ActiveDosageFormRaw MaterialsActual YieldFormulationPackagingIngredient2 kgs. Salicylic acid and2.5 kgs. aceticanhydride80 mg pertablet20 tablets perblister packAspirin1180 g aspirinTabletSYNTHESIS AND PACKAGING% composition by mass of eachcompoundMass to Mass StoichiometryCalculationNumber of dosage form andpackagingthat can be produced fromstoichiometric calculation

3 subdivision questions are based on mole concept. Each of them are to be answered by the respective…

Active Ingredient Raw Materials 2 kgs. Salicylic acid and 2.5 kgs. acetic anhydride Aspirin SYNTHESIS AND PACKAGING % composition by mass of each compound Mass to Mass Stoichiometry Calculation Number of dosage form and packaging that can be produced from stoichiometric calculation Actual Yield 1180 g aspirin Formulation 80 mg per tablet Dosage Form Tablet Packaging 20 tablets per blister pack

Active Ingredient Raw Materials 2 kgs. Salicylic acid and 2.5 kgs. acetic anhydride Aspirin SYNTHESIS AND PACKAGING % composition by mass of each compound Mass to Mass Stoichiometry Calculation Number of dosage form and packaging that can be produced from stoichiometric calculation Actual Yield 1180 g aspirin Formulation 80 mg per tablet Dosage Form Tablet Packaging 20 tablets per blister pack

Chemistry: The Molecular Science

5th Edition

ISBN:9781285199047

Author:John W. Moore, Conrad L. Stanitski

Publisher:John W. Moore, Conrad L. Stanitski

Chapter9: Liquids, Solids, And Materials

Section: Chapter Questions

Problem 92QRT

See similar textbooks

Similar questions

To prepare a very dilute solution of K2Cr2O7 (294.18 g/mol), 0.661 g of K2Cr2O7 was transferred to a 250.0-mL volumetric flask and adding water to the mark. A sample of this solution of volume 1.000 mL was then transferred to a 500.0-mL volumetric flask and diluted to the mark with water. Subsequently, 10.0 mL of the diluted solution was transferred to a 250.0-mL flask and diluted to the mark with water. What is the final concentration of K2Cr2O7 in this last solution?
Mass of Na2CO3=5g Mass of CaCl2=4.98g Mass of filter paper=1.11g Na2CO3 and CaCl2 combined, filtered, and dried overnight. The mass of the solid produced = 2.86g Calculate the theoretical yield of solid expected and the percent yield obtained.
In the standardization of HCl using pure anhydrous sodium carbonate as the primarystandard for methyl orange as an indicator, 1.0 mL HCl was found to be equivalent to 0.05gof sodium carbonate (MW =106). The normality of HCl is:
KAl3Si3O10(OH)2(s) + H+(aq) + H2O(l) -->Al2Si2O5(OH)4(s) + K+(aq) Balance the equation without adding any components or phases.
The dictionary defines homogeneousas “uniform in compo-sition throughout.” River water is a mixture of dissolved com-pounds, such as calcium bicarbonate, and suspended soil particles. Is river water homogeneous? Explain
Magnesium +Acetic Acid --> C2HG5+ O2 ---> Iron (III) carbonate -->
A solution was prepared by dissolving 25g of fructose in sufficient quantity of water to make 100 grams of solution. What is the %W/W of the solution? What is the mole of solute? What is the mole of solution? What is the mole percent of solute? What is the molarity of the solution?
An aqueous solution of sucrose C12H22O11 is prepared by dissolving 6.9290 g in sufficient deionized water to form a 100.00 mL solution. Calculate the molarity of the solution. Give value and unit.
A 244.5-g sample of ground water is analyzed for calcium. The Ca2+ in the sample is first precipitated and filtered-off as NH4CaPO4.7H20. This precipitate is dried and heated, releasing water and ammonia to yield anhydrous calcium pyrophosphate (CaP2O7). The mass of CaP2O, obtained is 0.0419 g. Give the calcium content of the ground water in parts per million (to three significant figures).
You have been tasked with determining the wastewater solids generated by a community. To determine solids, you collect two effluent samples of 100 mL each. The first sample was placed, unfiltered, in a crucible and dried at 105 ̊C overnight. The weight of the dried sample and crucible was 5.6112 g, while the weight of the crucible was 5.6000 g. The second sample was filtered. The filter and drying dish were dried overnight at 105 ̊C after which they weighed 2.1085 g. The filter and drying dish were then placed in a muffle furnace at 550 ̊C for 30 mins, after which they weighed 2.103 g. The drying dish weighs 1.6000 g and the filter weighs 0.5 g. a) Determine the concentration of TS, TSS, VSS, FSS and TDS in mg/L: b) Does TSS concentration meet the federal effluent regulations? If not, what removal techniques would you recommend and what minimum percent must be removed prior to discharge?
A solution was made using 147 g H2SO4 diluted to (QS to) 2 L with distilled water. What is the normality for this solution? MW of H2SO4 = 98 g/mole
A plant manufacturing nails and screws uses a large pool (volume = 10,000 L) to collect and treat its residual wastewater before discharging it in a nearby stream. The manufacturing process makes use of a strong acid (HCl) and a weaker one (phosphoric acid, H3PO4; pKa1 = 2.148, pKa2 = 7.20, pKa3 = 12.15), before discharging them in the pool for treatment (neutralization). Once the pool is filled to its maximum capacity, a technician measures the chlorine and phosphorus concentrations in the wastewater to be 0.5 M and 1.0 M, respectively. Assume (i) that chlorine and phosphorus come only from HCl and phosphoric acid, respectively, and (ii) that no H+ was consumed (or neutralized) in the manufacturing process. (a) Knowing that the technician has to bring the pH of the waste water back to a minimum of 7.2 before discharging it in the stream, what is the minimum amount (in kg) of NaOH(s) (40 g/mol) that he has to add to the pool before discharging the waste water in the stream? (b) What…