b) A capacitor C is connected in series with a 40 Q resistor across a supply of frequency 60 Hz. A current of 3A flows and the circuit impedance is 50 N, Calculate: (i) the value of capacitance, C, (ii) the supply voltage, (iii) the phase angle between the supply voltage and current, (iv) the p.d. across the resistor, (v)

b) A capacitor C is connected in series with a 40 Q resistor across a supply of frequency 60 Hz. A current of 3A flows and the circuit impedance is 50 N, Calculate: (i) the value of capacitance, C, (ii) the supply voltage, (iii) the phase angle between the supply voltage and current, (iv) the p.d. across the resistor, (v)

Power System Analysis and Design (MindTap Course List)

6th Edition

ISBN:9781305632134

Author:J. Duncan Glover, Thomas Overbye, Mulukutla S. Sarma

Publisher:J. Duncan Glover, Thomas Overbye, Mulukutla S. Sarma

Chapter2: Fundamentals

Section: Chapter Questions

Problem 2.7P: Let a 100V sinusoidal source be connected to a series combination of a 3 resistor, an 8 inductor,...

See similar textbooks

Similar questions

The rms value of v(t)=Vmaxcos(t+) is given by a. Vmax b. Vmax/2 c. 2Vmax d. 2Vmax
Let a 100V sinusoidal source be connected to a series combination of a 3 resistor, an 8 inductor, and a 4 capacitor. (a) Draw the circuit diagram. (b) Compute the series impedance. (C) Determine the current I delivered by the source. Is the current lagging or leading the source voltage? What is the power factor of this circuit?
A resistor, an inductor, and a capacitor are connected in parallel to an ac source with voltage amplitude V and angular frequency v. Let the source voltage be given by v = Vcosvt. (a) Show that each of the instantaneous voltages vR, vL, and vC at any instant is equal to v and that i = iR + iL + iC, where i is the current through the source and iR, iL, and iC are the currents through the resistor, inductor, and capacitor, respectively. (b) What are the phases of iR, iL, and iC with respect to v? Use current phasors to represent i, iR, iL, and iC. In a phasor diagram, show the phases of these four currents with respect to v. (c) Use the phasor diagram of part (b) to show that the current amplitude I for the current i through the source is I = √(I2R) + (IC - IL)2 . (d) Show that the result of part (c) can be written as I = V/Z, with 1/Z = √ (1/R2) + [ωC - (1/ωL)]2.
A 200 V, 50 Hz a.c. supply is given to capacitance of 25 micro F. If the supply is given, write the formula for the curmate of the capacitor and find the RMS current of the capacitor.
Q.4Determine the current flowing in the capacitor(-j25ohm) and its direction as shown in Figure below. Assume the voltage source to have negligible impedance.
A 90 kHz sinusoidal voltage has zero phase angle and a maximum amplitude of 30 mV . When this voltage is applied across the terminals of a capacitor, the resulting steady-state current has a maximum amplitude of 629.60 μA . Pt A. What is the frequency of the current in radians per second? Pt B. What is the phase angle of the current? Pt C. What is the capacitive reactance of the capacitor?
A transmission line has a reactance of 1 Pu is operating at Vs = Vr = 1 Pu. The generator is connected at source end which is delivering 0.5 Pu of active power and the transmission line is compensated with a series capacitance of 0.5 Pu. Find the load angle with series capacitance compensation ?
the parallel connection of a resistor and a capacitor takes 0.6 A rms from a 120 V rms voltage source. Given the 0.7 leading power factor, find the resistance and capacitance at 400Hz.
Q5. For an exhibition project you are designing a circuit of signal processor which can be connected to 230V, 50 Hz supply have a 5.0 H inductor, 80 μ F capacitor and 40Ω resistor kept in series. How can you evaluate the rms current and average power delivered to the circuit? Based on your observation, evaluate the potential drop across capacitance and inductor. Comment about that r m s voltage found in this circuit is less than peak voltage? Justify it with your answer. If you remove the inductor and connect a bulb in series with a capacitor. What will happen to the brightness of bulb if it is connected to DC source and then to an AC source. Assess and find reason for your observations in each case.
Reduce to its simplest form using msop
a) What is the time domain expression for the current? b) If the load impendance is created by an inductor with value L=375 mH, find the phaser voltage Vx? c) If the load impendance is created by a capacitor with value C=16.7 uF, find the phaser voltage Vx?
Electrical Engineering --question 1-- Calculate the theoretical voltages across the resistor and inductor for 10 kHz and 60 kHz using the 680Ω theoretical resistance, 3.3 mH inductance, and 5-V source. Demonstrate the step-by-step process. Answer must be in Polar form. --question 2-- Calculate the theoretical voltages across the resistor and capacitor for 500 Hz and 1750 Hz using the 680Ω theoretical resistance, the observed capacitance, and the 5V source. Demonstrate the step-by-step process. Answer must be in Polar form.