As shown, a circular conducting loop (with 4 turns and of resistance R= 8.8 0) is placed in a uniform magnetic field directed normal to the plane of the loop, of magnitude Bo = 1.4 T. The radius of the loop varies with time according to the formula r(t) = a + bt The magnitude of the current (in mA) induced in the loop at t= 11 s is: (Take a = 0.14 m, and b = 0.02 ms-). Bo r(t)

As shown, a circular conducting loop (with 4 turns and of resistance R= 8.8 0) is placed in a uniform magnetic field directed normal to the plane of the loop, of magnitude Bo = 1.4 T. The radius of the loop varies with time according to the formula r(t) = a + bt The magnitude of the current (in mA) induced in the loop at t= 11 s is: (Take a = 0.14 m, and b = 0.02 ms-). Bo r(t)

Principles of Physics: A Calculus-Based Text

5th Edition

ISBN:9781133104261

Author:Raymond A. Serway, John W. Jewett

Publisher:Raymond A. Serway, John W. Jewett

Chapter23: Faraday’s Law And Inductance

Section: Chapter Questions

Problem 1P

See similar textbooks

Similar questions

The magnetic flux through a metal ring varies with time t according to (B = at3 bt2, where (B is in webers, a = 6.00 s3, b = 18.0 s2, and t is in seconds. The resistance of the ring is 3.00 . For the interval from t = 0 to t = 2.00 s, determine the maximum current induced in the ring.
The conducting rod shown in the accompanying figure moves along parallel metal rails that are 25-cm apart. The system is in a uniform magnetic field of strength 0.75 T, which is directed into the page. The resistances of the rod and the rails are negligible, but the section PQ has a resistance of 0.25 . (a) What is the emf (including its sense) induced in the rod when it is moving to tire right with a speed of 5.0 m/s? (b) What force is required to keep the rod moving at this speed? (c) What is the rate at which work is done by this force? (d) What is the power dissipated in the resistor?
A single-turn circular loop of wire of radius 50 mm lies in a plane perpendicular to a spatially uniform magnetic field. During a 0.10-s time interval, the magnitude of the field Increases uniformly from 200 to 300 mT. (a) Determine the emf Induced in the ioop. (b) If the magnetic field is directed out of the page, what is the direction of the cun-ent induced in the loop?
A long solenoid of radius a with n turns per unit length is carrying a tune-dependent current I(t)=I0sintwhere I0 and are constants. The solenoid is surrounded by a wire of resistance R that has two circular loops of radius b with b>a. Find the magnitude and direction of current induced m the outer loops at tune t=0.
Two frictionless conducting rails separated by l = 55.0 cm are connected through a 2.00- resistor, and the circuit is completed by a bar that is free to slide on the rails (Fig. P32.71). A uniform magnetic field of 5.00 T directed out of the page permeates the region, a. What is the magnitude of the force Fp that must be applied so that the bar moves with a constant speed of 1.25 m/s to the right? b. What is the rate at which energy is dissipated through the 2.00- resistor in the circuit?
A square loop with side length L, mass M, and resistance R lies in the xy plane. A magnetic field B = B0(y/L) k is present in the region of the space near the loop. Determine the magnitude and direction of the induced current in the loop as the loop starts moving at velocity v = B0(y/L) j.
A 50-turn coil has a diameter of 15 cm. The coil is placed in a spatially uniform magnetic field of magnitude 0.50 T so that the face of the coil and the magnetic field are perpendicular. Find the magnitude of the emf induced in the coil if the magnetic field is reduced to zero uniformly in (a) 0.10 s, (b) 1.0 s, and (c) 60 s.
Two long, parallel wires cy equal currents in opposite directions. The radius of each wire is a, and the distance between the centers of the wires is d, Show that if the magnetic flux within the wires themselves can be ignored, the self-inductance of a length 1 of such a pair of wires is L 0 l in d1 a (Hint Calculate the magnetic flux through a rectangle of length 1 between the wires and then use L=N/I
In a 250-turn automobile alternator, the magnetic flux in each turn is B, = 2.50 104 cos t, where is in webers, is the angular speed of the alternator, and t is in seconds. The alternator is geared to rotate three times for each engine revolution. When the engine is running at an angular speed of 1.00 103 rev/min, determine (a) the induced emf in the alternator as a function of time and (b) the maximum emf in the alternator.
A wire of length 1.0 m is wound into a single-turn planar loop. The loop carries a current of 5.0 A, and it is placed in a uniform magnetic field of strength 0.25 T. (a) What is the maximum torque that the loop will experience if it is square? (b) If it is circular? (c) At what angle relative to B would die normal to the circular coil have to be oriented so that the torque on it would be the same as the maximum torque on the square coil?
Design a current loop that, when rotated in a uniform magnetic field of strength 0.10 T, will produce an emf =0 sin t. where 0=110V and 0=110V .
Suppose that a rectangular toroid has 2000 windings and a self-inductance of 0.040 H. If h = 0.10 m, what is the current flowing through a rectangular toroid when the energy in its magnetic field is 2.0 × 10-6 J?