Air is being drawn over the cold surface of the cooling coil of an air conditioning unit. If 10 m/min enters the air conditioner, calculate the mass flow rate of the condensed moisture, given that the air enters at 20 °C and 70% relative humid- ity and exits at 12°C dry bulb temperature and 90% relative humidity. Calcu- late the refrigeration capacity of the coil in W and Btu/h. Solution Step 1 Draw the process diagram: m2 ma W; W. H; H. mw Hw

Air is being drawn over the cold surface of the cooling coil of an air conditioning unit. If 10 m/min enters the air conditioner, calculate the mass flow rate of the condensed moisture, given that the air enters at 20 °C and 70% relative humid- ity and exits at 12°C dry bulb temperature and 90% relative humidity. Calcu- late the refrigeration capacity of the coil in W and Btu/h. Solution Step 1 Draw the process diagram: m2 ma W; W. H; H. mw Hw

Elements Of Electromagnetics

7th Edition

ISBN:9780190698614

Author:Sadiku, Matthew N. O.

Publisher:Sadiku, Matthew N. O.

ChapterMA: Math Assessment

Section: Chapter Questions

Problem 1.1MA

See similar textbooks

Similar questions

A winter air-conditioning system adds for humidification 0.0025 kg/s of saturated steam at 100 kPa pressure to an airflow of 0.36 kg/s. The air is initially at a temperature of 15°C with a relative humidity of 20 percent. The barometric pressure is 90 kPaa. What is the dry temperature of the air leaving the humidifier °C?
What is the temperature entering the cooling sectionwhen 25 kW of heat are removed and the air exits at 15 deg C, a relative humidity of 30% and a volumetric flowrate of 0.7 m^3/s?
In sensible heating or cooling process, it is the dry bulb temperature of air being varied either increase or decrease during the process. What psychrometric property in humidification process? In dehumidification process?
Air enters a humidifier at 34.25°C and 30% RH. If the air leaves the humidifier at 70% RH. Determine: The exit dry-bulb temperature of the air in °C.The saturation effectiveness in %.
explain the principle of operation of a cooling tower and neatly sketch section, analyse a crossflow cooling tower.
A dryer is to deliver 1,000 kg/h of palay with final moisture content of 10%. The initial moisture content in the feed is 15% at atmospheric condition with 30 oC dry bulb and 20 oC wet bulb. The dryer is maintained at 45oC while the relative humidity of the hot humid air from the dryer is 80%. If the steam pressure supplied to the heater is 2 MPa, determine the following: a.) Palay supplied to the dryer in kg/h. b.) Temperature of the hot humid air from the dryer in oC. c.) Air supplied to dryer in cu m/h. d.) Heat supplied by the heater in k W. e.) Steam supplied to heater in kg/h.
Using a psychrometric diagram, describe the heating and humidification process from the following data. Initially the air was at a dry bulb temperature (DBT) of 40 ° C and RH60%. The air is heated to DBT 90 ° C. The heated air is then flowed through a humidifier to increase the RH to 25%. For this process, calculate, a. Change in absolute humidity of air from initial to final conditions = kg water / kg air). b. The change in air enthalpy from initial to final conditions. = (kj / kg air)
The moisture removed from a material is 200 lb/hr and change of humidity ratio of air in the dryer is 105 grains/lbmd.a. Determine the fan capacity in cfm if specific volume of air entering is 38 ft3 /lb.
Using a psychrometric diagram, describe the heating and humidification process from the following data. Initially the air was at a dry bulb temperature (DBT) of 30 ° C and RH60%. The air is heated to DBT 80 ° C. The heated air is then flowed through a humidifier to increase the RH to 25%. For this process, calculate,a. Change in absolute humidity of air from initial to final conditions = (kg water / kg air).b. The change in air enthalpy from initial to final conditions. = (kJ / kg air)
A countercurrent tunnel dryer is being used to dry apple slices from an initial moisture content (wet basis) of 65% to 5%. The heated air enters at 95°C with 1% RH and leaves at 52°C. If the product temperature is 20°C throughout the dryer and the specific heat of product solids is 2.2 kJ/(kg °C), determine the quantity of heated air required for drying the product at a rate of 160 kg/h. Determine the relative humidity of outlet air.
the question below is already answered in the photos that I provided I only want to ask how did it find the answersSaturated steam at a pressure of 25 psia is sprayed into a stream of moist air. The initial condition of the air is 55 dry-bulb temperature and 35 F de-point temperature. The mass rate of air flow is 2000 lb per min. Barometric pressure is 14.696 psia. Determine how much steam must be added in lb per min to produce a saturated air condition, b) the resulting temperature of the saturated air.my question here is:regarding of the solution pls elaborate how did it get w1 and h1 is it given in the psychrometric chart or it has a specific solution to follow
Briefly discuss the effect of the property below in relation to SENSIBLE HEATNG process. a) What happen to its RELATIVE HUMIDITY during the process? b) What happen to its SPECIFIC HUMIDITY during the process?