An absolute optical encoder disc has 10 rings and 10 led sensors, and in turn provides 10 bit outputs. Suppose the output pattern is 1100011100. What is the angular position of the shaft? What is the resolution?

An absolute optical encoder disc has 10 rings and 10 led sensors, and in turn provides 10 bit outputs. Suppose the output pattern is 1100011100. What is the angular position of the shaft? What is the resolution?

Electric Motor Control

10th Edition

ISBN:9781133702818

Author:Herman

Publisher:Herman

Chapter22: Sequence Control

Section: Chapter Questions

Problem 6SQ: Draw a symbol for a solid-state logic element AND.

See similar textbooks

Related questions

Q: Microprocessor Systems Question: A 20-bit address bus, an 8-bit processor uses a 3-to-8 decoder to…

A: The solution can be achieved as follows.

Q: 1. (2.85567*10^3)10 is stored in register $f0 as a single precision folating point binary number.…

A: As per the rules we can answer only one question, please post the remaining questions as the…

Q: Good voice reproduction via PCM requires 128 quantization levels. If bandwidth of voice channel is 4…

A: Given, Quantization level, Q=128 Bandwidth, B.W. = 4 kHz

Q: What is the largest binary number that can be expressed with 16 bits? What are the equivalent…

A: In this question, We need to determine the largest binary number of 16 but and equivalent decimal.…

Q: Q3 What is a Field-Programmable Gate Array? What are the major components of an FPGA? Q1 Please…

Q: Write MIPS program

A: The answer to the above problem is given below:-

Q: 4. FIGURE 1 shows how a 3 to 8 line decoder (TTL 74138) can be used in conjunction with NAND gate…

A: From the above question, we need to calculate a Address of the address bus in order to read the…

Q: Q6: How many bits are represented by each symbol in 64-QAM? Sketch a constellation diagram for 64-…

A: We are authorized to answer one question at a time, since you have not mentioned which question you…

Q: 3. Solve the analog conversion for 8-bit binary numbers 101011112?

Q: In an M-ary 64-QAM digital system a) How many level does the system support? b) How many bits per…

A: QAM : quadrature amplitude modulation

Q: A memory location has a logical address where the segment address is 2019h and the offset address is…

A: The value of the offset address is 0076H The value of the data segment is 2019H To calculate the…

Q: A special PCM system uses 12 bit word and 32 channels. Date is transmitted serially with no sync…

A: Given, PCM system has Number of bits per word (n) = 12 Number of channels (m) = 32 Time duration of…

Q: If an 8-bit binary number is used to represent an analog value in the range from 010 to 10010, What…

A: Given 010101102 is the given binary number.

Q: Assume SS=5000H, DS=6000H, ES=7000H, CS=9000H, BX=1000H, DI=2000H, BP=3000H, IP=4000H, SI=2000H, the…

Q: Question 2: Eight sources, each with a bit rate of 1000 kbps are to be combined using synchronous…

A: Dear student as per our guidelines we are supposed to solve only one question in which it should…

Q: The address bus of a computer is 16 bits wide and the data bus is 32 bits wide. How many bytes does…

A: Given data, The address bus line of a computer is 16 bits. The data bus line of the computer is 32…

Q: Suppose a ring oscillator is built from N inverters connected in a loop. Each inverter has a minimum…

Q: What is the largest binary number that can be expressed with 20 bits? What are the equivalent…

Q: 1. What is the equivalent of the decimal number 0.45 to binary (up to 6 bits precision)? Just type…

Q: Using the IEEE 754 floating point format, write down the bit pattern that would represent 1/4. Can…

A: IEEE 754 is the most efficient way of representing floating point numbers. It has three components:…

Q: write a program to count the number of 5 in a given array stored in memory locations from 0110 H to…

A: Note: According to Bartleby guidelines we are supposed to answer the first question. kindly repost…

Q: 1- Explain the operation of the PCM encoder used in module ED-2960F. 2- Discuss the advantages and…

A: “Since you have asked multiple questions, we will solve the first question for you. If you want any…

Q: 5) An 8-bit register contains 10010110. What is the corresponding value (in decimal) if it…

Q: Calculate the average total propagation delay of the circuit below. From external input source 1st…

Q: 1 the minimum signal to noise ratio (SNR) to receive the symbols bability of bit error 106 or less?…

Q: In a RAM chip of size 256M x 32, what are the number of data lines and address lines?

A: Buses have a address lines data lines and control lines. The data lines: Convey bits…

Q: Q5: Draw the implementation of 6-bits SISO shift register, and sketch the timing diagram with…

Q: 4) Illustrate the generation of noncoherent version of PSK signal for the input binary sequence…

A: Non-coherent PSK Generation : Initially, we are giving the input binary stream and delayed output…

Q: What is the decimal number equivalent of the largest binary number that can be obtained with 9 bits?…

Q: Scenario: In a biased N-bit binary number system with bias B, positive and negative numbers are…

Q: Q1.1 What is the largest binary number that can be expressed with 12 bits? What are the equivalent…

A: Note: As per the policy we can solve only one question please re-upload the remaining question as a…

Q: In digital communication .explain all the methods/mechanism used for the minimization of bit error…

A: The methods used for minimisation of bit error rate: The Wireless Deep Fading Environment (WDFE)…

Q: 1) Assume the signals with the highest amplitude of 5 volt are transmitted. The max error is about 1…

A: The solution is given below

Q: A 700 Mbyte CD is used to store PCM voice data. Suppose that a CT voice signal is sampled at 10 kHz,…

A: Given; Total PCM voice data stored in CD is 700 MB Sampling frequency fs=10 kHz Number of encoded…

Q: We need to use synchronous TDM and combine 20 digital sources, each of 100 Kbps. Each output slot…

Q: VHDL Difference between function and task. What is logic data type.

A: Bit is 2 state data type. It can take 0 and 1 only. Reg is driven by always block it can't be…

Q: For a PCM system with the following parameters, Parameters: (i) Maximum analog input frequency = 5…

A: It is given that: fm=5kHzDynamic range=54dBVmax=±5.01V

Q: Convert decimal number 54.3125 to fixed point binary notation. How many bits are needed? Suppose…

Q: Q.65 (i) How many 128x8 RAM chips are required to provide a memory capacity of 2048 bytes. (ii) How…

A: Solution !!

Q: Consider two microprocessors having 8-bit and 16-bit wide external data buses, respectfully. The two…

Q: 4. FIGURE 1 shows how a 3 to 8 line decoder (TTL 74138) can be used in conjunction with NAND gate…

Q: 1. Represent the decimal values 11 and -10 as 8-bit signed integers. Add the two binary…

A: Since you have asked multiple questions, we will solve the first question for you. If you want any…

Q: Construct a bus system using tri state buffer for 2 registers having 4 bits each.

A: We have given the following problem Construct a bus system using tri state buffer for 2 registers…

Q: The speed of a serial data transmission is 2.5 Mbps. What is the actual number of bits that occur in…

A: The solution can be achieved as follows.

Q: How many address lines are required by a microprocessor to address 256KB of memory locations? If we…

Q: Write an assembly language program for 8085 microprocessor to add 2 digit BCD numbers stored in…

A: to perform the given problem Registers A, C, H, L are used for general purpose several 8085…

Q: Suppose x is an integer where 0 ≤ x ≤ 9, and F(x, y) = y sin(πx/10). Assuming fractions are…

A: Given that, x is an integer where 0 ≤ x ≤ 9, and F(x, y) = y sin(πx/10).

Q: Q2) Write the Assembly language instructions required to find: Z-X/Y, where X and Y are 16- bit…

A: Memory address Mnemonics 2000 LDA 2050 2003 MOV H, A 2004 LDA 2051 2007 ADD H 2008 MOV L,…

Q: 1. Maximum operating frequency of PIC microcontroller is 8 MHZ 12 MHZ 16 MHZ 20 MHZ 2. PIC 16f877a…

A: 1) Option - D -- 20 MHZ Maximum operating frequency of PIC microcontroller is 20 MHZ 2) Option -…

Q: Find the number of bits given if the PCM system has a quantization error of 0.4 V and maximum input…

A: Given: Quantization error = 0.4 V Maximum input = 6V

Question

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

This is a popular solution!

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Trending now

This is a popular solution!

Step by step

Solved in 2 steps with 2 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, electrical-engineering and related others by exploring similar questions and additional content below.

Similar questions

What is an MSDS?
Consider two microprocessors having 8-bit and 16-bit wide external data buses, respectfully. The two processors are identical otherwise and their bus cycles are the same speed. Suppose all instructions and operands are two Bytes. By what factor do the maximum data transfer rates vary? Suppose all instructions and operands are one Byte. By what factor do the maximum data transfer rates vary? Discuss your answers.
1. a. Create the gray code representation of the following binary numbers.i) 01011 ii) 10110 iii) 01101 iv) 11001 b. If a computer’s system clock is 2.7 GHz, calculate the period of the system clock. c. What is the minimum sampling rate needed in order to successfully capture frequencies up to 60MHz in an analog signal? d. Represent the number 1.00011011101 x 2-23in IEEE Standard 754 single precision floating point binary.
Assess the method to generate a 6.25 MHz signal using a 10-bits serial shift register operated with 50 MHz clock. Show all the necessary steps, delay calculations and workings in your answer.
If in a PCM system, uniform quantizer having total 256 steps is being used, then what will be the number of transmitted bits per sample?
For a CD audio system, the analog signal is digitized such that the signal to quantization ratio is maintained at least 96dB. The sampling is performed at 44100Hz. a) What is the minimum number of quantization levels required to attain the given signal to quantization noise ratio?b) How many bits per sample are required when levels are identified in part a)?c) Identify the data rate in bits/s for the system.
Find the number of bits given if the PCM system has a quantization error of 0.4 V and maximum input voltage of 6 V.
Q31)The bit rate for American PCM-24 system is a. 2.048 Mb/s b. 1.544 Mb/s c. 8 kb/s d. 64 kb/s This multiple choice question from DIGITAL COMMUNICATIONS course.just write for me the final answer.
Write an assembly language program for 8085 microprocessor to add 2 digit BCD numbers stored in memory location C050H and C051H respectively and store the result in memory location C052H.
Question 5 a) Briefly explain the Nyquist theorem in the context of digital sampling. b) Using logic gates, design an active low chip select for the memory a 256 K memory device starting at address 38000016 in a 16 Megabyte memory space. c) Convert each of the following 8-bit signed magnitude binary numbers to decimal. i) 10110101(base 2) ii) 01000101(base 2) iii) 11101010(base 2) iv) 01011110(base 2)
Construct a bus system using tri state buffer for 2 registers having 4 bits each.
A special PCM system uses 12 bit word and 32 channels. Date is transmitted serially with no sync pulse. The time duration for 1 bit is 488.28 ns. How many bits per frame is transmitted and at what rate?