Answered: At some point, it can be get Eutectic…

Science

Chemistry

At some point, it can be get Eutectic point on two compounds (A and B) in the phase diagram?

Physical Chemistry

2nd Edition

ISBN:9781133958437

Author:Ball, David W. (david Warren), BAER, Tomas

Publisher:Ball, David W. (david Warren), BAER, Tomas

Chapter7: Equilibria In Multiple-component Systems

Section: Chapter Questions

Problem 7.34E

See similar textbooks

Related questions

Q: A. Could the solution represented by this phase diagram be water? Explain why or why not. B. If i…

A: Since you have posted questions with multiple sub-parts, we are entitled to answer the first 3 only.…

Q: The solution prepared by dissolving 6.06 g of triphenyl methane [(C,H5)CH] in 1000 g of benzene,…

A: Given : Mass of solute i.e triphenyl methane = 6.06 g Mass of solvent i.e Benzene = 1000 g = 1 Kg…

Q: Describe a binary eutectic diagram and show all phase regions with all the relevant information for…

A: The binary eutectic phase diagram explains the chemical behavior of two immiscible (unmixable)…

Q: Two liquids, A and B, show partial miscibility below 52.4 °C. The critical concentration at the…

A: It is given that A and B show partial miscibility below 52.4oC. The critical concentration of A in…

Q: If acetone is miscible with both water and xylene, then why can’t all three form a clear single…

A: "Like dissolves Like" which means polar solute dissolves in polar solvents and non- polar solute…

Q: The molality of an aqueous solution of sugar (CMO is 175m. Calculate the mole fractions of sugar and…

A: Since you have asked multiple question, we will solve the first question for you. If you want any…

Q: If 124.4 mL of water is shaken with oxygen gas at 0.81atm, it will dissolve 0.0036 g O2. Estimate…

A: Given : Mass of O2 dissolved = 0.0036 g Volume of water used = 124.4 mL And pressure of oxygen gas =…

Q: For a general solvent, which enthalpy terms in the thermochemical solution cycle are combined to…

Q: Describe the molal boiling point-elevation constant for the solvent?

A: We a non volatile solute is added to the solution to a pure solvent then there is an eleviation in…

Q: Explain on a particle basis why the vapor pressure of a solution is lower than a pure solvent

A: Colligative properties Properties that depend on the number of particles present, not on the…

Q: The lattice enthalpy of KCI is positive, indicating that it takes energy to break the ions apart in…

A: The dissolution of ionic compounds is exothermic process because the ionic compound is a stable…

Q: Describe the ideal condition/set-up for recrystallization of substances. What are the factors to…

A: A question about re-crystallization, which is to be accomplished.

Q: Why does it conduct more before and after this minimum point?

A: A question based on electrochemistry, which is to be accomplished.

Q: Two important aspects of the solution process are the natural tendency of particles to mix and the…

A: Solutions are the mixtures in which the components are mixed uniformly with no visible boundaries.…

Q: The point on a phase diagram is where three phases of matter exist in equilibrium. The point is…

A: Given:

Q: 17. Compute for the boiling point of the solution at 20°C. A - 100.08°C B - 103.25°C C-100.81°C 18.…

A: Since you have posted a question with multiple sub-parts, we will solve first three sub-parts for…

Q: Which concentration unit is used when calculating colligative properties relating to the boiling…

A: Solution boiling point (solvent+non volatile solute )higher than pure solvent ΔTb= Ts - To where…

Q: Describe how fractional distillation can better purify a mixture of liquids by discussing a liquid…

A: To achieve a desired degree of separation of a mixture of liquids, the general method involves…

Q: The vapor pressures of pure ethyl alcohol and pure isopropyl alcohol are 60.8 mmHg and 45.2 mmHg at…

Q: The solubility is 12.8g in 100mL of ethanol at 0 degrees C, and 46.4 g in 100mL of ethanol at 60…

A: Given, the solubility is 12.8g in 100mL of ethanol at 0 degrees C and 46.4 g in 100mL of ethanol at…

Q: Phase diagram is a graphical representation of the physical states of a substance under different…

A: While drawing phase diagram for a binary solution, we take mole fraction of the components on X-axis…

Q: Using a methanol-water mixture as a solvent, a supersaturated solution of sodium chloride and…

A: supersaturated solution are in metastable state, when maximum solute which can be dissolved in…

Q: Construct the hypothetical phase diagram for metals A and B between temperatures of 600°C and 1000°C…

A: Solution Phase diagram could be a graphical illustration of the physical states of a substance below…

Q: Explain why freezing point depression is observed when a non-volatile solute is dissolved in a…

A: Solution Freezing point of depression may be a colligative property of resolution. it's discovered…

Q: …………………………………………...: Inflame skin tissue on contact. ……………………………………….……..: ignite spontaneously in…

A: (1)____________: Inflame skin tissue on contact.(2)____________: ignite spontaneously in…

Q: An ideal recrystallization solvent should have a large gradient of solubility along with…

A: A question based on analytical separation that is to be accomplished.

Q: Derive expression for Raoult’s law when the solute is non-volatile.

A: According to Raoult's Law, the vapour pressure of a non-volatile solute is equal to the vapor…

Q: phase diagram of å mixture a

Q: 2. Calculate the boiling point elevation of an aqueous solution containing 36 grams of sucrose…

A: Given Mass of sucrose = 36 g Molar mass of sucrose = 342 g Mass of water = 250 g = 0.25 kg consatnt…

Q: An aqueous solution of 2 percent non-volatile solute exerts a pressure of 1.004 bar at the boiling…

A: Given, Vapor pressure of water = 1.013 barVapor pressure of solutions = 1.004 barPercentage of…

Q: Complete the following table for aqueous solutions of caffeine, C8H10O2N4.

A: NOTE: “Since you have posted a question with multiple sub-parts, we will solve first three subparts…

Q: The molal boiling point constant for water is 0.52C/m. At what temp will a mixture of 105.0g of NaCl…

A: Given data the molal boiling point constant for water, Kb = 0.52 0C/m Mass of NaCl (solute) = 105.0…

Q: Mars has an average atmospheric pressure of roughly 0.006 atm -- almost exactly the triple point of…

A: Trple point in phase diagram , represents the condition at which three phases of coexists in…

Q: Henry's law constant is 0.034 mol/kg bar and 0.00060 mol/kg bar for CO2 and N2 respectively at 25 C…

A: The solubility of a gas in a liquid is directly proportional to the partial pressure of the gas in…

Q: Is the variation of strong electrolytes and weak electrolytes the same with temperature? Please…

A: Answer - The variation of strong electrolytes and weak electrolytes is not same with temperature…

Q: What limitations are encountered in the apolication of sublimation as a general method of…

A: The limitations are encountered in the application of sublimation as a general method of…

Q: The freezing point depression equation tends to be used for nonvolatile solutes. Offer an…

A: Volatile means that solute which will evaporate aur change its state. Non volatile solute is which…

Q: State raoult's law for a non volatile solute in single volatile solvent?

A: The vapour pressure of a solution of a non-volatile solute is equal to the vapour pressure of the…

Q: Is molality or molarity temperature dependent? Explain your choice. Why is molality used when…

A: Molality: It is defined as that number of moles of solute present in kilogram of solvent. Molarity:…

Q: Find the freezing point (Tr) and boiling point (Tb) of a solution containing 4.0g sucrose…

A: Given : Weight of sucrose = 4.0 gm Weight of water = 500 gm

Q: The dispersed phase of a colloid can be a a. gas b. liquid c. solid d. more than one choice is…

A: We have to tell which option is correct

Q: One component of an ideal binary solution has a pure component vapor pressure equal to one-fourth…

A: The partial pressure is equivalent to the multiplication between the pure component vapour pressure…

Q: Calculate the freezing point depression for a 2molal solution in water.

A: Freezing point (Tf) - Temperature at which vapor pressure of solid exactly equals to vapor pressure…

Q: Determine the freezing point and boiling point of the solution. (Assume density of water = 1.00…

Q: type of solution where intermolecular forces for all the components in the mixture are all the same…

A: A type of solution where intermolecular forces for all the components in the mixture are all the…

Q: The solution prepared by dissolving 6.06 g of triphenyl methane [(C6H5)CH] in 1000 g of benzene,…

A: Given : Mass of solute i.e triphenyl methane = 6.06 g Mass of solvent i.e Benzene = 1000 g = 1 Kg…

Question

Explain Briefly

At some point, it can be get Eutectic point on two compounds (A and B) in
the phase diagram?

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

introduction

VIEW

explanation

VIEW

Step by step

Solved in 2 steps

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, chemistry and related others by exploring similar questions and additional content below.

Similar questions

7.18. The vapor pressures of pure liquid A and pure liquid B are and , respectively. Determine the vapor pressure of: (a) a solution composed of of liquid A and of liquid B (b) a solution composed of of liquid A and of liquid B
7.58. Do communities that use salt in the winter use enough to form the low-melting eutectic betweenand , or are they taking advantage of the freezing-point depression phenomenon in general? How can you tell?
A student dissolves 27.2g of aniline, C6H5NH2, in 1.20102g of water. At what temperatures will the solution freeze and boil? Aniline is used in the polyurethane manufacturing process. Materials made from polyurethane include foams as pictured, spandex, hardwood floor coatings, dolly wheels, and many other end products.
A mixture of toluene (bp110.8C) and water is steam distilled. Visual inspection of the distillate reveals that there is a greater volume of toluene than water present, yet water (bp100C) has the higher vapor pressure. Explain this observation.
The vapor pressure of isopropanol is 47.0mmHg at 25.0C. If 0.500mol of nonvolatile hexachlorobenzene were dissolved into 2.00mol of isopropanol, what is the vapor pressure of the solution?
Miscible liquids from homogeneous mixture when added together. is Toluene miscible with water or miscible With ethyl alcohol? Please i need a clear and simple answer to this question. Thanks
A solution that contains 3.86 g X in 150 g of ethyl acetate boils at 78.210C. What is the ,olecular weight of X? The normal boiling point of ethyl acetate is 77.060C and kb for ethyl acetate is +2.770C/m.
Describe a binary eutectic diagram and show all phase regions with all the relevant information for each.
State the standard (reference) concentration for substances in the following phases.
The solubility of benzoic acid in water is: 0.21g/ 10mL at 10°C 0.27g/ 10mL at 18°C 2.75g/ 10mL at 80°C 6.80g/ 10mL at 95°C. Heating benzoic acid in water until __________ then cooling to _________ leads to maximum yield of recrystallization
The boiling point of a 1.50 m (molal; moles solute/kg solvent) aqueous solutionof LiI would be expected to be
Compounds like sodium stearate, called “surfactants” ingeneral, can form structures known as micelles in water,once the solution concentration reaches the value knownas the critical micelle concentration (cmc). Micelles containdozens to hundreds of molecules. The cmc dependson the substance, the solvent, and the temperature. At and above the cmc, the properties of the solution varydrastically. (a) The turbidity (the amount of light scattering) of solutionsincreases dramatically at the cmc. Suggest an explanation.(b) The ionic conductivity of the solutiondramatically changes at the cmc. Suggest an explanation.(c) Chemists have developed fluorescent dyes that glowbrightly only when the dye molecules are in a hydrophobicenvironment. Predict how the intensity of such fluorescencewould relate to the concentration of sodium stearateas the sodium stearate concentration approaches and thenincreases past the cmc.