an ac circuit has a frequency of 400 hz. a 16- ohms resistor, a 0.0119-h inductor, and a 16.6- uf capacitor are connected in series. If the voltage connected to the circuit is 440v. How many degrees are the voltage and current out of phase with each other?

Q: The drawing shows three ac circuits, as shown below, each connected to identical generators.…

A:

Q: The following is given for a series R-L-C circuit: resistor (R) = 8 Ohms, an inductor (L) = 32 mH…

A:

Q: When you are converting an instantaneous current to a phasor, how does the phase angle being…

A: The overall solution depends on the phase angle or epoch (initial phase) of the instantaneous form…

Q: A single-phase AC voltage controller has a resistive load R = 10 Ohm, and %3D the RMS input voltage…

A:

Q: A 400 resistor is connected in parallel to a coil having a resistance of 10 and an inductance of 3H.…

A: As per the guidelines of Bartleby we supposed to answer first three subpart only for solution of…

Q: 3. AC Analysis 1:1 I 586 0 Vị 19µF 36 mH V; is a sinusoidal AC voltage source having frequency 110…

A:

Q: 1µF Is(t) Vs(t) L

A: For the current to be in phase with voltage the circuit should be in resonance . i.e the inductance…

Q: An alternating current is given by the expression i = 200 sin (314t + T/6) amperes. The maximum…

A: Given: Expression for alternating current i=200sin314t+π/6 amperes

Q: A Star 3Phase source with phase voltage of 400V at 50HZ is connected to a delta connected 3Phase AC…

A:

Q: An AC system with the frequency of 60hz is composed of 2 relays with 20 ohms resistance and 0.16…

A:

Q: An RC series circuit is connected to a 240-V, 60-Hz power source. An ammeter indicates a current of…

A: An RC series circuit is connected to a 240-V, 60-Hz power source. An ammeter indicates a current of…

Q: An AC circuit has a frequency of 400 Hz. A 16-Ω resistor, a 0.0119-H inductor, and a 16.6-µF…

A:

Q: Given į =-10 sin(3t-85degree) e. Find the Frequency of the current f. Calculate at i at t= 2 ms.

A:

Q: AN AC source has a sinusoidal current of 4.8 sin(400Tt +30°) A. What is dc current of the circuit?

A:

Q: 1. What is the phase relationship between R, L, and C components in a parallel AC circuit?

A:

Q: IMPEDANCE AND ADMITTANCE OF AC CIRCUIT WHAT ARE THE DIFFERENCE SHOW CIRCUIT AND TABLES

A: We need to tell about the difference between impedance and admittance .

Q: The equation for an altemating current is given by i = 75 sin 314.16t. Find the peak value,…

A:

Q: A non-sinusoidal voltage (e=20+15sin1000t+ 10sin3000t+5sin4000t) Volt is plied to the circuit shown.…

A: A Non- Sinusoidal Voltage; e=20+15sin1000t+10sin3000t+5sin4000tTo find the total power=?Power=V2Z

Q: 15 A of current is taken by a non-inductive load at 125 V. In order that the same current shall be…

A:

Q: An ac circuit is rated 160 kVA at a lagging power factor of 0.75. Determine the reactive power

A:

Q: A coil is in series with a 20 microFarad capacitor across a 230 V, 50 Hz supply. The current taken…

A:

Q: 1. What is the phase relationship between R, L, and C components in a series AC circuit? 2. What is…

A: Series R, L, and C circuit comprises of the resistor R, inductor L and the capacitor C. Let the…

Q: The current and voltage in an AC circuit is given by V=120 sin (377t+20°) V and i=5 sin(377t– 60°)…

A: Draw the phasor diagram to find angle between voltage and current .

Q: An rms voltage of 22.2 V with a frequencyof 1.00 kHz is applied to a 0.290-mH inductor. (a) What is…

A: (a) Write the given values. Vrms=22.2 VL=0.29 mHf=1 kHz

Q: A 25-ohm resistor connected in series with a coil of 50-ohm resistance and 150-mH inductance. What…

A:

Q: Write a report to compare between Ac Through capacitance and AC through in inductance then: For the…

A:

Q: A. The field winding of a DC generator is wound with 900 turns and has a resistance of 50 ohms. If…

A:

Q: 1. Build the following circuit, Use the function generator to obtain the specified AC input voltage.…

A:

Q: The complex power for an ac circuit is given as S=5ej(pi/4) VA.  What will be the value of the real…

A: If S is he complex power associated with a circuit containing both the resistance and reactance,…

Q: a) Draw a graph that depict single-phase waveforms for a purely sinusoidal 50 Hz voltage with…

A: a) Draw a graph that depict single-phase waveforms for a purely sinusoidal 50 Hz voltage with…

Q: A 120V adjustable frequency ac source is connected in series with a resistor, an inductor, and a…

A:

Q: 3. Replace the DC source by an ac source with an rms value of 12 V. Connect it across the same bulb.…

A:

Q: Write a report to compare between Ac Through capacitance and AC through in inductance then: For the…

A:

Q: A non-sinusoidal voltage (e=20+15sin1000t+ 10sin3000t+5sin4000t) Volt is applied to the circuit…

A: Given:- e=20+15sin1000t+10sin3000t+5sin4000t Formula used:- Power :-V2Z

Q: Consider the sinusoidal voltage v = 48 cos(32t + 10°) V. NOTE: This is a multi-part question. Once…

A: Given: Vt=48 cos 32t+10°V

Q: Q1: By using Multisim software, Put AC voltage from function generator (2v, 50 HZ) to the…

A:

Q: When a load is connected to a power line with a frequency of 230V (rms) 50 Hz, it draws 4500 W at a…

A: We will find out reactive power ,from reactive power we will find capacitance .

Q: The current through the 20-Ohm inductive reactance is given. What will be the sinusoidal expression…

A: The voltage across the inductor can be evaluated using the Ohm’s law:

Q: Resistor R and a resistanceless coil L1 = 83.8 mH are connected in series to an AC source with…

A: The given circuit is the RL circuit: The current I can be calculated as: Irms=VrmsR2+XL2

Q: QUESTION 1 Given an AC source having a voltage v(t)=22sin(87t + 22°) V, find the period of the…

A:

Q: A non-sinusoidal voltage source (e, 10+15sin1000t- 100cos2000t-75sin3000t) Volt is applied to the…

A:

Q: For the circuit below with a sinusoidal voltage source, determine the average power supplied be the…

A:

Q: 3. Replace the DC source by an ac source with an rms value of 12 V. Connect it across the same bulb.…

A: Vrms=12V f=60Hz Rlamp=12 ohms.

Q: Due to mutual inductance between two coils, there is an induced emf in one coil due to a change in…

A: Answer:True

Q: Write a report to compare between Ac Through capacitance and AC through in inductance then: For the…

A:

Q: ww v(t)=28.284 cos(ot + 55°) + S' I

A:

Q: H.W: The voltage across a 0.5-H coil is provided below. What is the sinusoidal expression for the…

A: Given: L=0.5 Hv=100sin20t

Q: A coil draws 1875 watts when connected to a

A: This question belongs to circuit theory . It is based on the concept of coil .

Q: An AC generator has an output rms voltage of 58.0 V at a frequency of 56.0 Hz. If the generator is…

A: Given: Output RMS voltage, V0rms=58 V Frequency, f=56 V Inductance, L=20 mH

Power Measurement

According to Blondel's theorem, the total power is measured with one less number of wattmeters than the number of wires present in the system. So, a single-phase and two-wire system will require one wattmeter and a single-phase and the three-wire system will require two wattmeters, and a three-phase and the three-wire system will also require two wattmeters and a three-phase and the four-wire system will require three wattmeter devices. The wattmeter is a device that measures power using one voltage and one current input as shown in the above figure. Multiple current or voltage input pair cables are used by many power analyzers and digital storage oscilloscopes (DSOs) for measuring watts, in effect within a single instrument acting as multiple wattmeters. It is possible to measure three-phase and four-wire power with one correctly specified power analyzer.