Aluminum hydroxide is used for the relief of heartburn, sour stomach, and peptic ulcer pain and to promote the healing of peptic ulcers. Calculate the mass of products formed and excess reactant in this preparation by constructing a BCA table, determining the mass of each product formed, and determining the amount of the excess reactant remaining. Complete Parts 1-4 before submitting your answer. Al2S3 + 6H₂O → 2Al(OH)3 + 3H₂S < PREV 1 2 3 Based on your table (Part 1), determine the maximum number of grams of H₂S (MW 34.0809 g/mol) formed under these conditions.. massH₂S = g

Aluminum hydroxide is used for the relief of heartburn, sour stomach, and peptic ulcer pain and to promote the healing of peptic ulcers. Calculate the mass of products formed and excess reactant in this preparation by constructing a BCA table, determining the mass of each product formed, and determining the amount of the excess reactant remaining. Complete Parts 1-4 before submitting your answer. Al2S3 + 6H₂O → 2Al(OH)3 + 3H₂S < PREV 1 2 3 Based on your table (Part 1), determine the maximum number of grams of H₂S (MW 34.0809 g/mol) formed under these conditions.. massH₂S = g

Chemistry: Principles and Reactions

8th Edition

ISBN:9781305079373

Author:William L. Masterton, Cecile N. Hurley

Publisher:William L. Masterton, Cecile N. Hurley

Chapter4: Reactions In Aqueous Solution

Section: Chapter Questions

Problem 62QAP: Ten mL of concentrated H3PO4 (91.7% by mass, d=1.69g/mL) was accidentally poured into a beaker...

See similar textbooks

Similar questions

The phosphorus in a 0.2091-g sample was precipitated as the slightly soluble (NH4)3PO4 • 12 MoO3. This precipitate was filtered, washed, and then redissolved in acid. Treatment of the resulting solution with an excess of Pb2+ resulted in the formation of 0.2922 g of PbMoO4. Express the results of this analysis in terms of percent P2O5.
The phosphorus in a 0.2222-g sample was precipitated as the slightly soluble (NH4)3PO4 • 12Mo O3. This precipitate was filtered, washed, and then redissolved in acid, Treatment of the resulting solution with an excess of Pb2+ resulted in the formation of 0.2922 g of PbMo O4. Express the results of this analysis in terms of percent P₂O5. _______ %
Write a balanced chemical equation for the reaction thatoccurs when (a) Mg(s) reacts with Cl2(g); (b) barium carbonatedecomposes into barium oxide and carbon dioxide gaswhen heated; (c) the hydrocarbon styrene, C8H8(l), is combustedin air; (d) dimethylether, CH3OCH3(g), is combustedin air.
Aqueous solutions of ammonia (NH3) and bleach (activeingredient NaOCl) are sold as cleaning fluids, but bottlesof both of them warn: “Never mix ammonia and bleach, astoxic gases may be produced.” One of the toxic gases thatcan be produced is chloroamine, NH2Cl. (a) What is theoxidation number of chlorine in bleach? (b) What is theoxidation number of chlorine in chloramine? (c) Is Cl oxidized,reduced, or neither, upon the conversion of bleachto chloramine? (d) Another toxic gas that can be producedis nitrogen trichloride, NCl3. What is the oxidation numberof N in nitrogen trichloride? (e) Is N oxidized, reduced, or neither, upon the conversion of ammonia to nitrogentrichloride?
Formaldehyde (CH2O, MM = 30.03) has a multitude of uses includingtissue preservation. Formalin is a commercially available solution offormaldehyde and has a concentration of 19.6 m formaldehyde anda density of 1.09 g/cm3. What is the molarity of formaldehyde inthe solution?
5. A 0.5664 g ore sample is dissolved in nitric acid and then filtered. The aluminum is present in solution as Al3+. The solution is made basic with ammonium hydroxide, NH4OH, and the aluminum hydroxide, Al(OH)3 (FW 78.004), precipitates. This gel is filtered in a porous glass crucible, rinsed with dilute ammonium hydroxide, ignited, cooled in a desiccator, and weighed. The resulting alumina, Al2O3 (FW 101.94), weighed 0.1605 g. Why is the solution filtered after acid dissolution? To remove insoluble matrix material (like sand, etc.) 6. In #5, why rinse with ammonium hydroxide solution? To avoid peptization or loss of precipitate. Ammonium hydroxide is a volatile electrolyte. 7. In #5, what chemical transformation takes place during ignition? (Show the balanced chemical equation) 2Al(OH)3 -> Al2O3 + 3H2O 8. In #5, why use a desiccator during cooling? To avoid weight gain by adsorption of atmospheric water. 9. In #5, calculate the weight percent Al (AW 26.9815) in the sample.
A fertilizer railroad car carrying 34,300 gallons of commercialaqueous ammonia (30% ammonia by mass)tips over and spills. The density of the aqueous ammoniasolution is 0.88 g>cm3. What mass of citric acid,C(OH21COOH21CH2COOH22, (which contains three acidicprotons) is required to neutralize the spill? 1 gallon = 3.785 L.
16.792 g of Ba(OH)2 (171.342 g.mol-1) is weighed out and carefully dissolved to make a 500.00cm3 solution. A 25.00 cm3 of this solution is pipette then transfer into a 100.00 mL volumetric flask, filling up to the mark with water. A 40.00 mL sample of this diluted solution is then reacted with a 0.753 M solution of HNO3. Ba(OH)2(aq) + 2HNO3(aq) → Ba(NO3)2(aq) + 2H2O(l) The moles of Ba(OH)2 transferred to the beaker is:
16.792 g of Ba(OH)2 (171.342 g.mol-1) is weighed out and carefully dissolved to make a 500.00cm3 solution. A 25.00 cm3 of this solution is pipette then transfer into a 100.00 mL volumetric flask, filling up to the mark with water. A 40.00 mL sample of this diluted solution is then reacted with a 0.753 M solution of HNO3. Ba(OH)2(aq) + 2HNO3(aq) → Ba(NO3)2(aq) + 2H2O(l) The volume of the nitric acid that will be required to fully react with the base is:
16.792 g of Ba(OH)2 (171.342 g.mol-1) is weighed out and carefully dissolved to make a 500.00cm3 solution. A 25.00 cm3 of this solution is pipette then transfer into a 100.00 mL volumetric flask, filling up to the mark with water. A 40.00 mL sample of this diluted solution is then reacted with a 0.753 M solution of HNO3. Ba(OH)2(aq) + 2HNO3(aq) → Ba(NO3)2(aq) + 2H2O(l) The concentration of Ba(OH)2 in the 500.00cm3 volumetric flask is?
A 1.00 g sample of a magnesium-aluminum alloy yields 0.107 g H2 when treated with an excess of HCl(aq). What is the percentage by mass of Al in the alloy? [Hint: This is the inverse of Example 4-16. To solve this problem, let m and 1.00 - m be the masses of Al and Mg, respectively, and then use these masses in the setup above to develop an equation that relates m to the total mass of H2 obtained. Then solve for m.]
Write a complete balanced chemical equation with states for the reaction described below. NH4NO3 → N2O + H2O Ca(OH)2 + HCl → CaCl2 + H2O C4H8 + O2 → CO2 + H2O Cl2 + H2O → HCl + HClO3 NaCl + AgNO3 → AgCl + NaNO3