Bag slides off the slope. shown in the figure. At a horizontal speed of 20 m/s. If the ramp is 12 meters off the ground, determine the time required for the bag to hit the ground and the field where the bags begin to pile up. 12 m 20m/5 R. a B

Bag slides off the slope. shown in the figure. At a horizontal speed of 20 m/s. If the ramp is 12 meters off the ground, determine the time required for the bag to hit the ground and the field where the bags begin to pile up. 12 m 20m/5 R. a B

Elements Of Electromagnetics

7th Edition

ISBN:9780190698614

Author:Sadiku, Matthew N. O.

Publisher:Sadiku, Matthew N. O.

ChapterMA: Math Assessment

Section: Chapter Questions

Problem 1.1MA

See similar textbooks

Related questions

Q: The right limb of a simple U-tube manometer containing mercury is open to the atmosphere while the…

Q: What is the pressure difference between points A and B?

A: Given that, Relative density of oil (Soil)= 0.85 Density of oil ρ = relative density of…

Q: If the resultant of the four forces is FR = (-363k} lb, determine the tension developed in each…

Q: The long bolt passes through the 20-mm-thick plate. If the force in the bolt shank is 9 kN,…

A: Given data: ● The force applied on the bolt shank: F = 9 kN = 9000 N ● The thickness of the plate…

Q: B- A three-lobe rotary positive-displacement pump moves 0.45 cm³ of blood in each lobe volume Vlobe.…

Q: Q1. Water flowing through a pipe has a dynamic viscosity of 8.9 x 10-4 Pas and a density of 1000…

Q: 14 The brass bar shown is loaded axially in compression so that the maximum stress induced is 125…

A: Given Maximum stress = 125 MPa Diameter, D = 30 mm Hole diameter, d = 20 mm Find Total…

Q: The gusset plate is subjected to the forces of three members as shown in (Figure 1) The forces are…

A: GIVEN DATA- A SYSTEM OF FORCES IS GIVEN WE HAVE TO FIND TENSION T AND ANGLE θ

Q: n sensible heating or cooling process, it is the dry bulb temperature of air being varied either…

A: Sensible heating or coolingThe sensible heating or colling involves the increase or decrease in the…

Q: } Q1 ( shown. " The stresses in a bracket were obtained from a 3D finite element analysis as [20 0…

Q: C- Mention three of the advantage of the positive displacement pump?

A: Given Data- Positive displacement type pump given We have to write Three advantage of Positive…

Q: ) In cooling tower below, derive the given equations based on the system boundary below (neglect…

Q: The joint is subjected to the axial member force of 6 kips. Determine the average normal stress…

A: Given:Force acting, F=6 kipThickness of the member, t=1.5 in

Q: 6-16C A constant-velocity horizontal water jet from a stationary nozzle impinges normally on a…

A: Given date:- 1 constant velocity horizontal water jet 2 vertical flat plate…

Q: How many balls of 50 mm diameter fit in a volume of 4.1 m^3

Q: 4- Find the gearing ratio for the given compound gears shown in figure 10.

A: We can answer the first question for you since the exact one is not specified. Please resubmit the…

Q: 2. Two gaseous streams enter a combined tube in a steady flow manner and leave as a single mixture…

Q: 5) Before transferring the rod into the graduated cylinder, the cylinder tipped and some of the…

A: Write the relation in mass, density and volume. m=ρVAt m=constant then,ρV=constantρ∝1V

Q: The truck is to be towed using two ropes. Determine the magnitude of force FA in order to develop a…

Q: Create an isothermal process that takes a gas/thermodynamic system from a Pi, Ti, V; to a state…

Q: Each propeller of the twin-screw ship develops a full-speed thrust of F = 375 kN. In maneuvering the…

A: Given:Force generated by the propeller, F=375 kNc=14 ma=55 mb=100 m

Q: Winter air is heated & humidified thru steam heated coil and humidified using water sprayer. Air is…

Q: Determine the reactions at the supports:

A: To determine, the reactions at the supports The free body diagram of the given loadings is

Q: The flow rate through a 10-cm-diameter wrought iron pipe shown below is 0.04 m³/s. Find the…

Q: Determine the force P required to maintain the 240-kg engine in the position for which = 26°. The…

Q: Q3/ Two pipes containing water are connected to a compound differential manometer as shown in Fig.…

A: Given that: Specific gravity of the oil is 0.9. Specific gravity of mercury is 13.6 Therefore, ρw =…

Q: : A beam carries the loading shown in Fig. 4. Determine, (a) the smallest allowable width b of the…

Q: The 500-kg load on the hydraulic lift shown in the figure on the right is to be raised by pouring…

A: Given :- Load on hydraulic lift (L) = 500 kg × 9.81 m/s2 Load on hydraulic lift (L) = 4905 N To…

Q: Q.5( Determine the reactions in C on member ACD as shown in figure? B 800 KN 5 m 4 m 6m A D 8m E 600…

Q: Example(): Water flows through a 16-in pipeline (0.375-in wall thic gal/min. Assuming a pipe…

A: Given data as per question Water flow through pipeline 16 in (0.375 in wall Thickness) Q=30000…

Q: A- Define the following with mathematical expression if needed: 1- Closed system, 2- Cycle, 4-…

A: Thermodynamics is the branch of science which deals with energy and it's transformation.

Q: 4- The minimum force required to slide a body of weight W on a rough horizontal plane is A. W sing…

Q: Where does the resultant of the two forces act? Replace the two forces with a single equivalent…

A: This is the given problem

Q: 5. Heat is removed from the compartment of a refrigerator at a rate of 250 kJ/min. The refrigerator…

A: as per guideline i have to solve only three question of yours ,please repost rest

Q: Suspended mass m (g) 100 300 500 700 1000 Total time for 30 oscillations, t(s) 40.0 49.3 57.1 73.3…

A: Given For 500 g mass Total time, t = 57.1 sec For 700 g mass Time period, T = 2.81 sec Find…

Q: Q4- For the shaded area shown in Figure (4), determine: a. The x coordinate of the centroid (x'). b.…

Q: Glycerin at 10°C is flowing steadily through a 8-cm diameter pipe at 0.1 kg/s. What is the average…

A: Write the given data. m˙=0.1 kg/sD=0.08 m

Q: The mass center G of the 1365-kg rear-engine car is located as shown in the figure. Determine the…

Q: Required information NOTE: This is a multi-part question. Once an answer is submitted, you will be…

Q: Data: Hp2,3 = 2 m; A3 = 20 cm²; A₂ = 1 cm²; Hp0,1 = 0.8 m; NB= 74%(pump efficiency) To determine:…

Q: Q1-A/ Determine the moment of the force system shown in Figure (1A) with respect to moint A. 100 N…

A: Given: The load actin at the center, P = 100 N

Q: Rate of heat transfer for a fluid varies with the Reynolds number and the regime of the flow (i.e.,…

A: Given: L = 10 m h-Dk=3.66+0.83Re1/3 if flow is laminar. h-Dk=0.025Re4/5 if flow is turbulent. D =…

Q: 7. The only mode of heat transfer that does not need a medium. 8. A mode of heat transfer that…

A: given = one word answer or fill in the blank

Q: Do you expect a material's stiffness to increase or decrease if there is more than one deformation…

A: The stiffness of material if different for different type of loadings causing deformation in the…

Q: 3 A slender rod 1.4 m long and of mass 20 kg is attached to a wheel of mass 3 kg and radius 0.05 m,…

Q: 2. The solid shaft ABCDE has a diameter of 30 mm and is simply supported at its ends. The pulleys at…

A: Given: The diameter of solid shaft, d = 30 mm = 0.03 m The diameter of pulley B and D, D = 200 mm =…

Q: Determine the reactions in C member ACD as shown in figure? Q.5( B 800 KN 5 m 4m 6m C D 8 m 600 KN 3…

Q: You step on a digital scale, which tells you that your mass is 84.6 kg. From this, you assume that…

Q: Create an isothermal process that takes a gas/thermodynamic system from a Pi, Ti, Vi to a state…

A: Given, P_i = 200000 N/m^3 v_i = 0.1 m^3 P_f= 500000 N/m^3

Q: When the load L is 5.9 m from point C, the tension T in the cable has a magnitude of 7.2 kN. Express…

Concept explainers

Conservation of Energy

In physics, the rule of the conservation of energy states that energy doesn’t disappear from the atmosphere; instead, it changes its form from one type to another. Energy is one of the most important physical quantities in nature, and it cannot be created or destroyed — only transformed.

Question

Bag slides off the slope. shown in the figure. At a horizontal
speed of 20 m/s. If the ramp is 12 meters off the ground,
determine the time required for the bag to hit the ground
and the field where the bags begin to pile up.
12 m
20m/s
31.28 m, 1.564 sec 0
13.3m, 1.11sec 0
40.21 m, 3.7 s 0
R.

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step by step

Solved in 2 steps with 2 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, mechanical-engineering and related others by exploring similar questions and additional content below.

Similar questions

A train travels between two stations 792 m apart in a minimum time of 41 seconds. If the train accelerates and decelerates at 2.4 m/s, starting from rest at the first station and coming to a stop at the second station, what is the maximum speed?
A particle moves along a straight line in such a manner that its displacement, at any instant, from a fixed point on its path is given by the equation s = (t3 + 6t2 – 4t)/10. Determine the distance (in meter) traveled by the particle during the 10th sec.
The position of a particle along a straight line is given by s = (t^3 - 9t^2 + 15t) ft, where t is in seconds. Determine its maximum acceleration and maximum velocity during the time interval 0 ... t ... 10 s.
The position of a particle in millimeters is given by s = 70 - 17t + t2 where t is in seconds. Plot the s-t and v-t relationships for the first 10 seconds. Determine the net displacement Δs during that interval and the total distance D traveled. By inspection of the s-t relationship, what conclusion can you reach regarding the acceleration?
A particle is observed to start at rest and acceleration at a=30+2t, where t is in seconds, until its velocity is 39.20 m/s. It then hits an obstruction and the acceleration is given by a= -0.003v2, until the velocity decreases to 98.20 m/s. Determine the total distance the particle travelled, and the total time of travel.
A particle travels along a straight line with a velocity v = (12 – 3t^2) m/s, where t is in seconds. When t = 1 s, the particle is located 10 m to the left of the origin. Determine the distance the particle travels during this time period. What is the answer. Show the solution. A. 880 m B. 229 m C. 922 m
A motorboat and its load weigh 980 kg. Assume that the propeller force is constant and equal to 24 kg, and the water resistance is numerically equal to 1.5v kg, where v is the speed at any instant time in m/sec. If the boat starts from rest, determine its speed at the end of 10 seconds. Answer is 2.23 m/s
an automobile starting from rest speeds up to 12 m/s with a constant acceleration of 1.2 m/s^2. runs at fast speed for some time, and finally comes to rest with a decelaration of 1.5 m/s^2. if the total distance travelled is 319m, find the total time required. draw the v-t and s-t curves.
1. A car with an initial velocity of 45 kph and has a uniform acceleration of 5m/s2. Determine the time required for the car to reach 150 m from its initial position x0 = 0 and the speed of the car in kph as passes into 150m. 2. A man is required to pay 57500 at the end of 15 days or 60000 at the end of 60 days. Determine the rate of interest
A car travels at a constant speed of 10 m/s, then decelerates at a constant 2 m/s2until rest. Determine time elapsed and car’sdistancebefore rest.
A particle is observed to start at rest and accelerates at a = 30 + 2t, where t is in seconds, until its velocity is 399.20 m/s. It then hits an obstruction and the acceleration is given by a = -0.003v², until the velocity decreases to 99.20 m/s. Determine the total distance the particle travelled, and the total time of travel.
A particle is moving along a straight line with a = (12t - 3t^0.5) ft/s^2, where t is in seconds. Determine the velocity and position of the particle as a function of time. When t = 0, v = 0, and s = 15ft. Please show full solution, thanks!