At 90°C, if 51 g of potassium chloride are completely dissolved, the solution is considered to beSOLUBILITY CURVESKI140130120100NONO,KNO390.HCI,70NH CI60KCI5040NaciKCIO,302010O 10 20 30 40 50 do 70 80 9o 100TEMPERATURE °CA. supersaturatedB. saturatedC. uncoolGRAMS OF SOLUTE /100g H,0

Solubility curve represents the extent of respective solid that can be dissolved at given…

At 90°C, if 51 g of potassium chloride are completely dissolved, the solution is considered to be SOLUBILITY CURVES KI 140 130 120 I10 I 100 NONO KNO3 90. HCI, 70 NH CI NH, 60 KCI 50 40 Na CI 30 KCIO 20 10 10 20 30 40 50 do 70 80 90 100 TEMPERATURE °C O A. supersaturated B. saturated C. uncool GRAMS OF SOLUTE /100g HO

At 90°C, if 51 g of potassium chloride are completely dissolved, the solution is considered to be SOLUBILITY CURVES KI 140 130 120 I10 I 100 NONO KNO3 90. HCI, 70 NH CI NH, 60 KCI 50 40 Na CI 30 KCIO 20 10 10 20 30 40 50 do 70 80 90 100 TEMPERATURE °C O A. supersaturated B. saturated C. uncool GRAMS OF SOLUTE /100g HO

Introductory Chemistry For Today

8th Edition

ISBN:9781285644561

Author:Seager

Publisher:Seager

Chapter7: Solutions And Colloids

Section: Chapter Questions

Problem 7.26E

See similar textbooks

Similar questions

Graph Table 14.10 shows solubility data that was collectedin an experiment. Plot a graph of the molarity ofKI versus temperature. What is the solubility of KI at55°C?
A solution is made by dissolving 0.455 g of PbBr2 in 100 g of H2O at 50C. Based on the data in Table 8-1, should this solution be characterized as a. saturated or unsaturated b. dilute or concentrated
Classify each of the following solutions as saturated, unsaturated, or supersaturated based on the following observations. a. Agitation of the solution produces a large amount of solid crystals. b. H eating the solution causes excess undissolved solute present to dissolve. c. Excess undissolved solute is present at the bottom of the solution container. d. The amount of solute dissolved is less than the maximum amount that could dissolve under the conditions at which the solution exists.
Distinguish between dispersion methods and condensation methods for preparing colloidal systems.
You make a saturated solution of NaCl at 25 C. No solid is present in the beaker holding the solution. What can be done to increase the amount of dissolved NaCl in this solution? (See Figure 13.11.) (a) Add more solid NaCl. (b) Raise the temperature of the solution. (c) Raise the temperature of the solution, and add some NaCl. (d) Lower the temperature of the solution, and add some NaCl. Figure 13.11 The temperature dependence of the solubility of some ionic compounds in wafer. The solubility of most ionic compounds increases with increasing temperature This is illustrated using NH4CI (ports b and c).
A patient has a “cholesterol count” of 214. Like manyblood-chemistry measurements,this result is measured inunits of milligrams per deciliter (mgdL1). Determine the molar concentration of cholesterol inthis patient’s blood, taking the molar mass of cholesterolto be 386.64gmol1. Estimate the molality of cholesterol in the patient’sblood. If 214 is a typical cholesterol reading among men inthe United States, determine the volume of such bloodrequired to furnish 8.10 g of cholesterol.
Refer to Figure 13.10 ( Sec. 13-4b) to answer these questions. (a) Does a saturated solution occur when 65.0 g LiCl is present in 100 g H2O at 40 C? Explain your answer. (b) Consider a solution that contains 95.0 g LiCl in 100 g H2O at 40 C. Is the solution unsaturated, saturated, or supersaturated? Explain your answer. (c) Consider a solution that contains 50. g Li2SO4 in 200. g H2O at 50 C. Is this solution unsaturated, saturated, or supersaturated? Explain your answer. Figure 13.10 Solubility of ionic compounds versus temperature.
The following table lists the concentrations of the principal ions in seawater: (a) Calculate the freezing point of seawater. (b) Calculate the osmotic pressure of seawater at 25 C. What is the minimum pressure needed to purify seawater by reverse osmosis?