Answered: After a disturbance, Increase in…

After a disturbance, Increase in angular separation accompanied by a decrease in power transfer will result in the power system to become unstable True False

Power System Analysis and Design (MindTap Course List)

6th Edition

ISBN:9781305632134

Author:J. Duncan Glover, Thomas Overbye, Mulukutla S. Sarma

Publisher:J. Duncan Glover, Thomas Overbye, Mulukutla S. Sarma

Chapter12: Power System Controls

Section: Chapter Questions

Problem 12.8P

See similar textbooks

Related questions

Q: If a 10 poles hydro generator is installed in Jordan, then the speed of its prime mover in…

A: It is given that, Number of poles(p)= 10 The country given is Jordan,which is located in Asia. Thus…

Q: The synchronous generator of thermal power station will have a large number of poles O True False

A: In thermal power stations, the rotor which is used is a cylindrical rotor. In cylindrical rotor the…

Q: The sum of admittances connected between two buses is called as _____________________. a. Mutual…

A: The mutual admittance between two buses is defined as negative of sum of all admittances connected…

Q: Hydroelectric power plant is generally located far away from load center. Select one: True O False

A: Hydro electric power plant is for away from load centers .because power plants fuel is water .for…

Q: In Radial Distribution, the voltage across the Loads away from the Feeding Point goes on increasing.…

A: The given question is as follows-:

Q: By how much the velocity of wind turbine will be multiplied, if its wind power is tripled?

Q: A synchronous generator in Y (star) configuration is directly connected to an infinite bus. The…

Q: For the system shown below calculate the steady state error for (i) unit step input; (ii) unit ramp…

A: Since you have asked multiple questions in a single request, we will be answering only the 1st…

Q: = bus admittance ma

Q: a) Primary transmission Secondary transmission b) c) Primary distribution d) Secondary distribution

A: Primary transmission : In primary transmission voltage is transmitted at 132 KV to the transformer…

Q: Determine the following a) time constant, and b) settling time of a first order system with a rise…

Q: External effects causing short circuit include insulation failure due to lightning surges,…

A: Actually, short circuit is a uncertain condition in a power system. When the phase and neutral wires…

Q: If a car moves (14 km) North, (20 km) East, and (14 km) South, what is its displacement? O 34 km,…

A: Given data Car moves 14 km North and 20 km east,14km south

Q: 2. Which of the following irradiance parameter is the most important when calculating the PV system…

A: The detailed answer is solved below according to the given parameters and instructions in the…

Q: The emf generated by a dc generator depends upon the number of conductors only. Select one: O True O…

Q: The per unit impedance of a synchronous machine is 0.242. If base voltage is increased by 1.1 times,…

A: Given: Per unit impedance of a synchronous machine, Zpuold=0.242 pu Base voltage is increased by 1.1…

Q: 6. If a power system has 10,000 kVA capacity, operating at 0.7 lagging power factor and cost of…

A: consider the given question 6.

Q: When a generator is connected to infinite bus-bars, its frequency and terminal voltage are fixed…

A: True

Q: YouTube Gmail M Co Harmonics generated due to the presence of switching power electronic devices are…

A: Harmonics generated due to the presence of switching power electronic devices

Q: Calculate the blade length of a wind turbine rotor which produces a maximum power of 6 MW at a wind…

A: The solution to the given numerical on a wind turbine is given below.

Q: A hydro generator on the Jordan Valley has a rating of 1 MW, 1000 rpm. Then, the number of rotor's…

A: Given: A hydro generator in Jordon valley has a rating of 1 MW , 1000 RPM . To find the number of…

Q: The effect of temperature rise in an overhead transmission line is: O a. Decreases the SAG and…

A: Choose the correct option The effect of temperature rise in an overhead transmission line?

Q: The emf generated by a dc generator depends upor the number of conductors only. Select one: True…

A: In this question we will write about emf generated by dc generator...

Q: If the power system has 'n' number of generators, then the size of the B- coefficient matrix is…

A: As per the guidelines of Bartleby we supposed to answer first question only for remaining questions…

Q: The power factor of synchronous generator (connected to infinite bus) can be controlled by the O a.…

A: As per our company guidelines we are supposed to answer only first question kindly repost other…

Q: Wind turbines which are erected in the large body of water are called O a. Offshore wind turbines O…

A: find the explanation below

Q: Calculate the availability if a generator unit whose failure rate is given as 0.0011failures per…

A: In this question we need to find a availability of a genrator for the given condition.

Q: A 230V DC generator voltage is increased above the rated voltage when the field current increases…

A: In this question ,we will write about effect of field current on generator voltage ...

Q: Dwer system could providė or of 0.866, lagging, compute the

A: Since you have asked a multiple question we will solve the first question for you, If you want any…

Q: For the system shown find 5, wa, percent overshoot, peak time, rise time, and settling time. R(s)…

Q: A11 e generators are classified according to the methods of their field excitation. (TRUE/FALSE)

Q: The inductance of the transmission line in mH Sending end power factor Percentage voltage regulation…

Q: Calculate the efficiency of the transform

A: In this question, Calculate the efficiency of the transform. Efficiency = Po/Pi × 100

Q: A power station is to supply four (4) regions of loads whose peak values are 10 MW, 7.5 MW, 8 MW,…

Q: A lightning surge with a peak value of 3600kV strikes a transmission line at point A. Find the…

A: From the transient wave analysis

Q: In a power plant, the turbine is connected to the synchronous machine for power generation. Select…

A: In the power plant, Which location of the turbine connect to?

Q: Since the construction of DC generators and Alternators are similar, you can convert a DC generator…

Q: The average input to a manufacturing plant is 3.000 KVA at a power factor of 0.72 lagging. A…

Q: parallel plate transmission line.

A: Parallel Plate Transmission Line A Parallel Plate Transmission Line consist of two conducting…

Q: Calculate the blade length of a wind turbine rotor which produces a maximum power of 8 MW at a wind…

Q: Darrieus turbine does not requires guy wires to support. Select one: True O False

A: According to the question we have to discuss about Darrieus Turbine.

Q: Q.5) For the following system shown below, determine the characteristic equation, the rise time,…

Q: A critical communications relay has a constant failure rate of 0.1 per day. Once it has failed, the…

A: 1=0.1 per day;⇒1m=2.5⇒m=0.4 per day

Q: Remaining Time: 28 minutes, 24 seconds. A Questiqa Completion Status: 10 L> A Moving to another…

Q: A 50 Hz synchronous generator is supplying 60% of its maximum power to an infinite bus through a…

A: Power deliverd =0.8 Pmax 80% of Pmax=Pmax×80100=0.8PmaxPower of a synchronous generator…

Q: Two buses are interconnected by a transmission line of impedance (0.03 + j0.012) pu. The voltage on…

A: we need to determine the voltage on the second bus, real and reactive power on the first bus.

Q: TUTORIAL PROBLEMS 1. A generating station has a connected load of 40 MW and a maxímum demand of 20…

Q: HAWT type wind turbine has the following data, height of tower =100 m, diameter of rotor = 80 m,…

A: According to question:

Q: QUESTION 55 "Since most loads are capacitive in nature (e.g. motors), improvement of power factor is…

A: In this question choose the correct option Check the given Statment is true or false?

Concept explainers

Nodal Analysis

In the analysis of any electric circuit, nodal analysis is the method of determining the potential difference or voltage between different nodes in an electric circuit. A node is a point where two or more branches connect each other. In the nodal analysis, the voltages are determined in the terms of branch currents. The nodal analysis is also known as the node voltage method or branch current method. The nodal analysis method is one of the several applications of Kirchhoff's Current Law (KCL).

Question

After a disturbance, Increase in angular separation accompanied by a decrease in power transfer will
result in the power system to become unstable
True
False

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step 3

VIEW

Step by step

Solved in 3 steps with 1 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, electrical-engineering and related others by exploring similar questions and additional content below.

Similar questions

Given the complex numbers A1=630 and A2=4+j5, (a) convert A1 to rectangular form: (b) convert A2 to polar and exponential form: (c) calculate A3=(A1+A2), giving your answer in polar form: (d) calculate A4=A1A2, giving your answer in rectangular form: (e) calculate A5=A1/(A2*) giving your answer in exponential form.
A source supplies power to the following three loads connected in parallel: (1) a lighting load drawing 10kW. (2) an induction motor drawing 10kVA at 0.90 power factor lagging, and (3) a synchronous motor operating at 10hp,85 effIciency and 0.95 power factor leading (1hp=0.746kW). Determine the real, reactive, and apparent power delivered by the source. Also, draw the source power triangle.
Electrical load that draws current whose impedance varies throughout the cycle of the input ac voltage waveform is known as nonlinear load. True False
A 70-Vac source has the following waveform.Determine:a. the instantaneous voltage when t = 120 msb. the angle (1st occurrence) after t = 0 when the voltage is +80 Vc. the time (2nd occurrence) after t = 0 when the voltage is –10 V
AVERAGE POWER( NEED NEAT HANDWRITTEN SOLUTION ONLY OTHERWISE DOWNVOTE).
Rab = 11 for the indicated circle, if (Q5 *: R is the value of * 2012 892 512 a Rab 1212 2012 ww 112 212 b
A 12V 50 Hz signal has what instantaneous voltage at 15ms? Enter only numerical portion of your answer.
Circuits 1 HW 2 Q9
Write a Matlab code to sketch using plot function, y(t)=3 sin(t) for 3 periods
7. What is the angular velocity for a 75 - cycle circuit if it takes 23 ms to complete a cycle? a. 10.8385 rad/s b. 235.6194 rad/s c. 471.2389 rad/s d. 5.3192 rad/s
a load of 15 mva with power factor 0.86 lagging is given. Calculate the reactive power delivered by shunt capacitors to increase power factor to 0.9 lagging
A 70-Vac source has the following waveform. Determine:a. equation of the waveform (in time domain)b. the instantaneous voltage when t = 120 msc. the angle (1st occurrence) after t = 0 when the voltage is +80 Vd. the time (2nd occurrence) after t = 0 when the voltage is –10 V