An ideal transformer has N1 turns in its primary and N2 turns in its secondary. To the primary, AC voltage equals to V1 is connected. A device with total resistance R2 is connected to the secondary. How much power (in watts) is supplied to the primary, provided the following values: N1 = 46 turns N2 = 219 turns V1 = 11 Volts

An ideal transformer has N1 turns in its primary and N2 turns in its secondary. To the primary, AC voltage equals to V1 is connected. A device with total resistance R2 is connected to the secondary. How much power (in watts) is supplied to the primary, provided the following values: N1 = 46 turns N2 = 219 turns V1 = 11 Volts

Physics for Scientists and Engineers: Foundations and Connections

1st Edition

ISBN:9781133939146

Author:Katz, Debora M.

Publisher:Katz, Debora M.

Chapter32: Faraday’s Law Of Induction

Section: Chapter Questions

Problem 52PQ

See similar textbooks

Similar questions

A 40-mH inductor is connected to a 60-Hz AC source whose voltage amplitude is 50 V. If an AC voltmeter is placed across the inductor, what does it read?
In the transformer shown in Figure P33.51, the load resistance RL is 50.0 . The turns ratio N1/N2 is 2.50, anti the rms source voltage is Vs = 80.0 V. If a voltmeter across the load resistance measures an rms voltage of 25.0 V, what is the source resistance Rs?
In an oscillating RLC circuit, R = 7.0 L. = 10 mH. And C = 3.0 F. Initially, the capacitor has a charge of 8.0 C and the current is zero. Calculate the charge on the capacitor (a) five cycles later and (b) 50 cycles later.
An AC generator with an rms emf of 15.0 V is connected in series with a 0.54-H inductor. The frequency of the source emf is 70.0 Hz. Draw a phasor diagram for this circuit, including the current, the potential difference across the inductor, and the source emf. Draw your diagram with the current phasor pointing toward the right along the horizontal axis.
An ac source of voltage amplitude 10 V delivers electric energy at a rate of 0.80 W when its current output is 2.5 A. What is the phase angle between the emf and the current?
An emf of 9.7 × 10-3 V is induced in a coil while the current in a nearby coil is decreasing at a rate of 2.7 A/s. What is the mutual inductance of the two coils?
The emf of an ac source is given by v(t)=V0sint, where V0=100V and =200 . Find an expression that represents the output current of the source if it is connected across (a) a 20-pF capacitor, (b) a 20-mH inductor, and (c) a 50 resistor.
Write an expression for the output voltage of an ac source that has an amplitude of 12 V and a frequency of 200 Hz.
An ideal transformer has N1 windings in the primary and N2 windings in its secondary. If you double only the number of secondary windings, by what factor does (a) the voltage amplitude in the secondary change, and (b) the effective resistance of the secondary circuit change?
Problem 17: When a P = 730 W ideal (lossless) transformer is operated at full power with an rms input current of I1 = 3.4 A, it produces an rms output voltage of V2 = 8.4 V. Part (a) What is the input voltage, in volts? V1 = ______ Part (b) What is the output current, in amperes? I2 = ______ Part (c) Calculate the ratio of primary to secondary turns. N1/N2 = ______
For Transformer winding1 N1=1000 turns, N2= 200 turns and V1=220 Volts, secondary resistance of 22 Ohms. What is the AC power of the transformer in units of VA?
Given an ideal transformer connected to a V1 = 260 V AC source supplying a V2 = 14 V on a device. What is the ration between the current of the AC source I1 and the current across the device I2, therefore what is I1:I2? Choices: A. 20:1 B. 1:1 C. 1:20 D. None