or the given circuit sketch the Vout, Vin vs time in sec. B) For the given circuit sketch the Vul, Vin Vs time in sec.R+12 V1kVinVeut10 V12 VDiodes are IN402.

In the given circuit, for the positive cycle, diode D1 will work, since it is in forwarding bias for…

Answered: B) For the given circuit sketch the…

Science

Physics

B) For the given circuit sketch the Vul, Vin Vs time in sec. R +12 V 1k Vin Veut 10 V 12 V Diodes are IN402.

University Physics Volume 2

18th Edition

ISBN:9781938168161

Author:OpenStax

Publisher:OpenStax

Chapter14: Inductance

Section: Chapter Questions

Problem 20CQ: Discuss possible practical applications of RL circuits.

See similar textbooks

Related questions

Q: Let's say you have a 20 cm long silicon wire, with a diameter of 4 cm. What current flows through…

A: Write the given values with suitable variables. L=20 cm=0.2 mr=4 cm2=0.02 mV=1000 Vρ=2300 Ω.m Here,…

Q: I. A bar of intrinsic silicon having a cross section area of 3 x 10m² has an n= 1.5 x 1016m-30 If He…

A: SOlution: givent hat A = 3x10-4 m2 ni = 1.5x1016 m-3 µe = 0.14 m2/Vs µP = 0.05 m2/Vs

Q: During the 3.7 min a 6.0 A current is set up in a wire, how many (a) coulombs and (b) electrons pass…

A: (a) The amount of coulomb that passes through any cross section of the wire’s width is given by…

Q: Which logic gate best describes how the circuit below the functions, Given is a LED light emitting…

A: We know that, in order to make the LED glow, there must be current passing through the circuit.

Q: If a wire of radius a = 9.2 mm has got non-uniform current density J = Jo (1- (r/a)) where ris…

Q: TA wire A wire B se/2 Assume thot same voltage is applied Current density accras these for wines…

Q: If three cells of 1V, 1.5V, 2V are connected in parallel, then the total e.m.f will be:

A: it is to be noted that there is no definite, straight and simple formula for total emf of cells that…

Q: A metal object having a length (10m), cross section area (0.5 mm2), and resistance (0.52) is…

A: Thermal velocity is given by, Vth=3 KTmnWhere K is Bottzmann constant =1.38×10-23 m2kg…

Q: (b) A rod of Ge (Germanium) crystal weighing 350 g contains 30 mg of P (phosphorus). (i) What is the…

A: Given: The mass of rod is m=350 g. The mass of phosphorus is m'=30 mg. The additional doping is…

Q: I. The Ge sample (p-type) has been electric resistivity 0.3 2.cm at room temperature. Calculate the…

A: Given the Ge sample has electrical resistivity 0.3 Ohm.cm . The minority carriers concentration is…

Q: RI M- E R2 dwen: RI : 2kl D : Si D2: Si R= 1.3 kl Rg = 5.8 k h rR= 225kl R: 570 KL E - 12 V V…

A: Given: R1 = 2×103 ΩR2 = 1.3×103 ΩR3 = 5.8×103 ΩE = 12 VFor D1 rB = 3ΩrR = 225×103 ΩFor D2 rB = 4ΩrR…

Q: 14.0 4.0 N 6.0 N 10.0 V 2.0 2 Find the currents I,, 1,, and I, , and the potential difference Vbc…

A: Apply KCL at junction b. Apply KVL in loop befcb.

Q: has a rectangular cross-section (1x 4 um). A CuTUlm produces a voltage drop of (100 mV) across the…

A: Given L = 2.8mm A = 1*4 um I = 5 mA V = 100 mV So resistance R = V/I = 100/5 = 20 ohm We know…

Q: write the energy band diagram df P- ty pe and N-lype f Seml conductor.

A: In p-type semiconductor, the density of holes is greater than the density of electrons while in…

Q: What is the ohmmeter reading for cach configuration in Fig. 6.73?

Q: Ql: A conductive wire has a resistivity of (0.649x10-8(2.m):) at room temperature are (5.8x10-)…

A: Given : Conductivity of wire σ =0.649 x 10-8Ω-1m-1Electron densityη =5.8x1028…

Q: Q1: A conductive wire has a resistivity of (0.649×10-8(Q.m)') at room temperature are (5.8x10» )…

A: Given- Conductivity σ=0.649×10-8(Ω.m)-1So,Resistivity ρ=1σ=10.649×10-8=1.54×108Ω.m Conduction…

Q: 14.0 V 4.0 N 6.0 N 10.0 V 2.0 1 Find the currents I, I2, and I3 , and the potential difference Vbc…

A: Use KCL at node/junction b and write the equation as follows. Use KVL in loop befcb and write the…

Q: Re 14.4 V 11.4 V Rg 8 kohm 12 kohm 12 V 20 V le(mA) A !g-1.425 mA Vee(Volt) Answer the questions…

A: Dear student A transistor is a device which is made of 2 PN junction diodes. Transister is used to…

Q: The resistance (y Ohms) in a solid-state circuit varies according to the function y = (x- 4)e 2 +10,…

Q: Assume that the voltage of the battery is 9 V and that RR R the three esistors are identical What is…

Q: Conduc-Thor-s. Thor has two square prism conductors that are made of the same ohmic material and…

Q: I. The Ge sample (p-type) has been electric resistivity 0.3 2.cm at room temperature. Calculate the…

A: Here given the Ge sample has electrical resistivity 0.3 ohm.cm. The minority carrriers is 2.5 × 10¹³…

Q: By apphýng Kirchoff's Current Law ( KCL) at node 2, the currem through resistor Ra,i4 the voltage…

Q: dlodes withn forward drop voltage ot 0.7 V. If Vs = 150 Vrms and R = 8 KI2, the 1:1 Vout Vs RL %3D…

Q: A)he pn junction capacitance C is A) proportional to the charge space width B) not depend on the…

Q: a) If the electron concentration increase along the x-axis of a conductor as shown in equation…

Q: Vhat would the Hall voltage be (in pV) if a 2.20 T field is applied across a 12-gauge copper wire…

A: The hall voltage across a conductor is given by the following relation ε = Blv…

Q: Two vesistors w/ resistan ca of s.on ond 1o1 are in parallel attached to a battery with 12.00. lan…

Q: How do high- Tc superconductors become resistanceless at such high temperatures?

Q: A conductive wire has a conductivity of ( 0.649 x 10^-8) at room temperature are ( 5.8 x 1028)…

A: The mobility is μ=σne Here μ is mobility,σ is conductivity, n is electron density and e is…

Q: Assuming the practical model of the diode, what is the output waveform for the following circuit :

A: Diode will conduct when the diode is in forward bias. When diode conduct potential across the diode…

Q: What type of circuits shown in figure R R₁ ow www 1.0 ΚΩ +200 V 100 Ω +10 V Vin ov. A Vi ov -10 V…

A: We have four circuits given to us which are made by using diodes, resistors, capacitors and…

Q: The relaxation time τ is nearly independent of applied E field whereas it changes significantly with…

A: Relaxation time is the time interval between two successive collisions of the electrons.

Q: •1 During the 4.0 min a 5.0 A current is set up in a wire, how many (a) coulombs and (b) electrons…

A: a) The current in a wire is measured by the change in the electric charge with respect to time.…

Q: A new material is found to be superconducting below 77 K. How much resistance will a 75 mm long…

A: Given A new material is found to be superconducting below 77 K, 75 mm long temperature of 69.3 K…

Q: Conduc-Thor-s. Thor has two square prism conductors that are made of the same ohmic material and…

Q: o': Assuming the ideal diode model (Ve0 V), calculate Vour for the circuits in Figures (b) and (c)…

Q: 19. Analyze the circuit in Figure 5–39 to determine the correct voltages at the transistor terminals…

Q: For the potential ry- 3x, what is the corresp at the point (5,2)? A. 25 N/C

A: Given values:- Potential,(∇V)=xy2-3x ----(1) Let us consider E be the corresponding electric field…

Q: some an application, it is important that the value of a re: ange with temperature. We want to make…

A: We make the combined resistor from a carbon resistor (R1 at 0°C) in series with a nichrome resistor…

Q: answer sheet in the box on the 1. A metallic conductor is carry 2.00 mm/s. The resistivity of th…

Concept explainers

Proper Length

The theory of special relativity explains the connection between space and time to objects that move in a straight line at a constant speed. The objects move at the speed of light. When an object approaches light speed, its mass is endless and cannot move faster than light. The most crucial postulate of Einstein's special relativity is that the laws of nature do not change in each frame of reference.

Question

or the given circuit sketch the Vout, Vin vs time in sec.

B) For the given circuit sketch the Vul, Vin Vs time in sec.
R
+12 V
1k
Vin
Veut
10 V
12 V
Diodes are IN402.

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step by step

Solved in 2 steps with 1 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, physics and related others by exploring similar questions and additional content below.

Similar questions

For a parallel circuit, how do I determine he %diff between I1 + I2, as compared to I (current) reflect Ohm's law, apart from same voltage across the circuit?
Find the Vce value for the given circuit
Apply the loop rule to loops abgefa and cbgedc.
1.a. Which article of the National Electrical Code covers radio and television equipment?A. 770B. 517C. 810D. 7051.b. All _______-ampere receptacles for sensitive electronic equipment must be ground-fault circuitinterrupter protected.A. 10- and 30B. 10- and 15C. 20- and 30D. 15- and 20
Find the steady-state current in the RLC-circuit in Fig. 61 for the given data. Show the details of your work. R= 40,L=05H,C =0.1F,E =S500sin2rV c Bit) = Ky aim oot Fig. 61. RLC-circulit
The two frequencies wi-fi uses a current 2.4 GHz and 5.0 GHz. What are the angular frequency for circuit oscillation?
What similarities can you draw between the formulas of finding the capacitance and resistance in series and parallel circuits? Aside from P=IV, what other ways can we obtain power using Ohm's Law?
in the circuit shown in the figure, the S switch is closed at t=0 and the capasitors, which are completely empty, begin to fill. Here E=30V, C=3 uF and R=40 ohm. A) what is the time constant of the circuit, T, in the units of microseconds? B)when t=T, what is the total charge, in units of microcoulomb?
The remaining circuit quantities may change instantaneously as required by Kirchhoff's rules. Q in uC immediately after the switch ( t = 0 + ), in that order.
A capacitor, C, is (fully) charged by connecting it to a 7 Volt EMF and then is allowed to dischargethrough a 2 Ω resistor as shown in the Figure. What is the current, I, in the circuit (in A) when thestored energy in the capacitor has dropped to 30% of its initial value?
Answer the following circuitt by filling out all missing values.
in the curcuit shown in the figure , the S switch is closed at t = 0 and the capacitors, which are completely empty, begin to fill. Here E = 20 V , C = 4uF and R = 30 ohm. a) what is the time constant of the circuit , T in units of microseconds? b)when t=T , what is the total charge , in units of microcloumb accumulated in the capacitors ?