b) Hydrogen can be synthesized through dry reforming reaction as following equation: CH«(g) + CO2(g) → 2C0(g) + 2H2(g) The reaction is carried out in a stainless steel fixed bed reactor at reaction temperature of 700 °C with total flow of 0.4 mol·min consists of 60 mol% CH4 and 40 mol% CO2. Explain the factor that may control the rate of reaction to synthesize H2 from dry reforming in this study.

Q: ave a process stream (300 lbm/min) that contains 0.6 wt frac hexane and 0.4 wt frac octane. Our down...

A: Given, Flow rate of process stream=300 lb/min Let x be the flow rate of pure octane. Overall compone...

Q: 5. Crude oil having the density of 0.82 will have API gravity of.... 6. Lighter hydrocarbon will hav...

A:

Q: An aqueous solution containing 15% NaOH and 0.5% NaCl is concentrated at a rate of 100 kg/min in an ...

A: Given Feed=100 kgmin Convert=After one hour NaOH=2000 kg    

Q: How many grams of SO2 are produced when 152 g of CS2 react with 48.0 g of O2 according to the follow...

A: GIVEN: CS2= 152 g O2=48.0 g  

Q: Calculate the total work done for the path (a b c) of (3 mole) of ideal gas b V CE20 786 I mole K1 T...

A: given Details: ideal gas n=3 mole Ta=600 KTb=300 KTc=492 Kand CV=20.786 J.mole-1.K-1

Q: 1. For Aluminized ANFO derive the following a. Oxygen balanced equation 76. Heat of explosion (Kcal/...

A: (a) Aluminum ANFO is an explosive material that is a combination of Ammonium nitrate NH4NO3, Fuel Oi...

Q: An object will sink in a liquid if the density of the object is greater than that of the liquid. The...

A: Given, The mass of the sphere, m = 9.83 g The density of the liquid mercury, ρHg = 13.6 g/cm3   The ...

Q: Convert 23lbf ∙ ft/min2 to its equivalent in kg ∙ cm/s2. NOTE: it is lbf not lb

A:

Q: Simplify the expression i1997 + i1999, where i is an imaginary number.

A: Given, i9997+i9999 also we know, i2=-1 i9997+i9999=i9997i2+1=i9997-1+1=0

Q: QI/ A porter lifts a luggage of 15 kg from the ground and puts it on his head 1.5 m above the ground...

A: Given that m= 15 kg h = 1.5  m We have to calculate the word done 

Q: Two large beakers are connected with a straight horizontal pipe, 2 cm in diameter and 12 cm long. Th...

A: Write the expression or the diffusivity of organic components in water as follows: DAB = 1.173×10-16...

Q: 1. A 7-meter-long steel pipe was installed by a man during a cold whether at 20°C. What would be the...

A:

Q: b) A plant is producing 12,000 tly of a product. The overall yield is 80%, on a mass basis (kg of pr...

A:

Q: An uncontrolled furnace is emitting foul gas with NO2 portion of 1.8%. Knowing that the NO2 emission...

A: Given Foul gas have NO2=1.8% At STP(0 °C and 100 kPa) emission criteria of NO2=400mg/m3  Find Mini...

Q: The forces F1 = 500 N, F2 = 400 N, and F3 = 700 N all of which act on point A of the bracket, are sp...

A: For calculation of angle of force 2 vector from pythagoras theorem- cos θ2 = 432+42=45 => θ2 = co...

Q: Consider the PV diagram as shown above when a thermodynamic system changes its state from state a to...

A: given that for the path acb heat flows into the system (Q1)=120 J work done by the system (W1)=-50 J...

Q: A 0.750-m section of a steel pipe, 2-inch schedule 40 (inside diameter = 52.50 mm), is carrying wate...

A: Inside diameter of Steel pipe D= 52.50 mm Flow rate of water m = 0.0125 kg/sec Specific Heat of wate...

Q: Fora plu

A:

Q: Applying the phase rule, identify which point F 1 a liquid solid gas 1.

A: Given data: Applying phase rule and find the degree of freedom PT diagram is given.

Q: 5- The second virial coefficient of methane can be approximated by the empirical equation B'(T) = a ...

A: Given a=-0.1993bar-1 b=0.2002bar-1 c=1131k2 300<T<600 K  

Q: What is the importance of modeling and simulation in the chemical industries? Describe the basic ste...

A: Simulation and modelling are the lists of steps applied to solve real-world problems with more ease ...

Q: The initial activity of a radioactive source is 600 counts per second. After a time T, its activity ...

A: Given data: Initial activity of a radioactive source = 600 counts/s Activity after time T = 75 count...

Q: The homogeneous and irreversible reaction A → B is to be carried out isothermally in an ideal and co...

A:

Q: Show how it did derive or get the answer to S and R.

A: There is one material balance and one component balance. The unknowns are S and R . These will be ob...

Q: 1. You have just started working for Azeotrope Separations Co. and you have been placed in a project...

A: Dear User, According to Bartleby policy ,we are authorized to solve only 3-subparts, kindly submit o...

Q: Answer this: A solution is prepared by dissolving 100 mL of solute in enough water to give one liter...

A: Ppm is defined as parts per million, it implies one part in a million. It is given that a solution i...

Q: 1. The following table below is the experimental equilibrium data for the ethanol (1) – benzene (2) ...

A: Given data: The P, x-y data of a binary mixture of ethanol (1) and benzene (2) is given.

Q: A storage tank, in a room 20 m x 10 m x 50 m, containing 10,000 L of liquid toluene develops a leak....

A: Dear User! Please provide us with relevant equilibrium data and process conditions for air-toluene s...

Q: a. H and S for superheated steam at 80 kPa and 520 °C b. Tand V for superheated steam at 100 kPa wit...

A: If steam temperature is more than its vaporization point then steam is superheated steam . Vaporizat...

Q: Calculate for the specific gravity of the Fluid 3 if the specific weight of Fluid = is 62.4 Ib/ft3 a...

A:

Q: 2. The dehydrogenation of ethane in a steady – state continuous reactor is represented by the reacti...

A: Given: dehydrogenation of ethane in a steady state continuous reactor C2H6→C2H4+H2 Moles of C2H6 in ...

Q: 3. How much heat is required to rise the temperature of 0.5 kg water from 30°C to its boiling point?...

A: Given m=0.5 kg Specific heat=4186 J/kg-k T2=1000C T1=300 C

Q: 1: In the sweetening MEROX process for kerosene the mercaptans are converted into (a) Sulpher (b) Di...

A:

Q: the advantages of using Cyclic Olefin Copolymer (COC) as sustainable syringes in medince

A: Asked; Advantages of using Cyclic Olefin Copolymer (COC) as sustainable syringes in medicine are as ...

Q: t-296, the blue spheres Wt-297, and the green spheres Wt-298. ng that the sample is statistically re...

A:

Q: A furnace is fired with coal with the following proximate analysis: 7% Moisture, 23% VCM, 61% FC and...

A: The percent of carbon can be obtained from the heating value, VCM, FC percentage, and sulfur content...

Q: In the subtropics the latent heat loss Qe at the sea surface is typically -125 W/m?. How many meters...

A: Given Latent heat, Lh=-125 Wm2 Density=1027 kgm3 Latent heat of evaporation, Le=2472 x 103 Jkg  

Q: 4. What is the minimum amount of ice at 0°C that must be added to the contents of a can of diet cola...

A: Given details: Volume of cola=340 ml initial temperature of cola (T1c)= 20.50C=293.65 K Final Temper...

Q: In a gyratory crusher the size reduction is effected primarily by: 1.impact 2.attrition 3.cutting...

A: This question is based on crushing and grinding operations. We will analyse each option and find the...

Q: Ethylene glycol produced from ethylene oxide and water is following a liquid phase of first order re...

A: Given data: Ethylene glycol is produced from the reaction of ethylene oxide with water. The rate of ...

Q: 1. A fluid in the manometer has a density of 1,259.9 ; Ry at 300 K. The m3 barometric pressure is 1....

A: Given data: Density of manometric fluid = 1259.9 kg/m3 Barometric pressure = 1.1 atm Absolute pressu...

Q: Determine the molar concentration of an EDTA solution of which 30.00 mL were required to titrate a s...

A:

Q: 2A9CI + Na2SO4 · Ag2SO4 + 2NaCl (MW Ag = 108, Cl = 35.45, Na = 23, S= 32 and O = 16) Answer the Foll...

A: Given that there is a given reaction we have to find stoichiometric coefficient of AgCl

Q: ...... abm what it iks themad.comluachvity? ...... . ...p.......... K............... l .. .............

A: Given data: Density of liquid CCl4 = 1.595 g/cm3 Temperature = 20 0C Pressure = 1 atm Isothermal com...

Q: The homogeneous and irreversible reaction A → B is to be carried out isothermally in an ideal and co...

A: Given that  A         →         B-rA=kCA reactor is ideal and constant volume batch reactor  

Q: Which of the following parameters have little to no effect on the mass diffusivity of liquid substan...

A:

Q: 7. W = 0 when the opposing pressure is A. expanded freely B. same as the gas pressure C. constant D....

A: Given that : in question 7 we have to Choose the correct option when work done should be zero      a...

Q: Example 4.z If 10 g of N, reacts with 10 g of H, and NH, is formed in the reactor, (a) which species...

A: given Details: Mass of N2=10 g Mass of H2=10 g molar mass of N2=28 g/mol molar mass of H2=2 g/mol th...

Q: The homogeneous and irreversible reaction A - B is to be carried out isothermally in an ideal and co...

A:

Q: An ammonia synthesis process operates continuously at 400 [C] and 1 atm. The inlet feed is 40.0 mol/...

A: Given that, The molar flow rate of the feed nF = 40 mol/min The feed contains stoichiometric amounts...