ANSWER THIS QUESTIONS 1a. What is the number of components for the formulation: "Beeswax + Glycerin + Methyl paraben"?  CHOICES:  A. ONE, B.ZERO, C.TRHEE, D. TWO  1b. Present your working formula for the formulation: "Beeswax + Glycerin

Q: What percent of X can be extracted with 100 mL hexane?  b) What will be the percent X remaining in…

A: The question is based on the concept of solvent extraction. we have to calculate amount extracted…

Q: Use the items to construct a flow chart for the procedure used to create a saturated borax solution…

A: The blanks in the given procedure is filled as follows,

Q: How would the following errors change the calculated value of the percent oxalic acid in the…

A:

Q: How much 1.0 M sodium bicarbonate solution (in mL) is needed to stoichiometrically react with 25 mL…

A: Molarity of sodium bicarbonate solution = 1.0 M Volume of acetic acid solution = 25 mL Concentration…

Q: (Topic: Gravimetry multi-component analysis) The calcium and magnesium in a urine sample were…

A: Solution - Principle of gravimetry   The principle of this type of analysis is that once an…

Q: If given the option between using a P1000 and a P200 pipetter to dispense 200 uL, the P200 should be…

A: P1000 pipette measure between 200μl to 1000μl  And P200 pipette measure upto 200μl

Q: On the Excel spreadsheet (available in the Lab folder on HuskyCT), enter the mass of KNO3 used and…

A: Trial number 1 2 3 4 Total volume of water, mL   14 16.5 19 21.5 Total volume of…

Q: he separation and purification processes given below and the method used against them are given.…

A: The different products that can be extracted from a given compound can be of varying nature and…

Q: Esall 0/50/ved its Volume (4L) His focusfooing Nagl from sodiumchloride it was related 3. by a daing…

A: Calculating the molarity of a diluted solution by using an equation given by dilution law: M1V1=M2V2…

Q: In a similar experiment, the mass of 3 PB tablets was measured to be 3.1177 g. The tablets were…

A:

Q: wo salts A and B are dissolved in water. At the temperature of the experiment, the solubility of A…

A:

Q: 2.1g of sample are dissolved in methylene chloride and the sample is extracted with  aqueous…

A: Given, weight of the sample = 2.1g Isolated weight of compound, ethyl-p-aminobenzoate = 0.8g…

Q: Sources of Error Determine the relationship between the observed/apparent value (EX) VERSUS that of…

A: Given: Not all the solid was transferred during the filtration of the precipitate.

Q: How was the precipitate obtained after filtration?   By scraping from the filter paper and…

A: Filtration is used to separate an insoluble solid from a pure liquid or a solution

Q: 3. What is the name of the indicator used in the Vinegar analysis experiment? 4. Why is it important…

A: The indicator is a chemical substance which indicates the end point. and percent error represent the…

Q: For the Ksp determination, the stoichiometric endpoint should not be passed. If an experiment…

A: Solubility is the property of solute in the given solution to be dissolved in the solvent and it…

Q: Direction:A. Create a complete workflow process of producing a Liquid Dosage Form through…

A: There are many types of liquid dosage form-syrup,emulsion, suspension.

Q: Method of separation/chemical reaction (with brief process) of 1.5 kgs cream of tartar and 2.5 kg…

A: Unrefined substance SOURCING  (1). Source (regular/Synthetic) of unrefined substance :- 1)cream of…

Q: Vitamin C Analysis, a student accidentally puts 1.0 g of sodium bicarbonate (NaHCO3) solid into the…

A: The sodium bicarbonate (NaHCO3) solid is a base which neutralises the acid in the reaction. Hence it…

Q: An inexperienced graduate student moved into a laboratory and began work. He needed some diethyl…

A: (a)

Q: What should be done if the percent recovery is greater than 100%? Should the recrystallization…

A: The maximum percent recovery one can get is 100%. If one is getting more than that it's means there…

Q: 1-A bottle of Na2EDTA.2H2O is labeled with an assay of 100.5%, what is this implied? What is the…

A: Purity of substance- Pure substances are those which are made up of only one type of atoms or…

Q: What would the theroetical yield be of a oil sythesis? The exact quantites are below. Note:…

A:

Q: profile-image Time remaining: 00 : 09 : 27 Chemistry A group was given the responsibility of…

A: Solutions- The solubility of three different solvents are given in g/100ml solvent

Q: A stock salt solution is prepared by dissolving 5.69 g of table salt in water and diluting the…

A:

Q: Predict the products, and balance the equation Remember to include "1" where expected. When writing…

A: The solution is as follows :

Q: Calculate the gravimetric factor of: FeO in Fe2O3 Bi2S3 in BaSO4 BaSO4 in (NH4)2SO4…

A: Gravimetric factor is conversion of gm Of compound into gram of single element. It is the ratio of…

Q: Determine the percentage Fe in a sample of limonite from the following data:  -Sample : 0.5000g…

A: Percentage composition simply it means amount of element present relative to total amount of…

Q: Provide the balanced reaction for this experiment?     a piece of weigh paper (or weigh boat) and…

A: The balanced chemical reaction between KHP and NaOH is given below as,

Q: explain importance of Gravimetric Analysis when it comes to operation/s of each procedure/method?…

A: Gravimetric analysis is a process or method to determine the quantity of analyte on the basis of…

Q: the injector is kept at higher temperature than the column so that it will move quickly. If the…

A: A multiple choice question based on analytical separations that is to be accomplished.

Q: BaSO4 BaSO4 in (NH4)2SO4

A: This question is related to gravimetric analysis.

Q: - Also, identify the best solvent for molecular weight determination. g. Note that the density for…

A: Polylactic acid  is thermoplastic  polyester   and  obtained by the condensation of  Lactic  acid…

Q: QUESTION 21 Can the MRecovery of a sample come larger than 100, if the analysis is carried under the…

A: If the % recovery of a sample is larger than 100% that doesn’t mean that the recovery process is…

Q: xample of the dilution of Drink #1 to give you a visual idea of this dilution step Some volume was…

A:

Q: Attached below is the chemical reaction of sulfation. If 1.5 g of ZnS is roasted, what is the…

A: To solve this problem we have to calculate the percentage yield of ZnSO4

Q: When working with starch indicator is not one of the things to be considered? A. The indicator…

A: Starch is used as an indicator in redox titrations. It is used for the detection of the presence of…

Q: Discuss the a) direct method of weighing     b) indirect weighing using the analytical balance.

A: Since you have asked multiple question we will solve the first question for you. If you want any…

Q: Given the following situation, choose the best course of action: measuring 5.0 g of volatile 99%…

A:

Q: NPCI2) 2(NSCI) reflux Ru(PMeg)4ME2 Me2GeArH reflux Na, toluene

A: product of the following reactions given below;

Q: 1. If the temperature probe was mis-calibrated by +0.10 ˚C during both experimental procedure Part A…

A: 1. If the temperature probe was mis-calibrated during both experimental procedure , the reported…

Q: or each item, explain in one (1) sentence why the step is done in the gravimetric analysis of…

A:

Q: When you calculate the percentage composition of the product mixture, exactly what kind of…

A: The objective of the question is to clarify the doubt regarding the calculation of the percentage…

Q: Take the 1/100 dilution factor into consideration Molarity (M) will open the doors for you to get to…

A:

Q: If this is the procedure that we used to adapt a new reaction, what is the mass, molecular weiht,…

A: Amount of 2-chloro-5-nitrophenol added = 2.75 g           Molar mass of 2-chloro-5-nitrophenol…

Q: What is the conversion of 0.50 ft³ to in³?

A: What is the conversion of 0.50 ft3 to In3 ?

Q: Please help me there are multiple parts, double check your answer as previous tutors got it wrong.

A: The given illustration is the procedures for the preparation of borax solution.

Q: Organic Synthesis Preparation of Aspirin Data and Calculations: - Theoretical yield = = 6.52 g -…

A: Answer

Q: An aqueous of 2.0dm3 contains 53.0g Na2CO3 Calculate in a) gdm-3 b) moldm-3

A:

Q: If you have 6.61 g of caffeine dissolved in 72.3 mL of water and the extraction coefficient between…

A: The extraction coefficient can be described as the ratio of the concentration of the substance in…

Mass Spectrometry

This process is an instrumental method in which a sample is changed to fast moving positive ions by electron bombardment. The charged particles vary due to their different mass to charge ratio and are estimated with the help of this difference. It is also called mass spectroscopy.