19. I’ll give thumbs up if correct :) An airplane has a half-wingspan of 35m. Determine the change in length(mm) in mm of the aluminum alloy[Coefficient of Thermal Expansion22.5×10-6/°C] wing span if theplane leaves the ground at atemperature of 15°C and climbs to analtitude where the temperature is -48°C. Note: Add minus sign if change inlength is a contraction. Use 2decimals=

Given data in question Length Coefficient of thermal expansion Change in temperature To find out…

An airplane has a half-wingspan of 35 m. Determine the change in length (mm) in mm of the aluminum alloy [Coefficient of Thermal Expansion 22.5x10-6/°C] wing span if the plane leaves the ground at a temperature of 15°C and climbs to an altitude where the temperature is -48 °C. Note: Add minus sign if change in length is a contraction. Use 2 decimals =

An airplane has a half-wingspan of 35 m. Determine the change in length (mm) in mm of the aluminum alloy [Coefficient of Thermal Expansion 22.5x10-6/°C] wing span if the plane leaves the ground at a temperature of 15°C and climbs to an altitude where the temperature is -48 °C. Note: Add minus sign if change in length is a contraction. Use 2 decimals =

Structural Analysis

6th Edition

ISBN:9781337630931

Author:KASSIMALI, Aslam.

Publisher:KASSIMALI, Aslam.

Chapter2: Loads On Structures

Section: Chapter Questions

Problem 1P

See similar textbooks

Similar questions

A mass of 2 kg is projected with a speed of 3m/s up a plane inclined 20° with the horizontal. After traveling 0.8m, the mass comes to rest. Determine the coefficient of friction.
If the potential energy for a conservative onedegree- of-freedom system is expressed by the relation V = (4x3 - x2 - 3x + 10) ft ⋅ lb, where x is given in feet, determine the equilibrium positions and investigate the stability at each position.
A particle travels in a straight line with constant acceleration. When s = 4 , v=5 ft/s andwhen s=8, v=7 ft/s. Determine the acceleration ft/s^2.
3. A vertical piston-cylinder device on the left containing a gas has a mass of 40 kg and a cross-sectional area of 0.012 m². The local atmospheric pressure is 95 kPa, and the gravitational acceleration is 9.81 m/s². Determine the absolute pressure (kPa) inside the cylinder. (2 decimal)
The rotor of an electric motor has an angular velocity of 3600 rpm when the load and power are cut off. The 110-lb rotor, which has a centroidal radius of gyration of 9 in., then coasts to rest. Knowing that the kinetic friction of the rotor produces a couple with a magnitude of 2.5 lb-ft, determine the number of revolutions that the rotor executes before coming to rest.
dynamics question m=85 kg v=85 m/s r=5m
The rotor of an electric motor has an angular velocity of 4500 rpm when the load and power are cut off. The 75-kg rotor, which has a centroidal radius of gyration of 200 mm, then coasts to rest. Knowing that kinetic friction results in a couple of magnitude 4.5 N m⋅ exerted on the rotor, determine the number of revolutions that the rotor executes before coming to rest. DO NOT ROUND OFF IN THE SOLUTION. ROUND OFF ONLY IN 2 DECIMAL PLACE IN THE FINAL ANSWER
An air–fuel mixture is compressed by a piston in a cylinder of an internal combustion engine. The origin of coordinate y is at the top of the cylinder, and y points straight down as shown. The piston is assumed to move up at constant speed VP. The distance L between the top of the cylinder and the piston decreases with time according to the linear approximation L = Lbottom − VPt, where Lbottom is the location of the piston when it is at the bottom of its cycle at time t = 0, as sketched in Fig. At t = 0, the density of the air–fuel mixture in the cylinder is everywhere equal to ?(0). Estimate the density of the air–fuel mixture as a function of time and the given parameters during the piston’s up stroke.
Given: Specific weight of water = 9.81 kN/m3 Specific gravity (S.G) of oil = 0.8 Find: The density of water in kg/m3. The specific weight of oil in kN/m3.
⦁ A steel tape with coefficient of linear expansion of 0.0000116/0 C is known to be 50 m long at 20 C. The tape was used to measure a line, when the temperature was 30 C. If the corrected distance was found to be 582.424m., Find the measured distance.
A pump is used in a building to lift water from a ground floor. The pump is pushing 60l/sec of water through a 0.1m diameter to above floor which is 5m high Analyse the relationship between frictional energy loss under different gravitational flow conditions
A spherical tank of radius 0.35 m is filled with water with a density of 62.4lbm/ft^3. Calculate the mass of the water in the tank in Lon and in kg. V=(3.14D^3/6) where D is the diameter.