NewsG TranslateO .äiäil| äljähJl äzob Quadratic Equation..O Afkarf FacebookMy Citation list 12/..As shown, the region between the two plate conductors iscompletely filled with silicon (p = 640 Q.m). If X= 1 cm, Y = 20 cm,and Z= 2 cm, and a potential difference of 14.4 V is applied betweenthe top and the bottom surfaces, the current (in mA) passesbetween the top and bottom surfaces is:SiY0 4O 5O 11

Given data: Resistivity of silicon (ρ) = 640 Ωm X = 1 cm = 0.01 m Y = 20 cm = 0.20 m Z = 2 cm = 0.02…

As shown, the region between the two plate conductors is completely filled with silicon (p = 640 Q.m). If X=1 cm, Y = 20 cm, %3D %3D and Z= 2 cm, and a potential difference of 14.4 V is applied between the top and the bottom surfaces, the current (in mA) passes between the top and bottom surfaces is: V Si – Y 0 4 0 7 0 5 0 9 O 11

As shown, the region between the two plate conductors is completely filled with silicon (p = 640 Q.m). If X=1 cm, Y = 20 cm, %3D %3D and Z= 2 cm, and a potential difference of 14.4 V is applied between the top and the bottom surfaces, the current (in mA) passes between the top and bottom surfaces is: V Si – Y 0 4 0 7 0 5 0 9 O 11

College Physics

10th Edition

ISBN:9781285737027

Author:Raymond A. Serway, Chris Vuille

Publisher:Raymond A. Serway, Chris Vuille

Chapter17: Current And Resistance

Section: Chapter Questions

Problem 12P: Germanium is a semiconducting metal with a resistivity of 0.460 m. (a) Determine the current per...

See similar textbooks

Similar questions

discuss how current flows in n type and p type semi-conductors
A wire of length 1 km, has a conductance of 0.6 mho. What is theconductance of the same wire which is 3 km long?
What would the Hall voltage be (in µV) if a 2.40 T field is applied across a 13-gauge copper wire (1.829 mm in diameter) carrying a 22.0 A current? (Assume the free charge density of copper is 8.342 ✕ 1028 e−/m3.)
Let's say you have a 20 cm long silicon wire, with a diameter of 4 cm. What current flows through this wire if a 1000 V potential difference is applied to the two ends? Please enter your answer in the unit of mA. You can use 2300 Ohm.m for the resistivity of silicon.
During the 3.7 min a 6.0 A current is set up in a wire, how many (a) coulombs and (b) electrons pass through any cross section of the wire's width?
During the 5.05 min a 4.84 A current is set up in a wire, how many coulombs pass through any cross section across the wire's width and figure out how many electrons pass through any cross section across the wire's width??
What is the average velocity in a current wire of d=10mm (carry a current of 1A),Assume that each atom contributes 2F electrons. Given molar mass of cu =64g/mol, density is 9g/cm^3.
What would the Hall voltage be if a 2.00-T field is applied across a 10-gauge copper wire (2.588 mm in diameter) carrying a 20.0-A current?
A copper wire of 3.2 mm in diameter and 4 m length carries a certain amount of current. The conductionelectron density in copper is 8.49x1028 electrons/m3. A 75.0-Ω resistor is connected with the copper wireto the terminals of a battery whose emf is 11.0 V and whose internal resistance is 0.8 Ω. Calculate (a) thecurrent in the circuit, (b) the current density in the wire, (c) the terminal voltage of the battery, Vab, and (d)the power dissipated in the resistor R, (e) the power dissipated in the battery’s internal resistance r, (f) the resistivity of the wire, (g) the drift velocity of the free electrons, and (h) Estimate the rms speed ofelectrons assuming they behave like an ideal gas at 20°C. Assume that one electron per Cu atom is free tomove (the others remain bound to the atom).
how does current flows in p type and n type semi-conductors?
A rectangular block of copper has sides of length 10. cm, 20. cm,and 40. cm. If the block is connected to a 6.0 - V source acrosstwo of its opposite faces, what are (a) the maximum currentand (b) the minimum current the block can carry?
The current in a conductorvaries in time as shown inFigure P17.60. (a) How manycoulombs of charge passthrough a cross section of theconductor in the interval fromt = 0 to t = 5.0 s? (b) Whatconstant current would transportthe same total chargeduring the 5.0 - s interval asdoes the actual current?