B 1.5 m F -2 m D.

Q: The spring of the mechanism works under tension and at the same moment it exerts a tension force of…

A:

Q: Q.2) A person uses an exercise band with an elastic modulus (spring constant) of 35 lb/ft. They…

A:

Q: In a ship-unloading operation, a 3500-lb automobile is supported by a cable. A worker ties a rope to…

A: Draw the free body diagram at point A. Here, TAB is the tension in the cable AB and TAC is the…

Q: 7 نقاط Find the forces in cables (A and B) if the mass of the box is (10 kg) then * fine the mass of…

A: A free body diagram of a geometric representation of all the forces acting on a system. The weight…

Q: Calculate the tensions in cables AC and AB needed to hold the ball. Assume the ball mass В is 45 kg,…

A:

Q: A tractor becomes stuck in the mud, and the operator plans to use a truck positioned at point A to…

A: Consider the diagram shown below for the tractor and resolved tension forces.

Q: Find the force F on the bottom of the tank if : K=1.5 m , H= 6 m , D=5 m.

A:

Q: combine the two forces P and T, which act on the fixed structure at B into a single force R

A:

Q: 3- The refrigerator has a weight of 200 lb and a center of gravity at G. Determine the force…

A: Given data  weight=200 lb  μ=0.4N= Normal Reaction…

Q: Q2: The 80-lb block C rests on the uniform 15-lb bar AB. The cable connecting C to B passes over a…

A: The free body diagram of the block C is as follows: The force in the vertical direction is as…

Q: Practice Problem 3.4.7: The resultant of the three forces is the force R =-170j kN acting through…

A:

Q: ider body A which weighs 200 Ibs, while f = 0.50 under body B wnich weigh 0 lbs. Determine the angle…

A:

Q: F P a A

A:

Q: Q2 The 80-lb block C rests on the uniform 15-lb bar AB. The cable connecting C to B passes over a…

A: We need to find the force acting between block and bar

Q: Q3: The diagram shows the open bonnet of a car. The bonnet is held open at an angle of 60° to the…

A: Given data  weight of bonnet (W) = 25 N  length of bonnet (l) = 0.90 m location of CG (x) = 0.35 m…

Q: A fixed crane has a mass of 1000 kg and is used to lift a 2400 kg crate. It is held in place by a…

A: Given data:

Q: Practice Problem 3.4.7: The resultant of the three forces is the force R =-170j kN acting through…

A: Resultant of the force 1 is -P1j^ Resultant of the force 2 is -P2i^ Resultant of the force 3 is…

Q: 1.5 m 1.5 m The horizontal steel shaft has a mass of 480 kg and is suspended by a vertical cable…

A: There are three static equilibrium equations, horizontal force balance, vertical force balance, and…

Q: The three forces, each of magnitude F, are applied to the crate. Determine F so that the three…

A: Given The magnitude of three forces is equal to F. The resultant of three forces is R=400 lb The…

Q: 2. The resultant of the three cable forces pulling on A is vertical and equal to the weight, W, of…

A:

Q: Q2/ For the force (F), the rectangular components are Fx = -40 N, and Fy = 60N, respectively.…

A:

Q: 1. The ball D has a mass of (50D+12.5B) kg. If a force F = 100C + 25A N of is applied horizontally…

A:

Q: 3–39. The ball D has a mass of 20 kg. If a force of F= 100 N is applied horizontally to the ring at…

A:

Q: C 30 B 3 m

A:

Q: Calculate the force in member AG. 2 kN 2 m B 2 m 2 m D. 3 m 4 kN F E 8.00 kN (T) 8.00 kN (C) 8.94 kN…

A:

Q: Q2. The 80-lb block C rests on the uniform 15-lb bar AB. The cable connecting C to B passes over a…

A:

Q: SAMPLE PROBLEM 2/2 Combine the two forces P and T, which act on the fixed structure at B, into a…

A: sin60=BD6'BD=5.2'cos60=DC6'DC=3'tanα=BDAD=5.2'6'α=40.9o Cbreak T in components,x-…

Q: Q2) The lift sling is used to hoist a container having a mass of 500 kg.Determine the force in each…

A: Since force F supports entire weight: F=500g =500*9.81 F=4905 N Forces balance at…

Q: Given a system made of the force F, couple M and distributed loads defined by w1 and w2, find the…

A: To find :  The equivalent system at B  Given :  The Force is F=8 kN The moment is M=5 kN·m The…

Q: Practice Problem 3.4.7: The resultant of the three forces is the force R =-170j kN acting through…

A: Given: The Three force system is shown below:

Q: the resultant force of the three cable tensions that support the crate is r= 750j lb find t1 and t3…

A: Given data: The resultant force is r = 750j lb. The tension in third cable is T3 = 250 lb. The…

Q: Q) The mass of lamp is 20 kg and geometry is as shown. Find the force in each cable. C 30° B 45°

A:

Q: A heavy spool rests on the ground at point A and against the wall at point B. Find force F required…

A: Given that, Mass of the spool, m=100 kg,Radius of spool, ri=200 mm, and ro=460 mm,Coefficient of…

Q: Q2: The 80-lb block C rests on the uniform 15-1lb bar AB. The cable connecting C to B passes over a…

A:

Q: 3. Determine the force F required to hold the gate shut as shown in the illustration.

A:

Q: 6. Determine the force in each cable needed to support the flowerpot whose weight is 10ON とれ В 6 m 4…

A: The position vector is used to describe the location of a body. When it comes to characterising a…

Q: Q2: The 80-lb block C rests on the uniform 15-lb bar AB. The cable connecting C to B passes over a…

A:

Q: Two horizontal beams are used to balance the masses A, B, and C, as shown in the figure. Each beam…

A: Given data: Mass of block C, mC = 30 kg. Draw the diagram of the lower rod. Apply equilibrium…

Q: The gardener of question 4 wishes to transport a second 250-N bag of fertilizer at the same time as…

A: Given data Weight of second bag is 250 N She exerts 75 N on each arm Weight of wheel barrow is 60 N

Q: Painters A and B support themselves and the 1 0-kg uniform plank CD by pulling down on the two…

A:

Q: The supporting structure of the billboard is attached to the ground by a pin at B, and a roller at…

A: Given data: The weight of billboard and structure together is, W=1400 N. The mass of the weight is,…

Q: the man is holding up the 35-kg ladder ABC by pushing perpendicular to ladder. The total length of…

A: given data; mass of ladder (m)=35kglenth of ladder (AC)=6mmaximum force (F)=400NAB=2mangle(θ)=?

Q: a) Calculate the forces in cables AC and AB needed to hold the 20-kg ball D in equilibrium as shown…

A:

Q: The mass of the uniform bar AB is 40 kg. Calculate the couple C required for equilibrium if 04. a. e…

A:

Q: The resultant force of the three cable tensions that support the crate is R = 500j lb. Find T1 and…

A:

Q: The connection on point A is a ball and socket while on point C is a guided roller. Determine the…

A:

Q: For the truss shown; the force in DB is: 3 kN 2 m 2 m to D C 1.5 m B 3 kN Select one: O 3 kN O 6 KN…

A:

Q: Sample Problem 2/2: Combine the two forces P and T, which ac B, into a single equivalent force R. P…

A:

Power Transmission Elements

It is defined as the energy transfer from one location to another location. The energy will start moving from the energy generation source to the energy applied position to obtain the work output. From this method, a large amount of electric energy moves from the power station to various electrical substations.