B/ propane is reacted with oxygen to form carbon dioxide and water K02TNZ0 CHs+O2 CO2+H;O -Is the equation correct? (Correct if not) -If 50 moles from C3Hg entered to reactor with 50 moles of O2 and assuming that full converting of limiting reactor, how many H2O moles form?

B/ propane is reacted with oxygen to form carbon dioxide and water K02TNZ0 CHs+O2 CO2+H;O -Is the equation correct? (Correct if not) -If 50 moles from C3Hg entered to reactor with 50 moles of O2 and assuming that full converting of limiting reactor, how many H2O moles form?

Chemistry

10th Edition

ISBN:9781305957404

Author:Steven S. Zumdahl, Susan A. Zumdahl, Donald J. DeCoste

Publisher:Steven S. Zumdahl, Susan A. Zumdahl, Donald J. DeCoste

Chapter1: Chemical Foundations

Section: Chapter Questions

Problem 1RQ: Define and explain the differences between the following terms. a. law and theory b. theory and...

See similar textbooks

Similar questions

A chemical manufacturer produces ethylene oxide by burning ethylene gas with air in the presence of catalyst. If the conditions are carefully controlled, a substantial fraction of ethylene remains unconverted and some is completely oxidized to form carbon dioxide and water. Formation of carbon monoxide is negligible. After the gases leaving the absorber is as follows: 9.6%CO2, 3.0%O2 and 6.4% ethylene. Of the ethylene entering the reactor, what percentage is converted to ethylene oxide?
1 mol propane (C3H8) and stoichiometric amount of oxygen (O2) needed to combust propane was preheated to 400 K. After combustion, the products released are at 1500 K. The combustion products are H2O(l) and CO2(g). With 100% conversion was achieved, estimate the total heat released. Calculate the heat requirement for a reactor in combusting 1 mol of methane, CH4, with 25% excess air until the products reach a temperature of 1000 K. The reactants entered the reactor at 298.15 K and 100% conversion of methane is achieved. Assume air is approximately 21% O2 and 79% N2 and products are H2O(l) and CO2(g). Hint for both #1 and #2 – Combustion products at 298 K is CO2(g) and H2O(l). If the exiting temperature is above 373.15 K, H2O will leave as H2O(g). Therefore, you should account for the phase change of H2O(l) to H2O(g).
Jansen Gas creates three types of aviation gasoline(avgas), labeled A, B, and C. It does this by blendingfour feedstocks: Alkylate; Catalytic CrackedGasoline; Straight Run Gasoline; and Isopentane.Jansen’s production manager, Dave Wagner, hascompiled the data on feedstocks and gas types inTables 4.6 and 4.7. Table 4.6 lists the availabilitiesand values of the feedstocks, as well as their keychemical properties, Reid vapor pressure, and octanerating. Table 4.7 lists the gallons required, theprices, and chemical requirements of the three gastypes. Table 4.6 Data on Feedstocks Feedstock Alkylate CCG SRG Isopentane Gallons available (1000s) 140 130 140 110 Value per gallon $4.50 $2.50 $2.25 $2.35 Reid vapor pressure 5 8 4 20 Octane (low TEL) 98 87 83 101 Octane (high TEL) 107 93 89 108 Table 4.7 Data on Gasoline Gasoline A B C Gallons required (1000s) 120 130 120 Price per gallon $3.00 $3.50 $4.00 Max Reid pressure 7 7 7 Min octane 90 97 100 TEL level Low High High Note that each feedstock…
- The major objective of a roasting process is to eliminate the Sulphur contained in the concentrate andto provide a calcine. In a roasting plant, 1000 kg per hour of molybdenum(IV) sulphide (MoS2) is roastedwith 25 % excess air to obtain MoO3 calcine in a chamber-type roasting furnace. Preheated air entersthe reactor at 400 K while MoS2 enters at room temperature. After the process, the waste gases leavethe reactor at 1000 K, and the calcine leaves at 850 K.a) Draw process flowsheet and heat balance diagram (ref. temp is 298 K) b) Calculate the amount of off-gas per hour in moles. c) Calculate the amount of calcined MoO3 per hour in kg.
Certain mole of charcoal (12C) has to be completely converted to CO2 after reaction with the oxygen of air. If double amount of air (mole basis) was supplied in the reactor then find the average molecular weight of the outlet gas mixture stream. Note that, carbon has no reaction with nitrogen in this case.
Use only the first decimal points (X.X) for atomic masses. R = 8.314 L*kPa/mole*K. In a reactor at 350.0 kPA and 95 °C, HCl adds to acetylene by the following reaction:2HCl(g) + C2H2(g) --> C2Cl2H4(g)39.1 g of HCl and 39.1 g of acetylene are placed into the reactor. What is the limiting reagent? What is the final volume of the system?
Balance each of the chemical equations shown below. Be sure to include values of 1 for any species that only have 1 equivalent involved in the reaction (i.e. empty inputs DO NOT correspond to the value "1"). Use integers for ALL coefficients.
Meztiza, a beer cocktail, is prepared by mixing rum, beer, and cola. Compute the finalconcentration(%w/v) of ethanol in meztiza if 100.0 mL of beer was first mixed with 5.0 mL rum andbefore finally diluting it with cola to produce 200.0 mL of the beer cocktail. ( a beer contains about 4.50% (v/v) of ethanolfermented by yeast from sugars while rum contains about 40.0% (v/v) ethanol. Meanwhile, arubbing alcohol is also an alcohol solution which contains 70.0 %(v/v) isopropyl alcohol fermentedby a bacterium instead of a yeast)
ethylene oxide is produced by oxidation of ethylene 100 kmol of ethylene and 100 kmol of o2 are charged to a reactor.the % conversion of ethylene is 85 and%yield of ethylene oxide is 94.12 .calculate the composition of product stream leaving the reactor .the reactions takes place are
Butane (C4H10)(C4H10) and dry air are fed to a combustion reactor at a steady rate of 45.9 mol/s45.9 mol/s butane and 2500.0 mol/s2500.0 mol/s dry air. Assume the butane reacts completely to produce CO2CO2 and H2O.H2O. The reactants enter the reactor at 25 ∘C25 ∘C and the products leave the reactor at 1110.4 ∘C.1110.4 ∘C. Calculate the percent excess air. Using the information below, find the heat interaction. Species ΔHf at 298 K(kJ/mol) CP (kJ/kmol·K) O2 0 3.5R N2 0 3.5R C4H10 -125.5 12R CO2 -393.5 3.5R H2O -241.8 3.5R
For the equilibrium system: H2O(g) + CO(g) <--> H2(g) + CO2(g). Delta heat of rxn: -42 kJ/mol and Kc=0.62 at 1260 K.0.10 mol each of water, CO, and CO2 (all at 1260 K) are placed in a sealed 1.0-Liter thermally-insulated vessel, which is also at 1260 K. When the system comes to equilibrium, which is true?-The temp & mass of CO would increase.-The temp & mass of CO would decrease.-The temp would remain constant & the mass of CO would increase.-The temp would increase and the mass of CO would decrease.-The temp would decrease and the mass of CO would increase.
ANSWER ONLY D For the gas-phase reaction A = 2B operated at 1.0 bar: Initially, the reactor contains only A, at 1.0 mol. a. Prove that the reaction coordinate (moles of A consumed) equals the following: (see attactched image) b. Make a plot of the reaction coordinate versus temperature between 200 and 400 K for exothermic reaction conditions, making use of the van’t Hoff Equation. Data: Ka = 5.0 at 298 K, ΔHrxn0 = -50.0 kJ mol-1. Neglect the ΔCp term. d. If the reaction described in part b (i.e., exothermic conditions) were operated in a simple batch reactor, would the reaction mixture’s temperature increase, decrease, or remain constant as the reaction progressed? To maximize conversion, would you recommend that heat be added to, or removed from, the reactor?