Ammonia (NH3) gas and oxygen (O₂) gas react to form nitrogen (N₂) gas and water (H₂O) vapor. Suppose you have 2.0 mol of NH3 and 9.0 mol of O₂ in areactor.Could half the NH₂ react?If you answered yes, calculate how many moles of N₂ would be produced. Roundyour answer to the nearest 0.1 mol.yesnomolX3

Answered: Image /qna-images/answer/f1474673-090c-4ba9-b299-d74779460dcc.jpg

Ammonia (NH3) gas and oxygen (O₂) gas react to form nitrogen (N₂) gas and water (H₂O) vapor. Suppose you have 2.0 mol of NH3 and 9.0 mol of O₂ in a reactor. Could half the NH3 react? If you answered yes, calculate how many moles of N₂ would be produced. Round your answer to the nearest 0.1 mol. yes no mol S

Ammonia (NH3) gas and oxygen (O₂) gas react to form nitrogen (N₂) gas and water (H₂O) vapor. Suppose you have 2.0 mol of NH3 and 9.0 mol of O₂ in a reactor. Could half the NH3 react? If you answered yes, calculate how many moles of N₂ would be produced. Round your answer to the nearest 0.1 mol. yes no mol S

Chemistry: Matter and Change

1st Edition

ISBN:9780078746376

Author:Dinah Zike, Laurel Dingrando, Nicholas Hainen, Cheryl Wistrom

Publisher:Dinah Zike, Laurel Dingrando, Nicholas Hainen, Cheryl Wistrom

Chapter11: Stoichiometry

Section: Chapter Questions

Problem 9STP

See similar textbooks

Similar questions

3.50 A test of an automobile engine's exhaust revealed that g of NO2 was emitted in 10 minutes of operation. How many moles of NO2 would this engine release if it were used for a 45-minute commute, assuming that this mea- sured number is representative of the emission under all circumstances?
Magnesium ribbon reacts with acid to produce hydro- gen gas and magnesium ions. Different masses of magnesium ribbon are added to 10 mL of the acid. The volume of the hydrogen gas obtained is a measure of the number of moles of hydrogen produced by the reaction. Various measurements are given in the table below. (a) Draw a graph of the results by plotting the mass of Mg versus the volume of the hydrogen gas. (b) What is the limiting reactant in experiment 1? (c) What is the limiting reactant in experiment 3? (d) What is the limiting reactant in experiment 6? (e) Which experiment uses stoichiometric amounts of each reactant? (f) What volume of gas would be obtained if 0.300 g of Mg ribbon were used? If 0.010 g were used?
The space shuttle environmental control system handles excess CO2 (which the astronauts breathe out; it is 4.0% by mass of exhaled air) by reacting it with lithium hydroxide, LiOH, pellets to form lithium carbonate, Li2CO3, and water. If there are seven astronauts on board the shuttle, and each exhales 20. L of air pee minute, how long could clean air be generated if there were 25,000 g of LiOH pellets available for each shuttle mission? Assume the density of air is 0.0010 g/mL.
a. Write die balanced equation for the combustion of isooctane (C8H18) to produce water vapor and carbon dioxide gas. b. Assuming gasoline is 100.% isooctane, with a density of 0.692 g/mL, what is the theoretical yield of carbon dioxide produced by the combustion of 1.2 1010 gal of gasoline (the approximate annual consumption of gasoline in the United States)?
A weighed sample of iron (Fe) is added to liquid bromine (Br2) and allowed to react completely. The reaction produces a single product, which can be isolated and weighed. The experiment was repeated a number of times with different masses of iron but with the same mass of bromine (see graph below). (a) What mass of Br2 is used when the reaction consumes 2.0 g of Fe? (b) What is the mole ratio of Br2 to Fe in the reaction? (c) What is the empirical formula of the product? (d) Write the balanced chemical equation tor the reaction of iron and bromine. (e) What is the name of the reaction product? (f) Which statement or statements best describe the experiments summarized by the graph? (i) When 1.00 g of Fe is added to the Br2, Fe is the limiting reagent. (ii) When 3.50 g of Fe is added to the Br2, there is an excess of Br2. (iii) When 2.50 g of Fe is added to the Br2, both reactanu are used up compietely. (iv) When 2.00 g of Fe is added to the Br2, 10.8 g of product is formed. The percent yield must therefore be 20.0%.
When 64.7 g of HI (127.9 g/mol) forms from the reaction of hydrogen gas with excess iodine, how many grams of H2 are predicted to have reacted? Assume the reaction goes 100% to completion and report your answer to three decimal places (do not include units). H2 + I2 → 2 HI
Answer the problem using the rubrics below as a guide: Given and Asked - Complete data and proper units and significant figures (SF). Equation or formula used - Necessary equations needed in solving the problem are shown. Solution - Complete and organized solution/s shown Answer - Correct answer with correct significant figures (SF) and unit. 1. A combustion reaction wherein 15.0 g of propane (C3H8) is burned with 75.0 g of oxygen (O2). a. Determine the limiting reactant. b. What is the maximum amount of CO2 can you produce?
The combustion of gasoline produces carbon dioxide and water. Assume gasoline to be pure octane (C8H18) and calculate the mass (in kg) of carbon dioxide that is added to the atmosphere per 1.8 kg of octane burned. ( hint: Begin by writing a balanced equation for the combustion reaction.) mCO2 = kg
Glucose (C6H12O6) is broken down in cells through a series of redox reactions ending with the reduction of oxygen to water and the release of carbon dioxide. The overall process is also known as respiration. The balanced equation is shown below: C6H12O6 (s) + 6O2 (g) → 6H2O (g) + 6CO2 (g) If 332 grams of glucose were consumed, how many grams of water would be breathed out? Assume an excess of oxygen gas. Molar mass of glucose: 180.16 g/mol
What is the maximum number of grams of PHg that can be formed when 47.31 g of phosphorous react with 18.96 g of hydrogen to form PH? Round your answer to two digits after the decimal point. PA(g) + 6H2(8) -- > 4PHa(g)
Given: 2K(s) + 2H2O --> 2KOH + H2(g) How many grams of hydrogen gas are produced if 3.011 x1023 atoms of potassium react completely? Group of answer choices 0.252 g 5.6 g 1.008 g 2.016 g 0.504 g PreviousNext
Nitrogen (N2) gas and hydrogen (H2) gas react to form ammonia (NH3) gas. Suppose you have 13.0 mol of N2 and 1.0 mol of H2 in a reactor. Calculate the largest amount of NH3 that could be produced. Round your answer to the nearest 0.1 mol .