An ideal gas within a piston-cylinder assembly undergoes a Carnot refrigeration cycle, as shown in the figure below. The isothermalcompression occurs at 325 K from 2 bar to 8 bar. The isothermal expansion occurs at 275 K.Determine:THp-v diagram for a Carnot gasrefrigeration or heat pump cycle.(a) the coefficient of performance,(b) the heat transfer to the gas during the isothermal expansion, in kJ per kmol of gas,(c) the magnitude of the net work input, in kJ per kmol of gas.

Given that, an ideal gas in piston-cylinder device undergoes a Carnot refrigeration cycle shown in…

An ideal gas within a piston-cylinder assembly undergoes a Carnot refrigeration cycle, as shown in the figure below. The isothermal compression occurs at 325 K from 2 bar to 8 bar. The isothermal expansion occurs at 275 K. Determine: TH Tc. p-v diagram for a Carnot gas refrigeration or heat pump cycle. (a) the coefficient of performance, (b) the heat transfer to the gas during the isothermal expansion, in kJ per kmol of gas, (c) the magnitude of the net work input, in kJ per kmol of gas.

An ideal gas within a piston-cylinder assembly undergoes a Carnot refrigeration cycle, as shown in the figure below. The isothermal compression occurs at 325 K from 2 bar to 8 bar. The isothermal expansion occurs at 275 K. Determine: TH Tc. p-v diagram for a Carnot gas refrigeration or heat pump cycle. (a) the coefficient of performance, (b) the heat transfer to the gas during the isothermal expansion, in kJ per kmol of gas, (c) the magnitude of the net work input, in kJ per kmol of gas.

Elements Of Electromagnetics

7th Edition

ISBN:9780190698614

Author:Sadiku, Matthew N. O.

Publisher:Sadiku, Matthew N. O.

ChapterMA: Math Assessment

Section: Chapter Questions

Problem 1.1MA

See similar textbooks

Similar questions

vapor-compression refrigeration cycle operates at steady state with Refrigerant 134a as the working fluid. Saturated vapor enters the compressor at 2 bar, and saturated liquid exits the condenser at 8 bar. The isentropic compressor efficiency is 80 %. The mass flow rate of refrigerant is 7 kg/min. Sketch the process on a T-s diagram and determine; I) the compressor power, in kW Ii) the refrigeration capacity, in tons III) the coefficient of performance.
In a vapor-compression refrigeration cycle, ammonia exits the evaporator as saturated vapor at -22°C. The refrigerant enters the condenser at 16 bar and 190°C, and saturated liquid exits at 16 bar. There is no significant heat transfer between the compressor and its surroundings, and the refrigerant passes through the evaporator with a negligible change in pressure.If the refrigerating capacity is 50 kW, determine:(a) the mass flow rate of the refrigerant, in kg/s.(b) the power input to the compressor, in kW.(c) the coefficient of performance.(d) the isentropic compressor efficiency, in percent.(e) the rate of entropy production, in kW/K, for the compressor.
A vapor-compression refrigeration cycle operates at steady state with Refrigerant 134a as the working fluid. Saturated vapor enters the compressor at 2 bar, and saturated liquid exits the condenser at 8 bar. The isentropic compressor efficiency is 80 %. The mass flow rate of refrigerant is 7 kg/min. Sketch the process on a T-s diagram and determine; the compressor power, in kW the refrigeration capacity, in tons the coefficient of performance.
Calculate the Coefficient of Performance for an ideal vapor-compression air conditioner operating between 10°C and 30°C, approximately.
An AC with a heat transfer rate of 55000 BTU/HR from air @14.7 psia and 95 degrees F, with rate of 1500 ft3/min. Refrigerant 134a is used and evaporates at a constant pressure of 50 psia from compressed liquid conditions, 30F, to exit temperature of 50 F. For air, Cp=0.24 Btu/lbm-R and Rair=53.3 ft-lbf/lbm-R; Determine the mass-flow-rate of liquid refrigerant required and the exit temperature of the air. Sorry for the missing info
A steam-powered power plant works on the basic Rankine cycle.shown in the figure. Likewise, some of its thermodynamic states are summarized in the attached table.Knowing that the work per unit mass delivered to the pump is 3W4 = 2480 (J/kg], determinein SI units the following: a) The specific volume of water in state 4.b) The associated work per unit mass, developed in the Curbina.c) The associated heat per unit mass released by the water in the condenser.d) The efficiency of the cycle
As shown in the figure, Refrigerant 22 enters the compressor of an air conditioning unit operating at steady state at 40oF, 80 lbf/in2 and is compressed to 160oF, 200 lbf/in2. The refrigerant exiting the compressor enters a condenser where energy transfer to air as a separate stream occurs, and the refrigerant exits as a liquid at 200 lbf/in2, 90oF. Air enters the condenser at 75oF, 14.7 lbf/in2 with a volumetric flow rate of 1500 ft3/min and exits at 110oF. Neglect stray heat transfer and kinetic and potential energy effects, and assume ideal gas behavior for the air.
1.) A Carnot power cycle employing 1 lb of air as a working substance is pressumed to operate between temperature limits of 600 F and 70 F . The pressure at the beginning and end of isothermal expansion process are 510 psia and 170 psia respectively Determine: A.) The change of volume between the end of isentropic expansion and the end of isentropic compression , ft *3/lb . B.) The heat supplied to the cycle , Btu/ lb C.) The heat rejected to the cycle , btu/ lb D.) The net work of the cycle , btu . lb E.) The cycle thermal efficiency , %
Two reversible cycles operate between hot and cold reservoirs at temperatures TH and TC, respectively. (a)If one is a power cycle and the other is a refrigeration cycle, what is the relation between the coefficient of performance of the refrigeration cycle and the thermal efficiency of the power cycle? (b)If one is a refrigeration cycle and the other is a heat pump cycle, what is the relation between their coefficients of performance?
Figure P6.22 provides the T-s diagram of a Carnot refrigeration cycle for which the substance is Refrigerant 134a. Determine the coefficient of performance.
For the NH3/H2O cycle the following relationship give the solution flow rate per unit refrigeration rate: WFS_A * X - WFS_G(X-1) = 1 whereWFS_A = mass fraction of NH3 in solution form the absorberWFS_G = mass fraction of NH3 in solution from the generator X-1 =mass of solution from the generator per unit mass of refrigerant flowFor large systems, a reasonable pressure drop between the evaporator and absorber is 1.5 psiConsider a large NH3/H2O plant operating per the schematic below: Known/given:i. Refrigeration load = 500 tonsii. Evaporator temperature (state point 10) = 41.1 Fiii. Evaporator pressure (state point 10) = 75 psiaiv. Absorber pressure (state point 11) = 73.5 psia (per rule of thumb above regarding pressure drop between the evaporator and absorber)v. Strong aqua solution temperature (state point 3) = 105 Fvi. Condenser temperature (state point 8) = 100 Fvii. Condenser and tower pressure (state point 7) = 211.9 psiaviii. Concentration split, WFS_G - WFS_A =6% by weight…
Problem # 2: In a steam thermal plant, it operates with a condenser outlet temperature of 180 ° F, and a boiler outlet temperature of 1000 ° F. If the pressure at the pump outlet is 300 psia. If the efficiencies of the turbine and pump are 85%. Determine: a.) The real work of the turbine, in Btu / Ibm. b.) The actual work of the pump, in Btu / Ibm. c.) The thermal efficiency of the real cycle. d.) The thermal efficiencies of the ideal cycle and Carnot. e.) Diagram T vs s, with all possible values and indicating the real and ideal cycles.