Assuming the capacitors in Figure 12-2 are non-polarized electrolytic capacitors, what is the maximum AC rms voltage that can safely be applied to the circuit? total capacitance 30 24 V 35 V O 100 V 10 W²=40 V² = 188 € uF 33 35 V 100 O 49.5 V Figure 12-2

Assuming the capacitors in Figure 12-2 are non-polarized electrolytic capacitors, what is the maximum AC rms voltage that can safely be applied to the circuit? total capacitance 30 24 V 35 V O 100 V 10 W²=40 V² = 188 € uF 33 35 V 100 O 49.5 V Figure 12-2

Delmar's Standard Textbook Of Electricity

7th Edition

ISBN:9781337900348

Author:Stephen L. Herman

Publisher:Stephen L. Herman

Chapter21: Resistive-capacitive Series Circuits

Section: Chapter Questions

Problem 6RQ: A 15-F AC capacitor is connected in series with a 50 resistor. The capacitor has a voltage rating...

See similar textbooks

Related questions

Q: 7. Find V. and the power dissipated in all the resistors. 60 V 12 2 ww V₂ 1292 692 ww 24 V

Q: Find the Thevenin equivalent circuit to the LHS of AB of the DC network in Figure Q2. From the…

Q: 10 10 μα R1 100 Ω | SNSPD L 100 nH R2 2ΜΩ S V 1. No photons have been incident on the detector for a…

Q: A three phase, 100 MVA, 25 kV generator has solidly grounded neutral. The positive, negative, and…

A: It is given that: VA=100 MVAVL=25 kVZ1=0.2 puZ2=0.2 puZ0=0.05 pu

Q: etermine the value of R. to ensure that the zener diode is conducting. Let Vz=3.5V @ Izr=10mA. Let…

Q: An ideal voltage divider consists of only R₁, R2, and the voltage source in series with each other.…

A: As we have given in the above question about the voltage divider and stray capacitance, here we have…

Q: An electrical lamp is rated 120 volts, 500 watts. If the voltage applied across the lamp is twice…

A: Let us suppose that the base voltage is equal to the rated voltage and the base power is equal to…

Q: Determine the Thevenin's and Norton's equivalent circuits of the following: 1. 3A (1 $5.2 100 N 62…

Q: The activation function in the example is assumed to be linear as f(x) = x. Repeat the example and…

A: We have to drawn update code functionthe given Activation Code function

Q: Using mesh analysis, determine the values of Vo, and io of the circuit from the Figure. Note: • use…

A: In this question, We need to determine the voltage Vo and current Io using mesh analysis. We…

Q: Suppose we know X(z) has two poles at p₁ = 0.8e and p2 = = 1, 22 = -1. zeros at 21 = (a) What is the…

Q: A source of e.m.f of 15 V supplies a current of 2 A for 6 minutes. How much energy is provided at…

Q: Determine the forward differences y₁ [n] and y2[n], respectively, of the signals and and x₁[n]: =…

Q: Example using f(x) = ao +Σ(an cos nx+b find the Fourier expansion of the periodic function shown…

Q: PROBLEM SOLVING 1. Determine R. and I of the circuit from Figure 1. For every step of…

A: As per Bartleby guideline we need to answer the first question only. Kindly repost the rest…

Q: 4. From the given circuit given below, solve for a. Total Resistance (5 points) b. Current in every…

Q: 100V 20 b 1302 2403 3002 30Ω www 1002 5002

A: Calculation of current I in the given circuit. Ra,Rb and Rc are making delta configuration convert…

Q: Given the circuit below, apply mesh-current analysis to determine the current I1 and I3 flowing in…

A: First apply KCL at node b and write the I2 in terms of I1 , I3. Apply KVL in the two loops and using…

Q: 2, Calculate Vx using transformation. 20L-90°v ՏՂ M Source 40 j130 NIE 32 J4n + 100 & Ux

Q: For a given DC motor, the speed depends upon flux only applied voltage alone back emf back emf and…

Q: 1. The time to failure in hours of an electronic component subjected to an accelerated life test is…

A: Answer-a I have created stem and leaf plot using R-programming. The R-code and the output if stem…

Q: A signal g(t) is produced by switching on a continuous-time signal v(t) for a limited time -0.5T ≤ t…

Q: (a) For the following network, derive an expression for the system reliability in terms of the…

Q: Find the resonant freq. (in rad/s) and in Hz of the following parallelcircuit: 20μF capacitor in…

A: Given data: The capacitance, C1=20×10-6 F The inductance, L=1×10-3 H The resistance, R=7 Ω

Q: 2, Calculate Vx using transformation, 20L-90°v +1 52 M using Source 4 √130 не 32 J4 + 100 Ux

Q: 6. Apply nodal analysis to solve for Vx. 24 Ο 10 Ω ΜΕ +1 άλλ 201 10.2V,

Q: An ideal transformer has a turns ratio of 8:1, and the primary current is 3 A when supplied at 240…

A: Turn ratio = 8:1 Primary current = 3 A Voltage = 240 V

Q: A three-phase star-connected alternator working at 1400 KVA, 50 Hz,2300 V, has an armature dc…

Q: 4. Find the IDFT of X[k] = [2, 4 + 4j, 14, 4 - 4j].

Q: A 0 0 0 0 1 1 तातात 1 1 A B Cin B O 0 1 1 0 0 1 1 XOR CIN 0 1 0 1 0 1 0 1 G XOR AND AND H I OR Full…

Q: An open loop control system results in -2t a response of ¤¯¤¹(sin5t+cos5t) for a unit impulse input.…

A: Given- Open loop control system response, Ft=e-2tsin5t+cos5t. Unit impulse input. To find- The DC…

Q: 3. Find the power of the 50 V source. ΤΩ www 40V ΤΩ ΘΩ www 4/5Ω 50V www 10Ω 40V

A: Given: Required: Find the power of the 50 Volts source.

Q: Find z transform for the given Discrete time signals below: a. x[n]=2sin(100n)u[n] b.…

Q: If a total of 35MHz bandwidth is allocated to a particular FDD cellular system which has 50KHz…

Q: Example: Find the Fourier coefficients of the periodic function whose definition in one period is

A: Given: fx=-k-π<x<0k0<x<π

Q: What will be the oscillator frequency of the Hartley oscillator if inductance L1, L2 are equal to…

A: We need to find out the frequency of oscillation for given oscillator .

Q: There are three temperature regions for our semiconductors, identify and briefly describe the…

A: The doping dependency of ionised impurity scattering must be taken into account before investigating…

Q: Blank Use the Norton equiplent circuit to determine the power dissipated by 50.2. олог 25.12 wwwww…

Q: (a) Find the node voltages v1, v2 and v3 in the circuit shown below. (b) Find the total power…

Q: Question No.17 If the OC test data on delta side of a three phase Y-A transformer is 66 kV, 11 A, 45…

A: Given: The open circuit test data on the delta side of a three-phase Y-∆transformer, Line voltage,…

Q: 50 V + 6Ω M 3 i 2 Ω Σ8Ω 4Ω Ds 5Α

Q: Find the Voltage output given the schematic diagram. show the formula R3 = 1k ohms resistor to…

Q: JF. Ст-

Q: In the circuit below, a constant voltage source of 8 V is applied at t = 0. Find all branch voltages…

Q: Q5. Design a Voltage-divider D-MOSFET circuit that produces a voltage gain of - 6. The following…

A: The required parameters can be calculated by using the DC analysis and AC analysis of the amplifier…

Q: Solve for the steady state error for input 5u(t). The function u(t) is the unit step

A: Given,

Q: 4. Find the per unit value for each component and draw the impedance diagram. Y Generator 10 kV 100…

Q: For the network,determine the voltages VI and V2 and the current I. RSS 100 R₂ 29 + 18V RS60V, R3602…

Q: To sketch the characteristic curve of the diode you need to vary voltages on diode and measure…

A: The diode will conduct only during the forward bias and it will not conduct during reverse bias. The…

Q: Consider the circuit from P2 in PS2, now connected to an external source as shown in figure 2. The…

A: Given that, Supply voltage VAC=Cos(Ωt+ϕ), Inductor and Capacitor are parallelly connected and…

Concept explainers

Capacitor

The capacitor is an element used to store electrical energy in the electrical field. A capacitor is a form of passive energy.

Question

Assuming the capacitors in Figure 12-2 are non-polarized electrolytic capacitors, what is
the maximum AC rms voltage that can safely be applied to the circuit?
total
capacitance
24 V
O 35 V
O 100 V
O 49.5 V
10V²=474²=186 €
uF
50
V
uF
35
Figure 12-2
33

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

This is a popular solution!

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Trending now

This is a popular solution!

Step by step

Solved in 2 steps with 1 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, electrical-engineering and related others by exploring similar questions and additional content below.

Similar questions

The circuit in Figure 24-2 is connected to a 120-V, 60-Hz line. The resistor has a resistance of 36 , the inductor has an inductive reactance of 40 , and the capacitor has a capacitive reactance of 50 . ET120VITZVAPFERIRR36PELILXL40VARsLLECICXC50VARsCC
The circuit in Figure 24-2 is connected to a 60-Hz line. The apparent power in the circuit is 48.106 VA. The resistor has a resistance of 12 . The inductor has an inductive reactance of 60 , and the capacitor has a capacitive reactance of 45 . ETITZVA48.106PFERIRR12PELILXL60VARsLLECICXC45VARsCC
Capacitive Circuits Fill in all the missing values. Refer to the formulas that follow. XC=12fCC=12fXCf=12CXc Capacitance XC Frequency 38 F 60 Hz 78.8 400 Hz 250 pF 4.5 k 234 F 10 kHZ 240 50 Hz 10 F 36.8 560 nF 2 MHz 15 k 60 Hz 75 nF 560 470 pF 200 kHz 6.8 k 400 Hz 34 F 450
A 15-F AC capacitor is connected in series with a 50 resistor. The capacitor has a voltage rating of 600 WVDC. The capacitor and resistor are connected to a 480-V, 60-Hz circuit. Is the voltage rating of the capacitor sufficient for this connection?
Assume the circuit shown in Figure 21-1 has an apparent power of 432 VA and a true power of 345.6 W. The capacitor has a capacitance of 15.8919 F, and the frequency is 60 Hz. Find the missing values. ET ER EC IT IR IC Z R XC VA432 P345.6W VARSC PF C15.8919F
A postage stamp mica capacitor has the following color marks starting at the upper left dot: yellow, violet, brown, green, no color, and blue. What are the capacitance value, tolerance, and voltage rating of this capacitor?
The circuit in Figure 24-2 is connected to a 1000-Hz line. The resistor has a current flow of 60 A, the inductor has a current flow of 150 A, and the capacitor has a current flow of 70 A. The circuit has a total impedance of 4.8 . ETITZ4.8VAPFERIR60ARPELIL150AXLVARsLLECIC150AXCVARsCC
In a pure capacitive circuit, does the current lead or lag the voltage?
A postage stamp capacitor has the following color marks starting at the upper-left dot: black, orange, orange, black, silver, and white. What are the capacitance value and tolerance of this capacitor?
Hi. In the circuit E = 230 V 50 Hz, sinusoidal AC voltage, R = 9 Ω and L = 0.9 How large should capacitor C be (in microfarades) for the maximum possible current to flow through the resistor? How to calculate C?
number 42 a,b,c what is the value of the total capacitive reactance in each circuit in figure 12-81 can you show the steps of these book- principles of electric circuits 10th edition
The capacitance and a resistance are connected in parallel. This combination is then placed in series with an inductance. Compute the impedance when f= 60 Hz, R = 136 Ω, L = 243 mH, and C = 29 μF Note: Box the final answer. Do not answer in polar form or rectangular form. Use amplitude (polar) like in the photo. If applicable, round off all answers to 5 decimal places.