggestions. The data is as follows:Building rent 20000 R.O Every month instalments 30000 R.OThe estimated sales are 750000.0 R.OMaterial Cost / unit 15.0 R.OProduction cost / unit 8.0 R. OTransportation & other Costs / unit (Approx) 4.00 R. O Maintenance cost / unit 1.5 R. O Salary of the employees / unit 0.8 R.OMarketing and advertisement cost / unit 0.7 R. OEach unit is sold at price 35.0 R. O Construct the B.E.P chart on a graph sheet and indicate, B.E.P, M.o.S and also indicate the new B.E.P & M.o.S after the improvement measures has been taken (With different colours). Show the calculations for the following parameters separately before and after the measures taken.1. Determine the B.E.P2. Determine the profit 3. Margin of safety.Also write your decisions taken to improve the profits of the company and to reduce the B.E.P.
Five engineers measure the thickness of a slab using a meter stick and a vernier caliper. One engineer got a thickness of 4.3 cm ± 0.1 cm using a meter stick, the other four engineers measured a thickness of (a) 4.32 cm ± 0.01 cm, (b) 4.31 cm ± 0.01 cm, (c) 4.24 cm ± 0.01 cm, and (d) 4.43 cm ± 0.01 cm respectively using the caliper. Which of these four measurements made by the four engineers agree with the measurement obtained by the engineer that used a meter stick? Only a (b) and (c) (c) and (d) (a), (b), and (c) none of these
A parent exerts a torque on a merry-go-round at a park. The torque has a magnitude given by τ = 2.5θ2 + 11.0θ − 13.5, where the torque has units of newton meters when θ is in units of radians. (a) How much work is performed by the torque as the merry-go-round rotates through 1.50 revolutions, beginning at θi = 0? (answer in joules)(b) If it takes the merry-go-round 8.40 s to go through the 1.50 revolutions, what is the power transferred by the parent to the ride? (Enter the average power over 8.40 s.) (answer in Watts)
A drug store sells 30 bottles of antibiotics per week.Each time it orders antibiotics, there is a fixed ordering costof $10 and a cost of $10/bottle. Assume that the annualholding cost is 20% of the cost of a bottle of antibiotics, andsuppose antibiotics spoil and cannot be sold if they spendmore than one week in inventory. When the drug store placesan order, how many bottles of antibiotics should be ordered?
Direction: Show your complete solution and box you final answer. Do not round off in between the solutions but round off your final answer to the nearest ten thousandths place(4 decimal places). 1. A fluid enters a machine at 170 m/s, 800 kPa, and with a specific volume of 0.3 m^3/kg. The radiation heat loss is 25 kJ/kg. The internal energy decreases by 495 kJ/kg. If the fluid leaves at 330 m/s, 138 kPa, and 0.95 m^3/kg, determine the work done by the fulid in kJ/kg.
1. A certain batch of parts is routed through six machines in a batch production plant. The setup and operation times for each machine are given in the table below. Batch size is 200 and the average nonoperation time per machine is15 hr. Determine (a) manufacturing lead time and (b) hourly production rate for operation 4.Machine 1 2 3 4 5 6Setup time (hr) 5 3 6 4 5 3Operation time (min) 3.0 3.3 8.2 3.9 4.5 2.3 a. 6(4.3+200(3.9/60)+15) = 193.8 hours 24.2 days if 8 hour shiftb. 4(60)+200(3.9)/200 =5.1 hourly production for operation 4 2. Suppose the part in the previous problem is made in very large quantities on a production line in which an automated work handling system is used to transfer parts between machines. Transfer time between stations is 30 sec. total time required to setup the entire line is 102 hr. Assume that the operation times at the individual machines remain the same as in the previous problem, Determine (a) manufacturing lead time for a part coming off the line,…
A runner wants to run 10.0 km. She knows that her running pace is 7.5 miles per hour. How many minutes must she run?