At what angle will light traveling in the air be completely polarized horizontally when reflected from glycerin?

Q: In the figure P1 = 100 g and W2=75g. If L3 = 30 cm and L4 = 15 cm, what is P2? %3D

A: To solve this question, we equate the torques due to the weights on either sides since the bar is ho...

Q: A challenge gaining prominence throughout the planet is the increased need for "green" or sustainabl...

A: Input power ( Pi ) = 1 MW = 1 * 10 6 W  Efficiency ( n ) = 0.278  Time in hour  ( t ) = 365 * 24 = 8...

Q: (i) Total resistance of the circuit. (ii) Total current flowing in the circuit. (iii) The p. d. acro...

A: From figure R2 and R3 are connected in parallel to each other Hence their effective resistance will ...

Q: A billiard player sends the cue ball toward a group of three balls that are initially at rest and in...

A:

Q: An electric motor lifts an elevator that weighs 9,013 N a distance of 8.3 m in 15.1 s. What is the p...

A:

Q: One half mole each of nitrogen, oxygen and carbon dioxide are mixed in enclosure of volume 5 litres ...

A:

Q: ball m= 0.15 kg. He applies an average force of 52 N. The ball had an initial velocity of 37.5 m/s t...

A: Givenm=0.15 kgF=52 NInitial velocity, u=37.5 m/sFinal velocity, v=43 m/s

Q: If a proton is moving in a circular motion at a rate 5 x 10 m/s in 5 µm: a. Solve the magnetic field...

A:

Q: A metal hoop lies on a horizontal table, free to rotate about a fixed vertical axis through its cent...

A: Given: The magnitude of the torque is 1.75x10-2 N.m. The time interval is 3 s.

Q: Of the following methods, which one can you use to directly calculate the peak altitude of the Sun i...

A: In this question we have to answer how we can calculate the peak altitude of the Sun in the sky. Ple...

Q: The resistance of a thin silver wire is 1.0 32 at 0°C. The wire is placed in a liquid bath and its r...

A: Resistance is a measure of the opposition to current flow in an electrical circuit. Here,we calculat...

Q: A capacitor is connected to the battery and fully charged, with charge Q on the plates and potential...

A:

Q: Find the angle between the two vectors À=2î+3 ĵ +& B=-4î+2ĵ–k

A:

Q: A uniform 34.0-kg beam of length { = 4.55 m is supported by a vertical rope located d = 1.20 m from ...

A: Mass of beam = 34 kg Length of beam = 4.55 m distance from left = 1.2 m  

Q: (1b). The Earth can be considered to be a perfect black body radiator at a temperature of 134°F. Rad...

A: Write the given data. T=134 °F=329.817 KR=6390 km=6390×103 m

Q: Two charges, Q1 and Q2 are placed along the horizontal line, as shown in the picture below. The char...

A:

Q: Two charges: Q1=8mC and and Q2=2.0mC are separated by 6 meters. Where should the third charge -3mC b...

A:

Q: A box is pulled 2.0 meters along a rough surface at constant velocity using 100 N force inclined at ...

A:

Q: A crate of mass 78 kg is pushed along a floor with a force of 30N for a distance of 9 m. Calculate t...

A: Given : m = 78 kg F = 30 N  d = 9 m  

Q: Q3: a) What is the angle between a wire carrying an 10 A current and the 2.75 T magnetic field it is...

A:

Q: A solenoid with 525 turns has a length of 5.50 cm and a cross-sectional area of 2.50 x 10 9 m2. Find...

A:

Q: An air-filled capacitor consists of two parallel plates, each with an area of 9.20 cm2 separated by ...

A:

Q: Start Earth Falling Mass 200 g Outer Radius 100 mm In the setting below, what is the resulting linea...

A: mg-T = ma ....(1) TR = (MR2/2)×a/R  T = Ma/2 ......(2)

Q: Two children of mass 25 kg and 26 kg sit balanced on a seesaw with the pivot point located at the ce...

A: Given Data:- Mass of the two children is m1=25 kg, m2=26 kg Distance of separation between the two c...

Q: a(m/s*) 12- >t(s) 12 11 a. Determine the velocity after 12 seconds. b. Distance traveled after 10 se...

A: Form 0 s to 8 s, the acceleration is given by  a = (12/8)t = 3t/2  a = dv/dt 3t/2 = dv/dt 1.5tdt = d...

Q: In Convective Heat Transfer the greater the motion of the the greater the heat transfer, in general,...

A: Convective heat transfer takes place in fluids due to density difference .

Q: To study torque experimentally, you apply a force to a beam. One end of the beam is attached to a pi...

A:

Q: What is the difference in wavelength between the incoming and scattered photon if the angle of scatt...

A: Write the given data. θ=45°

Q: How long does it take (in seconds) for light to travel from the Sun to Saturn if the Sun is roughly ...

A: The speed of an object is given by v = dt, where d = the distance travelled by the object t = time t...

Q: Provide a free body diagram showing object (box) skidding down the same incline (accelerating slight...

A:

Q: H.W 2: a-A person walking at (1 m/sec) hits his head on a steel beam Assume his head stops in (0.5 c...

A:

Q: (1a). Figure shows a copper rod AB being heated at one end. Explain how the heat transfers from A to...

A:

Q: A spring-mass system has a spring with k = 5500 N/cm and a mass of 5.75 kg. %3D Determine the natura...

A: Given data:  Spring constant (k) = 5500 N/cm Mass (m) = 5.75 kg Required: The natural frequency of t...

Q: 6. Using the right-hand rule, find the direction of the following: a. The force if the velocity is a...

A:

Q: (1b). The Earth can be considered to be a perfect black body radiator at a temperature of 134°F. Rad...

A:

Q: A 6.75-kg bowling ball moving at 9.1 m/s collides with a 0.95-kg bowling pin, which is scattered at ...

A:

Q: Part A (Eigure 1 cables. Because the celling is covered with intricat archt or a large concert hall ...

A:

Q: VP 5.22.1 Be sure to review Examples 5.20, 5.21, and 5.22 (Section 5.4) before attempting these prob...

A:

Q: If you hold your arm outstretched with your palm upward, the force to keep your arm from falling com...

A:

Q: A 15.0-block is attached to a very light horizontal spring of force constant 500.0 N/m and is restin...

A:

Q: Compute for the x-component of 39.9394-unit vector directed 296.5761 degrees with respect to the pos...

A:

Q: A gas follows the PV diagram in the figure below. Find the work done on the gas along the paths AB, ...

A:

Q: Start with a wire at rest freely hanging between two supports. Mark a point on it, start your movie...

A:

Q: Assignment for Chapter 3 1. A 2.50 kg box is pulled by a constant force of 16 N that is exerted at a...

A: Mass of box = 2.50 kg Force = 16 Nθ = 36.9odistance moved = 3 m coefficient of kinetic friction = 0....

Q: Table 3 - Resistivity of Different Materials Length of the wires: 0,240 m Cross Sectional Caleulate ...

A:

Q: A cylinder is fitted with a piston, beneath which is a spring, as in the drawing. The cylinder is op...

A:

Q: - The diagram below shows the initial charges and positions of three identical metal spheres, X, Y, ...

A: Given data:  Three identical metal spheres The charges on the spheres q1 = +2 μC q2 = +4 μC and q3 =...

Q: A magnetic needle of magnetic moment 6.7 x 10-2 Am2 and moment of inertia 7.5 x 10-6 kg m2 is perfor...

A:

Q: 1. In 1896 in Waco, Texas, William Crush of the "Katy" railroad parked two locomotives at opposite e...

A:

Q: An ultrasound wave bounces off a bone in a human body and back to the transducer in 3.1E-5 s. How fa...

A: In diagnostic ultrasound imaging ,the speed of the sound is assumed to be 1540 m/s .  

Interference of Light

The word "constructive" signifies addition in interference. Constructive interference occurs when the path of the waves that start from the slit differs by 1 entire wavelength or in the intervals of the same. Hence, the waves that are presented on the screen are in phase (crest to crest/trough to trough). The waves interfering constructively forms bright fringes on the screen.