An RC Circuit consists of a resistor and a capacitor. If the capacitor were charged to 10 volts and had a value of 10 microfarads, please calculate what resistance would result in a voltage of 3.7 volts in 20 seconds. ohms

An RC Circuit consists of a resistor and a capacitor. If the capacitor were charged to 10 volts and had a value of 10 microfarads, please calculate what resistance would result in a voltage of 3.7 volts in 20 seconds. ohms

College Physics

11th Edition

ISBN:9781305952300

Author:Raymond A. Serway, Chris Vuille

Publisher:Raymond A. Serway, Chris Vuille

Chapter18: Direct-Current Circuits

Section: Chapter Questions

Problem 10CQ: An uncharged series RC circuit is to be connected across a battery. For each of the following...

See similar textbooks

Related questions

Q: The voltage across a resistance R6 in the circuit of Figure is to be measured by a voltmeter…

A: Given that:- Electric circuit is given in the question.

Q: The RC charging circuit in a camera flash unit has a voltage source of 295 V and a capacitance of…

A: The voltage source is V=295 V. The capacitance is C=126μF=126×10-6 F

Q: 2. What is the output voltage that you would expect to observe across R, circuit of Figure below?…

A: SOlution: To find e output voltage that you would expect to observe across RL in the clamping…

Q: You need an RC combination for a digital timer that will allow a capacitor to charge to 75% of its…

Q: The figure shows a simple RC circuit consisting of a 100.0-V battery in series with a 10.0-μF…

A: Given: Vo=100vC=10.0μF=10*10-6 Ft=2.0 sV=37 V (voltage across capacitor)

Q: A source is connected in series to 3 identical resistors. If this setup of resistors dissipates a…

A: GivenThree identical resistors are connected in series.Power dissipates = 72 W

Q: 12. A circuit has 4 capacitors of equal capacitance Co 30 μF. What is the equivalent capacitance Ceq…

Q: In the circuit shown (a) find the charge on each capacitor; (b) voltage across each capacitor and…

A: Let the capacitances of the capacitors be C1, C2, and C3, the charge stored by the capacitors be Q1,…

Q: Determine the time constant and the maximum voltage across the capacitor (after long times) for the…

A: resistance of each resistor = 100 ohm Capacitance of each capacitor = 8 mF Voltage of the battery =…

Q: A circuit has a 21Ω resistor, a 895Ω resistor and a 104 resistor all connected in series with each…

A: If Resistances R1, R2, R3 connected in series then equivalent resistance of the circuit is Req=…

Q: Consider the RC circuit in figure. In the condition that the capacitor reaches its maximum charge,…

A: When capacitor is fully charged, current in the circuit becomes zero.

Q: 8. ht The following description of a circuit appears in your experimental laboratory manual. You are…

A: An ammeter is connected in series with the batteries.

Q: An RC circuit has an unknown resistance and an initially uncharged capacitor of 631 x 10-6 F. When…

A: Given data: The capacitance of the capacitor, C=631×10-6 F Time taken by the capacitor to charge to…

Q: A capacitor is charged to a potential of 12.0 V and then connected to a voltmeter having an internal…

A: Write the given values with the suitable variables. V0=12 VR=3.4 MΩ=3.4×106 Ωt=4 sV=3 V Here, V0, R,…

Q: The table below has information about different resistors in a simple circuit. What would the…

Q: The figure shows the circuit of a flashing lamp, like those attached to barrels at highway…

Q: Q1) If the capacitor in an RC circuit is replaced by two identical capacitors connected in series,…

Q: An RC Circuit consists of a resistor and a capacitor. If the capacitor were charged to 10 volts and…

A: Initially the capacitor was fully charged. Then it starts discharging.VC=V0e-tRCV0=10 VC=10×10-6…

Q: The battery with unknown EMF internal resistance r is supplying electrical power of 18 mw to a…

Q: As a capacitor is being charged in an RC circuit, the currentflowing through the resistor is(a)…

A: When a capacitor is being charged in the RC circuit, the current through the resistor can be given…

Q: A student connects two resistors with unknown resistance values in series, and notes that the…

A: Let, two resistances be P and Q RS = 805 =P+Q

Q: 01 You build a circuit with one resistor, R with a variable voltage source. and you obtained the…

Q: An electrical circuit contains a capacitor of 52 picofarads and a resistor of 1344 ohms. If the…

Q: An RC circuit have 9 V source and lies at 54 seconds of time constant. Then, find the voltage across…

A: Given data: The source voltage is V=9 V. The time constant is τ=54 s. The time taken is t=153.5 s.…

Q: A simple RC circuit consisting of a 10.0-µF capacitor in series with a resistor. Initially, the…

A: Given data according to question C = 10 t = 2s V = 37%V0 We have to calculate resistance

Q: A 10^-7 F capacitor (100 nanofarads) is charged to 50 V and then disconnected. One can model the…

A: Given value--- C = 10-7 F. V0 = 50 V. air resistance for cold day = 6 × 1013 ohm. air resistance…

Q: A simple RC circuit consisting of a 10.0-µF capacitor in series with a resistor. Initially, the…

A: GIVEN Capacitor = 10 μF The potential difference between plates = 100 V at t= 0 sec Potential…

Q: Engineering students at the University of Houston can take classes where they learn about the theory…

A: Given, Ohms law as V=IR where V is voltage R is resistance & I is current

Q: 2. Use a VIRP Table to analyze the following circuit if the battery has a voltage of 24 V R-50 Ohms…

Q: 10 MQ 5000 V I Tov 200 kQ Figure 1: Circuit diagram What is the voltage across the lower resistor in…

A: Given data: Two resistors are connected in series R1 = 10 MΩ = 10,000 kΩ R2 = 200 kΩ Battery…

Q: The RC charging circuit in a camera flash unit has a voltage source of 285 V and a capacitance of…

Q: A circuit contains a resistor in series with a capacitor, the series combination being connected…

Q: After the capacitor in an RC circuit had acquired charges, the battery was removed. As a result, the…

Q: The graph below depicts the voltage across the cell (or equally across the variable resistor) as the…

A: Given, Plot of V (voltage across the cell) and I current in the circuit. Variable resistance changes…

Q: An RC circuit has an unknown resistance and an initially uncharged capacitor of 515 x 10^-6 F. When…

A: Value of C = 515×10-6 Time t= 25.5s q=90% changed q=0.9q0

Q: An RC circuit with one resistor and one capacitor has a time constant of 1.5 seconds when the…

Q: A resistor with an unknown resistance is connected in parallel to an 11 Ω resistor. When both…

A: Resistance of known resistor: R2 = 11Ω Voltage of emf source: V = 17 V Current through unknown…

Q: A capacitor of capacitance 332 uF is charged with a source of 10 V. It is discharged through a…

A: The formula for the current passing through a resistor when the capacitor is discharging is:

Q: You connect five identical resistors in series to a battery whose EMF is 12.0 V and whose internal…

Q: For the circuit shown below. (M- mega - 100:u- micro -10) S1 1M Ohm Vs 20 V 4.7 uF The capacitor…

A: Voltage across the capacitor during Charging

Q: Q10. A given battery has a 12.00-V emf and an internal resistance of 0.100 Q. Calculate its terminal…

A: Given data: Emf ε=12.00 V Internal resistance r=0.100 Ω Load resistance R=10 Ω

Q: A small circuit consists öf The capacitor stores 23.7 mJ of energy after a Vut = 32.0 V battery has…

Q: A combination of three resistors r1, r2 and r3 in series is connected across a voltage source vT.…

A: Given Data: Resistance 1 →r1, Resistance 2 →r2 & Resistance 3 →r3 Configuration →Series Applied…

Q: A combination of three resistors R1,R2, and R3 in series is connected across a voltage source VT.…

Question

100%

An RC Circuit consists of a resistor and a
capacitor. If the capacitor were charged to
10 volts and had a value of 10 microfarads,
please calculate what resistance would result
in a voltage of 3.7 volts in 20 seconds.
ohms

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

This is a popular solution!

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Trending now

This is a popular solution!

Step by step

Solved in 2 steps with 2 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, physics and related others by exploring similar questions and additional content below.

Similar questions

Consider the circuit below. The battery has an emf of = 30.00 V and an internal resistance of r = 1,00 . (a) Find the equivalent resistance of the circuit and the current out of the battery. (b) Find the current through each resistor, (c) Find die potential drop across each resistor, (d) Find the power dissipated by each resistor, (e) Find the total power supplied by the batteries.
An uncharged series RC circuit is to be connected across a battery. For each of the following changes, determine whether the time for the capacitor to reach 90% of its final charge would increase, decrease, or remain unchanged. Indicate your answers with I, D, or U, respectively. (a) The RC time constant is doubled. (b) The battery voltage is doubled. (c) A second resistor is added in series with the original resistor.
A 1,00-?O voltmeter is placed in parallel with a 75.0kresistor in a circuit, (a) Draw a circuit diagram of the connection, (b) What is the resistance of the combination? If the voltage across the combination is kept the same as it was across the 75.0-kresistor alone, what is the percent increase in current? (d) If the current through the combination is kept the same as it was through the 75.0-kresistor alone, what is the percentage decrease in voltage? (e) Are the changes found in parts (c) and (d) significant? Discuss.
Consider the circuit shown in the preceding problem. Write equations for the power supplied by the voltage sources and the power dissipated by the resistors in terms
Why is the following situation impossible? A technician is testing a circuit that contains a resistance R. He realizes that a better design for the circuit would include a resistance 73R rather than R. He has three additional resistors, each with resistance R. By combining these additional resistors in a certain combination that is then placed in series with the original resistor, he achieves the desired resistance.
Digital medical thermometers determine temperature by measuring the resistance of a semiconductor device called a thermistor (which has a=0.06/C ) when it isat the same temperature as the patient. What is a patient’s temperature if the thermistor’s resistance at that temperature is 82.0% of its value at 37C (normal bodytemperature)?
An RC circuit takes t = 1.58 s to charge to 45% when a voltage of ΔV = 5.5 V is applied. If the circuit has a resistance of R = 1.5 Ω, what is its capacitance, in farads?
A flash unit for a camera has a capacitance of 1700 μF. What resistance is needed in this RC circuit if the flash is to charge to 90% of its full charge in 21 s?
An RC circuit has an unknown resistance and an initially uncharged capacitor of 631 x 10-6 F. When connected to a source potential, it takes the capacitor 27.6 s to become 80.1 % fully charged. What is the resistance of the circuit? Enter a number rounded to the nearest 100 place.
An RC circuit with one resistor and one capacitor has a time constant of 1.5 seconds when the resistor used has a resistance value of 20.0 kilo-Ohms. If another 40.0 kilo-Ohm resistor is placed in series with the first resistor to increase the effective resistance, what will be the time constant for the circuit?
A heart pacemaker is designed to operate at 72 beats/minusing a 6.5µF capacitor in a simple RC circuit. What value ofresistance should be used if the pacemaker is to fire (capacitor discharge) when the voltage reaches 75% of maximumand then drops to 0 V (72 times a minute)?
A capacitor with capacitance 10.8 μF in an RC circuit is initially charged up to a voltage of Vo = 17.8 V. The capacitor is then discharged using a resistor, whose resistance is 185 kΩ. During the discharging process, after how long will the capacitor be left with 15% of its maximum charge?