Ann is a construction worker, and she is preparing to have concrete poured at her construction site. Each corner is designed to be a 90° corner. Using a tape measure, she takes measurements from the corners, marks a point, and then measures diagonally between the points to see if the corner is 90°. Which of the following sets of measurements would indicate that the corner she measured is 90°? Select all that apply. O 6 feet, 8 feet, and 10 feet O 6 feet, 8 feet, and 12 feet O 9 feet, 12 feet, and 14 feet O 9 feet, 12 feet, and 15 feet O 12 feet, 16 feet, and 18 feet O 12 feet, 16 feet, and 22 feet

Ann is a construction worker, and she is preparing to have concrete poured at her construction site. Each corner is designed to be a 90° corner. Using a tape measure, she takes measurements from the corners, marks a point, and then measures diagonally between the points to see if the corner is 90°. Which of the following sets of measurements would indicate that the corner she measured is 90°? Select all that apply. O 6 feet, 8 feet, and 10 feet O 6 feet, 8 feet, and 12 feet O 9 feet, 12 feet, and 14 feet O 9 feet, 12 feet, and 15 feet O 12 feet, 16 feet, and 18 feet O 12 feet, 16 feet, and 22 feet

Mathematics For Machine Technology

8th Edition

ISBN:9781337798310

Author:Peterson, John.

Publisher:Peterson, John.

Chapter12: Multiplication Of Decimal Fractions

Section: Chapter Questions

Problem 13A: The length, L, of the point on any standard 118° included angle drill, as shown in Figure 12-5, can...

See similar textbooks

Similar questions

Use the angle values given to find 2. a. If 1 = 37, find 2. b. If 1 = 29, find 1.
Determine the values of 1 through 10.
The length, L, of the point on any standard 118° included angle drill, as shown in Figure 12-5, can be calculated using the formula L=0.3 O where represents the diameter of the drill. Determine the lengths of the following drill points with the given diameters. Round to 3 decimal places for inches and 1 decimal place for millimeters. a. 12 b. 14 c. 38 d. 10 mm e. 25 mm f. 45 mm
Given:Owithtangentlandm1=46 Find:m2, m3,m4,m5
Determine the values of 2,3, and 4 for these given values of 1. a. 1=32 2 4 3 b. 1=3519 2 4 3
If the angle of elevation to the sun is 74.3 when a flagpole casts a shadow of 22.5 feet, what is the height of the flagpole? a. 63.2 feet b. 79.5 feet c. 83.1 feet d. 80.0 feet
The length, L, of the point on any standard 82° included angle drill can be calculated using the formula L = 0.575 , where represents the diameter of the drill. Determine the lengths of the following drill points with the given diameters. Round to 3 decimal places for inches and 1 decimal place for millimeters. a. 12 b. 14 c. 38 d. 10 mm e. 25 mm f. 45 mm
Determine the sizes of Aand Bto the nearest minute.