Assuming that the density of silica gel is 2.65 g cm-3 and that the silica particle are spherical with an average radius of 5 x 10-6 cm, calculate the estimated surface area Sest. Why is there such a large difference between S and Sest?

Assuming that the density of silica gel is 2.65 g cm-3 and that the silica particle are spherical with an average radius of 5 x 10-6 cm, calculate the estimated surface area Sest. Why is there such a large difference between S and Sest?

Fundamentals Of Analytical Chemistry

9th Edition

ISBN:9781285640686

Author:Skoog

Publisher:Skoog

Chapter32: Gas Chromatography

Section: Chapter Questions

Problem 32.17QAP

See similar textbooks

Related questions

Q: A 531.1 g sample of ammonia releases 777.1 joules of heat. The specific heat capacity of ammonia is…

A: Here we are required to find the change in the temperature when certain mass of ammonia releases…

Q: during the experiment of esterification of isopentyla acetate, in the process how is the adding of…

A: Ans : If you add saturated NaCl to organic layer, saturated NaCl will pull the water from organic…

Q: Do QUESTION b (ii) early as possible I upvote

Q: 2. Two emissions of light were observed. One emission (A) was at 410 nm and the other (B) was at 690…

Q: Consider the electrolysis of a mixture of molten AIB33 and MgBr2. Identify the half- reaction…

Q: What is the equilibrium-constant expression of the basic dissociation of NaNO2? Kb =…

Q: Q6. Predict the major producet(s) of the following reactions. Show stereochemistry where applicable.…

A: a. E1 elimination. b. sn2 reaction. 3. sn2 reaction. 4. Allylic bromination.

Q: complexes do not favour B-elimination reaction. Explain citing example.

A: Ti4+ complexes do not favour β-elimination reaction because

Q: Based on the ternary phase diagram, a binary mixture of furfural and water will always split into…

Q: The molar volumes of water and ice at 0 oC and 1 atm are 18.02 and 19.65 cm3 mol-1, respectively,…

A: Given: Molar volume of water = 18.02 cm3 mol-1 Molar volume of ice = 19.65 cm3 mol-1 Enthalpy of…

Q: 13.65 g of an unknown compound decreased the freezing point of 346 g of benzene (Kf= 5.12 C /m) by…

A: Given, mass of unknown compound = 13.65 g mass of solvent benzene = 346 g = 0.346 Kg Freezing point…

Q: Which of the following phase diagrams corresponds to a system wherein the upper critical temperature…

A: The phase diagram corresponds to a system wherein the upper critical temperature is less the boiling…

Q: Initial Post: For your initial post, describe how you personally experience acid/base chemistry in…

Q: Do QUESTION (b) (i) early as possible I upvote

Q: Which of the following does not belong to the group? aluminum tray marble…

Q: Based on the schematic diagram below, which compound is represented by AB? AB compound NH,NO3 ANO3…

A: Given that, a compound AB. We have to determine the compound AB.

Q: 7. Calculate AG° for the following galvanic cell Zn(s) | Zn²*(aq) || Fo2*(aq) IFe(s) given these…

A: The standard electrode potential of a Galvanic cell is given by the formula E° = E°(cathode) -…

Q: How is pH and pOH calculated?

A: pH describes the potential of H+ in a solution. pH is calculated using the following equation…

Q: What is the maximum wavelength of light capable of removing an electron from a hydrogen atom in the…

A: Maximum wavelength means minimum energy...

Q: Principal ingredient of an antacid is Al(OH)3 (76.98). The concentration of 0.00400 M Al(OH)3…

A: Given, Molarity of Al(OH)3 = 0.00400 M

Q: The osmotic pressure of an aqueous solution at 309 K is 120 kPa. Calculate the freezing point of the…

A: For aqueous solution , freezing point is given as : Freezing point of solution = Freezing point of…

Q: An air-standard Diesel cycle has a compression ratio of 18 and a cut-off ratio of 2.5. The state at…

Q: 2.Describe four different ways in which the enthalpy change associated with the following chemical…

A: The reaction can be given as HNO3(aq)+ KOH (aq) →KNO3(aq)+ H2O And the reaction generated 53.4…

Q: Which of the following was used in excess in the gravimetric method of analysis experiment? BaCl,…

A: The correct answer about gravimetric analysis is given below

Q: The reaction described by the equation 0,(g) + NO(g) 0,(g) + NO,(g) has, at 310 K, the rate law rate…

Q: 1. (a) Determine the valence electron counts on the transition metals. Find out the formal oxidation…

Q: For the reaction, N2 (g) + O2 (g) ↔ 2 NO (g). If O2 is removed, the concentration of N2 will…

A: The given equilibrium reaction is: N2 (g) + O2 (g) ⇌ 2 NO (g) Given the equilibrium is disturbed by…

Q: 7,(0) Compound X has the following percentage composition by mass: C: 38.9% ; H: 5.4% ; Cl: 38.4%;…

A: “Since you have posted a question with multiple sub-parts, we will solve first three sub-parts for…

Q: Identify the type of reaction for the conversion of trans-1-chloro-2-methylcyclopentane to…

A: The reaction given is the conversion of trans-1-chloro-2-methylcyclopentane to 1-methylcyclopentene.…

Q: opose a reaction mechanism for the reaction below and use electronic fac plain why a racemic mixture…

Q: ll. Direction: Carefully read the following problems. Do the following : D. Determine the percentage…

A: Given the balanced Chemical equation - C7H6O3(s) + C4H6O3(l) ------> C9H8O4(s) + CH3COOH(l)…

Q: what is the primary solute and solvent of duralumin?

A: A solution is a homogenous mixture of two or more substances. The part of a solution that is present…

Q: 1.Vanadium crystallizes in a body-centered cubic lattice, and the length of the edge of a unit cell…

Q: Consider these reactions: Reaction 1: H2(g)+Cl2(g)⟶2HCl(g)ΔH=−184.6 kJ Reaction 2:…

A: Given : Reaction 1 H2(g)+Cl2(g)⟶2HCl(g) ΔH=−184.6 kJ To calculate :- Amount of Cl2 has…

Q: The following reaction is used in some self-contained breathing devices as a source of O2 (g). 4…

Q: Make 50 ml of the extraction buffer containing the following ingredients using the stock solution…

A: We need to make 50 mL of the extraction buffer.

Q: 279.28 mL of 1.22 M organic salt was mixed with 168.14 mL of Ethanol (d= 0.789 g/mL, MW…

A: Given, Volume of organic salt in mL (solute) = 279.28 mL Molarity of organic salt = 1.22 M Volume…

Q: Make oleic acid vesicles by making a solution of 0.5mL of 50mM oleic acid, 1 mM HPTS in 0.2 M…

A: Vesicles are formed by the rehydration of dry film of lipids. One of most common vesicles are fatty…

Q: What is the time needed for a constant current of 0.100 A to deposit 0.500 g of Tl (I) [AW= 204.38…

A: Given: Mass of Tl to be formed = 0.500 g. Current passed = 0.100 A And the ion present in the…

Q: element is oxidized and which is reduced?

Q: A В Ether Water- Which set up represent KD > 1 KD = 1 KD < 1

A: If the solute is more soluble in organic layer then KD>1 If the solute is more soluble in…

Q: A suzuki reaction using 4-methyl-phenyl boronic acid and 4nitrobromobenzene was ran and then…

A: In simple column chromatography, stationary phase is polar and mobile phase is non-polar. Polar…

Q: (b) Predict the product and chemistry involved in the following reactions: (i) [Rh(CO)2Cl2] +CH;I

Q: iodate is given below. What is the molar solubility, in g/L? Include units in your answer.…

A: Given, Molar mass = 664 g/mol Solubility equilibrium La(IO3)3 <----> La3+(aq.) + IO3-(aq.)…

Q: Draw the structural formula of the following compounds. 1) 1-ethyl-3-methylbenzene (What is the…

A: structural formula consists of symbols for the atoms connected by short lines that represent…

Q: A certain reaction has an activation energy of 52.53 kJ/mol. At what Kelvin temperature will the…

A: Given K2 = 5 K1

Q: A particular reactant decomposes with a half-life of 103 s when its initial concentration is 0.275…

Q: 71/2 0.032 kg mol1 (0.032 kg mol¯)(300 m s-1)2 ] exp -1 [27(8.3145 J K-1 mol)(300 K) 2(8.3145 J K-l…

Q: Draw the enantiomer and one diastereomer for each compound below: OH H H3C COOH ii) OHC CHO HO H. ぐ

A: The compounds given are,

Q: Using this heating curve, complete the following statements: freezing point between points | Select…

A: There are three phases of matter. The phase of matter can be interchanged by changing the…

Question

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step by step

Solved in 2 steps with 2 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, chemistry and related others by exploring similar questions and additional content below.

Similar questions

Do not give handwriting solution Using 0.901 g/cm3 for density of tri - isopropylsilanol (i-C3H7)3SiOH and assuming spherical shape of the molecule, determine its molecular cross section and the maximal grafting density for these molecules supported on a flat silica surface.
Using 0.901 g/cm3 for density of tri - isopropylsilanol (i-C3H7)3SiOH and assuming spherical shape of the molecule, determine its molecular cross section and the maximal grafting density for these molecules supported on a flat silica surface.
Why are units of energy per area (J/m²) used for surface ten-sion values?
Data on a single crystal of NiSO4⋅7H2O give χm = 6.00 × 10−8 m3 mol−1 at 298 K. Identify the effective number of unpaired electrons in this compound and compare your result with the theoretical value.
What is the Molecular geormetry for SiO32- ?
What are the main advantages and limitations of the Valencia Linkage Theory?
1) For a crystalline substance with a hexagonal unit cell, the distance interplanar d is given by the expression. Consider graphite, for which a = 0.247 nm and c = 0.679 nm. On a standardized diffractogram with Cu Kα radiation ((λ = 1.5418 Å)), where angle 2θ will be observed the Bragg 002 peak of graphite?
A solid sample Niobium is composed of 1.24x10^21 BCC unit cells. What is the volume of the solid smple (in cm^3) if Nb has an aromic radius of 143pm?
The radius of gyration of a three-dimensional partially rigid polymer of 1000 units each of length 150 pm was measured as 2.1 nm. What is the persistence length of the polymer?
By what percentage does the root-mean-square separation of the ends of a one-dimensional polymer chain consisting of 1000 monomers increase (+) or decrease (−) when the persistence length changes from l (the bond length) to 2.5 per cent of the contour length? What is the percentage change in volume of the coil?
This is the most common industrial process for preparing large-scale production of nanoparticles wherein a liquid or gas is fed into a furnace and the nanoparticles are recovered by air classification. a. sol-gel method b. sputtering c. pyrolysis d. laser ablation
Calculate the thermal expansion coefficient, α = (∂V/∂T)p/V, of diamond given that the (111) reflection shifts from 22.0403° to 21.9664° on heating a crystal from 100 K to 300 K and 154.0562 pm X-rays are used.