Allowable recovery from limiting salt calculations Determine the limiting sait and allowable recovery for a brackish water RO system containing the following solutes: calcium 74 mg/L. barium 0.008 mg/L. and sulfate 68 mg/L. Assume 100 percent rejection of all solutes and & polarization factor of 1.15 and ignore activity coeficients (i.e., activity = concentration).

Allowable recovery from limiting salt calculations Determine the limiting sait and allowable recovery for a brackish water RO system containing the following solutes: calcium 74 mg/L. barium 0.008 mg/L. and sulfate 68 mg/L. Assume 100 percent rejection of all solutes and & polarization factor of 1.15 and ignore activity coeficients (i.e., activity = concentration).

Fundamentals Of Analytical Chemistry

9th Edition

ISBN:9781285640686

Author:Skoog

Publisher:Skoog

Chapter7: Statistical Data Treatment And Evaluation

Section: Chapter Questions

Problem 7.16QAP

See similar textbooks

Similar questions

Pure toluene (C7H8) has a normal boiling point of 111.0°C, and the Boiling Point Elevation Constant is 3.40°C. When 25g of compound A (MM=100) is dissolved in 500g of Toluene, the boiling point of the solution is 113.2°C. Therefore, the activity coefficient of the compound (γA) in the solution is approximately: a) 1.3 b) insufficient data c) 0.65 d) 0.8 (The answer according to the professor is 1.3, but I have tried and can't get that answer, thanks for the help)
Use the follow data below and answer the following questions: Component Concentration (mg/L) CO2 8 Ca2+ 45 Mg2+ 13 Sr2+ 12 Alkalinity 270 Determine the quantity (mass flow) of CaO and Soda Ash using practical solubility limit required to treat hard water taking volumetric flow as 145000 L/d and pH of 7.5 and purity of both reagents as 97%.
Given the property on the left as the criterion, which of the following order of comparison is TRUE? Select one: a. Increasing electrical conductivity at 25 °C: Si < SiO2 < SiCl4 b. Increasing standard boiling point: 0.10 molal solution of sucrose in CH3CH2OH < pure CH3CH2OH < 0.10 molal aqueous solution of sucrose c. Increasing standard melting point: I2 < Br2 < Cl2 d. Increasing melting point: Na < NaCl < Na2O
How many moles of solute particles are present in 1.64 mL of 0.458 M K2SO4? (the answer is 2.25E-3 but i would appreciate some insight on what steps to take!)
physical chemistry Roughly, what is the error introduced by the solution of some of the CO2 in the water in the bomb? The solubility of CO2 is about 0.0015 g/mL at 25°C and 1 atm CO2 pressure. The heat of solution of CO2 in a dilute aqueous solution is roughly -19.4 kJ/mol. Assume that the final CO2 pressure is 2 atm and that Henry's Law applies.
Calculate the normality and molarity of a 15.0% (by weight) H₂SO₄ solution with a specific gravity of 1.090.
At 30°C, pure benze has a vapor pressure of 121.8 mmHg. Dissolving 15.0g of a non-volatile solute, R, in 250g of benzene produced a solution having a vapor pressure of 120.2 mmHg. Determine the approximate MW of solute R.
The Henry’s law constant for the solubility of radon inwater at 300C is 9.57 x 10-6 M/mm Hg. Radon is presentwith other gases in a sample taken from an aquifer at 300C.Radon has a mole fraction of 2.7 x 10-6 in the gaseous mixture. The gaseous mixture is shaken with water at a totalpressure of 28 atm. Calculate the concentration of radonin the water. Express your answers using the following concentration units.(a) molarity(b) ppm (Assume that the water sample has a density of1.00 g/mL.)
Solution Calculations Using unit analysis, clearly show the set-ups for your calculations. You wish to prepare 50.0 mL of 2.30 x 10–2 M solution of (Levothyroxine) C15H11I4NO4 drug. (hint-how many grams will you need of this drug?) Describe how to prepare this solution from the pure drug and deionized water. Analytical balances and volumetric flasks are available to you. (Assume that this drug dissolves in water, at least to the extent necessary for this problem.) Use complete sentences in your description of the solution preparation process. Thank you!!
Analysis of a groundwater sample collected from Well No. 8 of Stratford, Ontario showed: pH = 7.8, silica = 10 mg SiO2/L, calcium = 65 Ca2+ mg/L, magnesium = 18.2 mg Mg2+/L, sodium = 76 mg Na+/L, sulphate = 28 mg SO42-/L, bicarbonate = 287 mg HCO3-/L; and chloride = 98 Cl- mg/L. Is the water quality analysis satisfactory from the point of view of analytical accuracy? (hint: aquatic solutions much be electroneutral so check if the solution is charge balanced)
1 kg solution of aqueous oxalic acid was made by dissolving 10g of C2H2O4 and is used as a disinfectant. The disinfectant was made at 30oC and is 3.5% dissociated. Determine: (a) Vapor pressure of solution (b) Boiling pt. of solution (c) Freezing point depression (d) Osmotic pressure
Calculate the formality and normality of a commercial solution of H2SO4 whose purity is 97% and its density is 1.82 g/mL.MW of H2SO4= 98.0 g/mol