An open V-belt drive operates under the following conditions: coefficient of friction between belt and pulley of 0.1, tight side tension of 1500 N, angle of contact of 120°, and groove angle of 40°. Which of the following is the slack side tension of the belt drive? Group of answer choices 3370 N 810 N 670 N

An open V-belt drive operates under the following conditions: coefficient of friction between belt and pulley of 0.1, tight side tension of 1500 N, angle of contact of 120°, and groove angle of 40°. Which of the following is the slack side tension of the belt drive? Group of answer choices 3370 N 810 N 670 N

Automotive Technology: A Systems Approach (MindTap Course List)

6th Edition

ISBN:9781133612315

Author:Jack Erjavec, Rob Thompson

Publisher:Jack Erjavec, Rob Thompson

Chapter40: Drive Axles And Differentials

Section: Chapter Questions

Problem 5RQ: How are problems normally first noticed with the differential and drive axles?

See similar textbooks

Similar questions

b) Base on your analysis, why the value of Belt Drive with V-Belt is having a lower coefficientcompared to flat belt?
Question 04: Discuss the comparative study between chain and belt drives. How are they useful in the field of mechanical engineering, give some practical examples?
Note: If you don't know the solution please leave it but don't give me wrong solution. A flat open belt drive is used to transmit a power of 25kW from a motor shaft rotating at 950 rpm. The radius of the pulley of the motor shaft is 125mm while the radius of the puller of the driven shaft is 450mm. The center distance between the shafts is 2,250mm. the coefficient of friction is 0.25 and the density of the belt material is 950 kg/m^3. The belt width is 126 mm. The allowable stress is 2.6MPa. Determine the thickness of the belt.
Explain the "Slip" and "Creep" phenomena that occur in a belt drive.
... An open belt drive operates under the following condition: driving pulley of 84 in. in diameter, driven pulley of 48 in. in diameter, and speed of driving pulley 150 rpm. Which of the following is the velocity of the belt?Group of answer choices 2640 ft/min 5280 ft/min 3300 ft/min 4620 ft/min
40.a. The type of braking method useful only as a means of lowering loads isA. pluggingB. regenerative braking.C. magnetic braking.D. dynamic braking.40.b. When minimum space is an important requirement, the best type of mechanical connecting device forslow-speed conveyors is aA. gearmotor.B. speed reducer.C. coupling.D. flat belt
Section angle of V-belt in belt drive φ=40˚,In order to make good contact and increase friction, thepulley groove angle should be_____. A.Slightly greater than 40˚ B.Slightly less than 40˚C.Equal to 40˚ .D.Equal to 90˚ (please explain it too)
Select an appropriate clutch system to transmit power from the engine to the compressor of a car air conditioner. Justify your selection. And explain in detail the working principle of the type of clutch you select.
how does a belt drive's velocity ratio affect performance when some slip occurs between the belt and the two pulleys?
Explain the following by selecting appropriate examples. Explain the selection criteria for the following types of belts with suitable Flat belt V belt Circular With suitable numerical example justify in which of the following the length of the belt is longer. Crossed belt drive Open belt drive
What are the advantages and disadvantages of conical clutches compared with plate friction clutches?
A multi-plate clutch must transmit 11 kW of power without slipping at 1500 rev/min. The coefficient of friction is 0.3. The inner and outer radis are 30 and 85 mm respectively. The axial force applied to the plates is 780 N. Determine the number of plates required using.