At what angle do you observe the 4th order maximum relative to the central maximum when 400 nm light is incident normally on two slits separated by 0.025 mm? Also, At what angle do you observe the 3rd order minimum? Set-up is the same as above and with a slit separation of 0.025 mm. Make sure to answer both parts of the question. Show all work.

At what angle do you observe the 4th order maximum relative to the central maximum when 400 nm light is incident normally on two slits separated by 0.025 mm? Also, At what angle do you observe the 3rd order minimum? Set-up is the same as above and with a slit separation of 0.025 mm. Make sure to answer both parts of the question. Show all work.

University Physics Volume 3

17th Edition

ISBN:9781938168185

Author:William Moebs, Jeff Sanny

Publisher:William Moebs, Jeff Sanny

Chapter4: Diffraction

Section: Chapter Questions

Problem 107AP: How far would you place a screen from the slit of the previous problem so that the second minimum is...

See similar textbooks

Similar questions

Shown below is the central part of the interference pattern for a pure wavelength of red light projected onto a double slit. The pattern is actually a combination of singleand double-slit interference. Note that the bright spots are evenly spaced. Is this a double- or single-slit characteristic? Note that some of the bright spots are dim on either side of the center. Is this a single- or double-slit characteristic? Which is smaller, the slit width or the separation between slits? Explain your responses.
Two slits of width 3 μm, each in an opaque material, are separated by a center-to-center distance of 7.5 μm. A monochromatic light of wavelength 400 nm is incident on the double-slit. One finds a combined interference and diffraction pattern on the screen. How many peaks of the interference will be observed in the central maximum of the diffraction pattern? Please show all the work! Thanks!
Suppose that the simulated light source was polychromatic, with both a red and a yellow component, as shown on the right. How easy would it be to identify the positions (yP ) of the separate red and yellow interference maxima? Can you think of a change in the appearance of the interference pattern of each individual wavelength that, were it to happen, would help to distinguish the red from the yellow peaks?
Solve the following: (show your complete solution) (a) At what angle is the first minimum for 550-nm light falling on a single slit of width 1.00 µm? (b) Will there be a second minimum?
The analysis of any two-point source interference pattern and a successful determination of wavelength demands an ability to sort through the measured information and equating the values with the symbols in Young's equation. Apply your understanding by interpreting the following statements and identifying the values of y, d, m and L. Finally, perform some conversions of the given information such that all information share the same unit. Consecutive bright bands on an interference pattern are 3.5 cm apart when the slide containing the slits is 10.0 m from the screen. The slit separation distance is 0.050 mm. y= ________ d=________ m=_______ L=________
A double slit interference patern is observd on a screen 1.0. behind two slits spaced 0.30mm apart. Ten bright frindges span adistance of 1.7cm. What is the wavelength of the llight? Please show full work, for a beginner physics student.. Thank you!
The analysis of any two-point source interference pattern and a successful determination of wavelength demands an ability to sort through the measured information and equating the values with the symbols in Young's equation. Apply your understanding by interpreting the following statements and identifying the values of y, d, m and L. Finally, perform some conversions of the given information such that all information share the same unit. If two slits 0.100 mm apart are separated from a screen by a distance of 300 mm, then the first-order minimum will be 1 cm from the central maximum. y= ________ d=________ m=_______ L=________
The analysis of any two-point source interference pattern and a successful determination of wavelength demands an ability to sort through the measured information and equating the values with the symbols in Young's equation. Apply your understanding by interpreting the following statements and identifying the values of y, d, m and L. Finally, perform some conversions of the given information such that all information share the same unit. Two slits that are 0.200 mm apart produce an interference pattern on a screen such that the central maximum and the 10th bright band are distanced by an amount equal to one-tenth the distance from the slits to the screen. y= ________ d=________ m=_______ L=________
During a super-cool experiment, an optical engineer wanted to decide on the best components to use for constructing an instrument. The engineer is requesting your help in finding the following importing information. What is the slit spacing of a diffraction grating that will be necessary so that 600-nm light will produce a first order principal maximum at 25.0° away from the centerline? Please explain your reasoning. If the distance between the grating and the screen is 5.00 m, what is the distance, on the screen, between the first order bright fringe and the third order bright fringe when the same 600-nm light source is used? Please explain your process.
The analysis of any two-point source interference pattern and a successful determination of wavelength demands an ability to sort through the measured information and equating the values with the symbols in Young's equation. Apply your understanding by interpreting the following statements and identifying the values of y, d, m and L. Finally, perform some conversions of the given information such that all information share the same unit. a. Two slits separated by 0.250 mm produces an interference pattern in which the fifth dark band is located 12.8 cm from the central antinode when the screen is placed a distance of 8.2 meters away. y= ________ d=________ m=_______ L=________
An intereference pattern is produced by light with a wavelength of 560 nm from a distant source incident on two identical parallel slits seperated by a distance (between centers) of 0.580 mm. (A) if the slits are very narrow what would be the angular position of the first order two slit intereference maxima? Express your answer in radians. (B) what would be the angular position of the second order two slit intereference maxima in this case?
Source S is placed inside a glass water tank, as shown below. The surface of the water is covered with oil. Two monochromatic coherent light rays 1 and 2, go through the path as shown in the figure. If the wavelength of light in water is λ = 400 nm and indices of refraction of oil, water, and glass are noil = 1.2, nwater = 1.33, nglass = 1.5 and a dark fringe appears at point P , what is x?