Answered: aser emits light of frequency…

aser emits light of frequency 851523504007150 Hz. What is the wavelength of the light in nm? Round your answer to 3 significant figures

Welding: Principles and Applications (MindTap Course List)

8th Edition

ISBN:9781305494695

Author:Larry Jeffus

Publisher:Larry Jeffus

Chapter26: Welding Metallurgy

Section: Chapter Questions

Problem 7R

See similar textbooks

Related questions

Q: 2. A simply supported beam is shown below. Do the following. a) Draw the equivalent load diagram. b)...

Q: - The bucket of a 'bobcat" is lifted and tilted by means of hydraulic cylinders EL and HJ Figure P4-...

Q: . Water having a kinematic viscosity v = 0.0000013m2/s flows in a 50mm diameter pipe at a veiocity o...

Q: What is the density of air in standard atmosphere at 38, 200 ft in SI.

Q: 11. Two bodies of weight 40 N and 20 N are connected to the two ends of a light inextensible string,...

A: given; →weight(w1)=20N→weight(w2)=40N→coefficient of friction(μ)=0.28→lets take tension in string =T...

Q: Problem 2/75 2/76 The device shown is a part of an automobile seat- back-release mechanism. The part...

Q: Question 2 A mass of 5 kg is supported on two springs, the stiffness of the springs being 2000 N/m ...

Q: Steam which is at a pressure of 3 Bar ond dry saturoreu expands in a convergent nozzie to s pressure...

A: A nozzle is a vent that is attached to the end of a hose or pipe and is used to control the flow of ...

Q: linder, four-stroke, spark-ignition engine working on the ideal Otto cycle draws in air at 14 psia a...

A: Express the compression ratio for the given Otto cycle as,r=v1v2Here, the compression ratio is r, sp...

Q: A rigid (constant volume) balloon is inflated at sea level, then submerged underwater, doubling the ...

A: A rigid balloon is inflated and submerged underwater and the pressure is doubled. From the gas const...

Q: The 45° strain rosette is mounted on a surface of the bracket as shown in Figure Q1. The bracket is ...

A: Esteel=120 GPaμ=.28 εa=100+60×10-6 εb=-200×10-6εc=-180×10-6 θa=0° ,θb=45°,θc=90°

Q: Which of the following mixtures of air is heaviest: 1) 50% dry air only 2) 2% water vapor + 98% dr...

A: Question:- Which of the following mixtures of air is heaviest? Options Available:- 1) 50% dry air ...

Q: A simple Rankine cycle works between the boiler pressure of 4 MPa and condenser pressure of 3 kPa. T...

Q: prizontal spring-mass-damper system with m = 100 kg, k = 3000 N/m, and c = 200 m is given an initial...

Q: It is desired to bring about a certain change in the state of a system by performing work on the sys...

A: By first law of thermodynamics we can write under adiabatic conditions. dU=δW Since the work done is...

Q: An Actual Rankine cycle operates on a boiler and condenser pressure of 2MPa and 20kPa respectively. ...

Q: am is rotating with c Gu

Q: ding mome

Q: Explain the life cycle assessment methodology

A: Life cycle assessment : Life cycle assessment it is define as it is the factual analysis which is as...

Q: A tennis ball is projected upward with a velocity of 120 m/s. Neglecting air resistance, how long wi...

Q: by m+r=2j

A: As per honour code we will answer the first question since exact one was not specified . Please subm...

Q: a material can absorb radiation, what aerospace material property is demonstrated

A: Radiation heat transfer is a process in which heat waves are released and then absorbed, reflecte...

Q: An Actual Rankine cycle operates on a boiler and condenser pressure of 2MPa and 20kPa respectively. ...

A: GIVEN DATA - A RANKINE CYCLE GIVEN WE HAVE TO FIND ALL GIVEN POINT

Q: Differentiate brittle and ductile materials in terms of degree of plastic deformation. What is effec...

Q: OTTO CYCLE At the start of an air-standard Otto cycle's compression process, P1 = 1 bar, T1 = 300 K...

Q: In a palm oil processing plant, the crude oil is heated using hot water from a furnace. The furnace ...

A: Heat exchangers are devices that allow heat to be transferred between two fluids via a separating wa...

Q: Q1.5 (v6q9-52, Diesel) An ideal cycle has a compression ratio of 18 and a cutoff ratio of 1.5. Deter...

A: Write the expression of cut-off ratio to calculate the maximum temperature. α=T3T11rγ-1

Q: The beam ham m=10kg and L=2m, it is moving with a velocity shown on the drawing, v=0,1 m/s. Find kin...

A: When the angle α is equal to zero , the beam will be on the floor.

Q: D. 0.250" D, = 0.125" L-6.250" If Cutting speed v=211 FPM (feet per minute) and f= 0.0018 in/rev; Fi...

A: Cutting speed v=211 ft/minor v=211×12 =2532 in/minf=.0018 in/revD0=.250''Df=.125''L=6.250''

Q: For a certain engine having an average speed of 1600 rpm a flywheel approximated as a solid disc, is...

Q: ... Hamstring 20cm Weight of lower leg + foot =4.5kg The weight of the lower leg and foot combined i...

A: Find the value of force in the hamstring

Q: age compressor delivers 0.23 kg/s of air. The suction pressure and temperature are 100 kPaa and 27˚C...

A: we have to determine the work doe by the compressor , we can assume perfect intercooling.

Q: a.) Determine the maximum normal stress developed in the bar when it is subjected to a tension of P ...

Q: sample are shown below in Figure 2. :- P. 50 mm L-150 cm w-100 mm Front View Side View Figure 2: Dim...

A: Given data : The value of axial force P=80 KN The width of rectangular section w=100 mm The depth of...

Q: WHAT ARE THE DIFFERENT PROPERTIES OF LIQUIDS? WHAT IS CRYSTAL STRUCTURE?

A: GIVEN DATA - TWO QUESTION GIVEN WE HAVE TO ANSWER IT

Q: Use rotation about the fixed frame to calculate the transformation matrix for a rotation of 30° abou...

A: Determine: Transformation matrix for a rotation of 300 about z0 axis and then 450 about x0 axis. Sol...

Q: Figure 3 shows a brake pedal assembly from a car. Under the action of an applied foot force, the ped...

A: i) Free body diagram of the pedal lever and reaction forces The free body diagram of the pedal lever...

Q: A 150 min x a mnm x 20 mm stecl plate is subjected a pull of 150 kN along its central axis as show i...

Q: If whieel A is rotating with an angular velocity of A14 rad/s, a0.21 m. b-0.13 m, d-o.78 m, and 031,...

Q: A water container is kept on a weighing balance. Water from a tap is falling vertically into the con...

A: Given:Volume flow rate of water=Q,velocity of water=U,total mass(container+water)=m,

Q: knife follower motion interval described below: 1. To raise the valve through 50 mm during 120° rota...

Q: 1. Ethane, initially at 35 kPa with a volume of 0.12 m³, is compressed frictionlessly in a cylinder ...

Q: A tensile testing machine operates using two lead screws. Both lead screws have a square thread prof...

A: Square threads are a popular screw thread form found in high-load applications like leadscrews and j...

Q: Determine Poisson's ratio for a cast iron that has a modulus of E= 12× 106 psi and a shear modulus G...

A: Given data : The value of modulus of elasticity=12×106 psi The value of shear modulus=4.8×106 psi ...

Q: Two jeepneys J1 and J2 are travelling along a straight road next to one another at the same directio...

Q: tained from in etable.

Q: When checking the exhaust system, the Certified Inspector must reject the vehicle if: It does not h...

A: While checking the exhaust system the inspector must reject the vehicle if it has no muffler, exhaus...

Q: a) Figure Q4 (a) shows an L-bracket ABC with diameter d which lies in the horizontal plane. It is ma...

Q: n a composite slab, the temperature at the interface (Tinter ) between two materials is equal to the...

A: Given: A composite slab

Q: A cam drive is used for a mechanism that packs stuffing into shipping boxes. The cam follower must r...

Concept explainers

The Space Lattice and Unit Cells

Every matter consists of atoms, molecules, and ions. If these atoms, molecules, and ions (micro-particles) are represented in a three-dimensional space-occupying certain specific points in space, then these arrangements are termed as space lattices and the specific points which are being occupied by atoms, molecules and ions are termed as lattice points. The atoms, molecules, and ions at the lattice points are generally grouped in a regular fashion and repeat periodically at the three-dimensional space.

Question

A laser emits light of frequency 851523504007150 Hz. What is the wavelength of the light in nm? Round your answer to 3 significant figures.

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step by step

Solved in 2 steps

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Principal Metallic Crystal Structures and Crystal Structure Analysis

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, mechanical-engineering and related others by exploring similar questions and additional content below.

Similar questions

Name the imperfection of crystals when an impurity atom substitutes an original atom.
What do you mean by characteristic x rays?
When compression is generated in the crystal lattice, it is because a substitutional atom entered it A) Of the same element but with a larger atomic radiusB) Of another element but with a smaller atomic radiusC) Of the same element but with a smaller atomic radiusD) From another element but with a larger atomic radius
The attached photo shows the Young’s modulus of a cubic single crystal as a function of orientation. where a1 a2 and a3 are the direction cosines between the direction hkl and [100], [010], and [001], respectively. For a certain crystal, E111 = 500 GPa and E100 = 90 GPa. Calculate Young’s modulus for this single crystal in the <110> direction
d)Please explain how to distinguish the types of defects that can be detected using X-Rays and AMI.
12) The imperfections of crystals do not depend upon a. Deformation of the solid b. coordination number c. Rapid cooling from high temperature d. High energy radiation striking the solid
What is the distort element?
At room temperature, crystal structures for cooper is of which type? Question 29 options: Body‑centered cubic (BCC) Hexagonal close‑packed (HCP) Hexagonal open‑packed (HOP) Face‑centered cubic (FCC)
Which of the following describes a bucky ball? a. plastic explosives nanoparticle b.. a carbon molecule (C60) c. a quantum dots d. a concrete nanoparticle with a comprehensive strength of 20 nanonewton
Which of the following have the same periodicity as the crystal lattice: a) electron wave function, b) electron distribution probability, c) lattice potential
A typical person can detect light with a minimum intensity of 4.0 x10-11 W/m2. For light of this intensity and λ = 550 nm, how many photons enter the eye each second if the pupil is open wide with a diameter of 9.0 mm?
Suppose NASA sent a robotic craft to explore the deep oceans of Jupiter’s moon, Europa (assume the ocean water has an index of refraction 1.34) . In an attempt to be discrete, NASA applies a coating to the submarine-like craft, to make it indetectable to any creatures in the ocean who can see light with a wavelength of 1200nm. The coating material has anindex of refraction of 1.25.a) Draw a clear physics diagram of the problem.b) Technology only allows for coatings to be 1 micrometer or thicker. What is the thinnest coating that can be applied to the craft to make it invisible at 1200nm.