An AM signal in which the carrier is modulated 70% contains 1500Wa the carrier frequency. Calculate the power at the carrier and the powe content of each of the sidebands when the percent modulation drops 50%? *

An AM signal in which the carrier is modulated 70% contains 1500Wa the carrier frequency. Calculate the power at the carrier and the powe content of each of the sidebands when the percent modulation drops 50%? *

College Physics

1st Edition

ISBN:9781938168000

Author:Paul Peter Urone, Roger Hinrichs

Publisher:Paul Peter Urone, Roger Hinrichs

Chapter24: Electromagnetic Waves

Section: Chapter Questions

Problem 50PE: Unreasonable Results An LC circuit containing a 1.00-pF capacitor oscillates at such a frequency mat...

See similar textbooks

Related questions

Q: A radio station utilizes frequencies between commercial AM and FM. What is the frequency of a…

A: Given: wavelength = 11.12 m

Q: If a carrier wave of 1000 kHz is used to carry the signal, the length of transmitting antenna will…

A: Frequency (v) = 1000 kHz = 106 Hz Speed of Light (c) = 3 * 108 m/s

Q: MHz antenna carried by an airplane flying over the ocean surface generates a wave that approaches…

A: (given) Conductivity σ=4 S/m Dielectric constant(εr)=72 Relative permeability μr=1 Frequency (f) =…

Q: The answer should be a percentage.

A: According to the question statement, the expression for the ratio of the intensity: For red-light…

Q: A carrier wave of peak voltage 12 V is used to transmit a message signal. Calculate the peak voltage…

A: The relation for the modulating index is given by μ = AmAc where, Am is the peak voltage if the…

Q: compute the wavelength. an AM station operating at a frequency of 750 Hz

Q: Explain, why high frequency carrier waves are needed for effective transmission of signals. A…

A: High-frequency carrier waves almost travel at the speed of light. These waves are not affected by…

Q: Determine the %modulation of an AM signal if the maximum voltage is 50 V and the minimum voltage is…

Q: A 150 m antenna transmitting frequency at 1.2 MHz by ground wave has an antenna current of 8 A. What…

A: Given : Transmitting frequency =f= 1.2 MHz Transmitting antennae height=ht= 150 meters Receiving…

Q: Estimate how long an AM antenna would have to be if it were (a) A or (b)A. AM radio is roughly 1 MHz…

A: Given: The frequency of AM radio is f= 1 MHz. The expression for wavelength (λ) is: λ=cf Here, c…

Q: A carrier wave of peak voltage 12 V is used to transmit a message signal. What should be the peak…

A: Given data: Carrier wave peak voltage is, Vc=12 V Nodulation index is, μ=75%=0.75 Formula used: The…

Q: A radio station has two antennae which are used to broadcast their 582 kHz radio wave signal. The…

A: It is given that

Q: A carrier wave of peak voltage 18 V is used to transmit a message signal. Calculate the peak voltage…

A: The incoming incident signal is often not compatible with the communication medium and hence…

Q: he U.S. Navy has long proposed the construction of extremely low frequency (ELF waves)…

A: Write the given values of the problem- Frequency(λ) λ=70 Hz

Q: Q1) The maximum peak to peak value of an AM wave is 52 volts and its frequency is 58000000. The peak…

A: Given: The amplitude of the carrier signal is Vc=52 v the frequency of the carrier signal is…

Q: Q3 / A receiving antenna has an impedance equal to 500. If the greatest power transferred from this…

A: Impedance=50ohm Power=150watt

Q: 7. If two signals of different amplitude are connected to inverting and non-inverting inputs of an…

A: OP-Amp is a voltage controlled voltage source with very high gain. If two singals of different…

Q: : A particular radio station utilizes frequencies between commercial AM and FM, to avoid…

A: Frequency (f) = 13MHz f = 13 × 106Hz We know that Vw= fλ. Where vW is the propagation speed of the…

Q: Q.1. The amplitude of a carrier wave lies between 25 mV and 5mV. Calculate the depth of modulation.

A: Given data: - The maximum potential is Vmax = 25 mV. The minimum potential is Vmin = 5 mV.

Q: An AM signal in which the carrier is modulated 70% contains 1500 W at the carrier frequency.…

Q: An em plane wave (not shown) propagates in the +z direction. A long thin wire connected to a light…

A: Given- Suppose the wire is rotated in the ccw direction by 900 in the xy plane. For the light bulb…

Q: A 1.07-µH inductor is connected in series with a variable capacitor in the tuning section of a…

A: The inductance is connected in the circuit is L=1.07μH=1.07×10-6 H. The linear frequency of the…

Q: Citizen's band (CB) radio utilizes frequencies between commercial AM and FM. What is the frequency…

Q: What is meant by term ‘modulation’? Draw a block diagram of a simple modulator for obtaining an AM…

Q: The intensity of your wifi signal is 16 units at a point A from the router. What will be the…

Q: A carrier signal given by (cos2Tt105t) volt is AM modulation by the message signal given by…

A: The correct option for the following Ques is Option B Ps= 64, Pc = 128, bandwidth = 2khz, and u =…

Q: Content DETAILS Chapter OSCOLPHYS2016 24.3.P.006. MY NOTES mts] Two microwave frequencies are…

Q: You and your friend Bruce are experimenting with a red lamp shade and blue lamp shade. You place…

Q: From Figure 2, determine fc (kHz): From Figure 2, determine Wc (mm):

A: Given: The speed is v=343 m/s. The initial wavelength is W1=200 m. The final wavelength is W2=5000…

Q: Infared light has a lower frequency than visible light. What is the frequency of IR light that has…

A: Given:Wavelength of IR light, λ = 680 nmVelocity of light, c = 3 X 108 m/s

Q: What is meant by ‘detection of a modulated signal’? Draw block diagram of a detector for AM waves…

A: Detection of the modulated signal: Detection means recovery of modulated signal. The modulated…

Q: You and your friend Bruce are experimenting with a red lamp shade and blue lamp shade. You place…

Q: Considering a channel with the power delay profile below, what kind of fading will a service having…

A: Given Power Delay Profile, we can classify a multipath channel into frequency selective or frequency…

Q: An FM radio station broadcasts at a frequency of 100 MHz. What inductance should be paired with a 10…

A: Resonant frequency, f= 100 MHz capacitance, C = 10 pF The formula of the resonant frequency is f=…

Q: Radio receivers can comfortably pick up a broadcasting station's signal when the electric field…

A: Given Data: The electric field strength of the electromagnetic wave is, E=10.0 mV/m The average…

Q: Write the expression for an AM wave when a carrier 10 cos(628000t) is modulated by a message…

Q: The U.S. Navy has long proposed the construction of extremely low frequency (ELF waves)…

Question

quickly solving plz

An AM signal in which the carrier is modulated 70% contains 1500 W a
the carrier frequency. Calculate the power at the carrier and the powe
content of each of the sidebands when the percent modulation drops
50%? *

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

This is a popular solution!

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step 3

VIEW

Trending now

This is a popular solution!

Step by step

Solved in 3 steps with 3 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, physics and related others by exploring similar questions and additional content below.

Similar questions

A carrier signal of 10 V amplitude is modulated by an information signal to a depth of 80%. Calculate the Vmax and Vmin for the modulated wave.
A radio can tune over the frequency range of a portion of MW broadcast band: (800 kHz to 1200 kHz). If its LC circuit has an effective inductance of 200 µH, what must be the range of its variable capacitor?
Determine the %modulation of an AM signal if the maximum voltage is 50 V and the minimum voltage is 30V.
For what absolute value of the phase angle does a source deliver 74 % of the maximum possible power to an RLC circuit?
The AM band extends from approximately 500. kHz to1 600. kHz. If a 2.0 - µH inductor is used in a tuning circuit fora radio, what are the extremes that a capacitor must reach tocover the complete band of frequencies?
From Figure 2, determine fc (kHz):From Figure 2, determine Wc (mm):
A carrier wave of peak voltage 12 V is used to transmit a message signal. Calculate the peak voltage of the modulating signal in order to have a modulation index of 75%.
A station is given a carrier frequency of 88 kHz. Having a modulating frequency of 12 kHz, compute for the upper and lower sidebands of the station.
The AM band extends from approximately 500 kHz to 1,600 kHz. If a 1.5-?H inductor is used in a tuning circuit for a radio, what are the extremes that a capacitor must reach in order to cover the complete band of frequencies? Cmax = nF Cmin = n
The power content of the carrier of an AM wave is 5 KW. Determine the power content of each sidebands and the total power transmitted when the carrier is modulated 75%.
Explain, why high frequency carrier waves are needed for effective transmission of signals. A message signal of 12 kHz and peak voltage 20 V is used to modulate a carrier wave of frequency 12 MHz and peak voltage 30 V. Calculate the (i) modulation index (ii) side-band frequencies.
A message signal of frequency 10 kHz and peak voltage 10 V is used to modulate a carrier of frequency 1 MHz and peak voltage 20 V. Determine (i) the modulation index, (ii) the side bands produced.