Balance the reaction between H3ASO4 and Hg to form H3A5O3 and Hg2+ in acidic solution. When you have balanced the equation using the smallest integers possible, enter the coefficients of the species shown. Enter "1" if the coefficient is "1." H3ASO4 + Hg- H3ASO3 + Hg2+ Water appears in the balanced equation as a (reactant, product, neither) with a coefficient of (Enter 0 for neither.) How many electrons are transferred in this reaction?

Balance the reaction between H3ASO4 and Hg to form H3A5O3 and Hg2+ in acidic solution. When you have balanced the equation using the smallest integers possible, enter the coefficients of the species shown. Enter "1" if the coefficient is "1." H3ASO4 + Hg- H3ASO3 + Hg2+ Water appears in the balanced equation as a (reactant, product, neither) with a coefficient of (Enter 0 for neither.) How many electrons are transferred in this reaction?

Principles of Modern Chemistry

8th Edition

ISBN:9781305079113

Author:David W. Oxtoby, H. Pat Gillis, Laurie J. Butler

Publisher:David W. Oxtoby, H. Pat Gillis, Laurie J. Butler

Chapter17: Electrochemistry

Section: Chapter Questions

Problem 80AP

See similar textbooks

Similar questions

ethylene oxide is prepared by oxidation of ethylene. 100Kmol of ethylene and 100Kmol of O2 are charged to a reactor.The percent conversion of ethylene is 85 and percent yield of C2H4O is 94.12. Calculate the composition of product steam leaving the reactor .The reactions taking place are: C2H4+0.5O2=C2H4O C2H4+3O2= 2CO2+2H2O
ethylene oxide is produced by oxidation of ethylene 100 kmol of ethylene and 100 kmol of o2 are charged to a reactor.the % conversion of ethylene is 85 and%yield of ethylene oxide is 94.12 .calculate the composition of product stream leaving the reactor .the reactions takes place are
PLEASE ESTABLISH BASIS ON THE STACK GAS A burner used Pittsburgh coal analyzing 14.1% ash, 2.1% N, 4.3% S. Excess air is supplied dry at 22⁰C and 1 atm. The stack gases at 285⁰C, 765 mmHg analyzes 9.65% CO2, 1.16% CO, 0.24% SO2, 0.58% H2 and 9.16% O2. Calculate: a) % excess air b) complete ultimate analysis of the coal, c) m3 air/kg coal and d) m3 stack gas /kg coal.
A pellet of benzoic acid standard was combusted in a bomb calorimeter to determine the experimental calorimeter constant. After 6 mins of monitoring the temperature, the bomb was fired. The following data were obtained. mole of benzoic acid: 0.0049 mol mass of burnt fuse wire: 0.0125 g qwire,surr: 5858 J/g ΔHcombustion of benzoic acid: -3228.0 kJ/mol Δng (combustion of benzoic acid): -0.5 mol R: 8.314 J/mol•K r1: 0ºC/min r2: 0ºC/min Tf: 30.4ºC Ti: 28.4ºC Determine the calorimeter constant (in J/ºC). Report your answer in 2 decimal places.
A chemical manufacturer produces ethylene oxide by burning ethylene gas with air in the presence of catalyst. If the conditions are carefully controlled, a substantial fraction of ethylene remains unconverted and some is completely oxidized to form carbon dioxide and water. Formation of carbon monoxide is negligible. After the gases leaving the absorber is as follows: 9.6%CO2, 3.0%O2 and 6.4% ethylene. Of the ethylene entering the reactor, what percentage is converted to ethylene oxide?
The production of cement results in significant GHG emissions. The emissions are caused by the decomposition of calcium carbonate (limestone) to calcium oxide (lime) and carbon dioxide. This process known as calcination, is carried out in kilns. Therefore, additional GHGs are emitted as a result of heating the kilns. A large cement manufacturer uses a mix of coal, natural gas, and biomass in its boiler. This mix produces the following amounts of GHGs per Million BTUs of energy: • 250 lbs CO2/MMBtu • 5 lbs CH4/MMBtu • 0.36 lbs N2O/MMBtu Process carbon emissions from the calcination process produce 925 lbs of carbon dioxide per metric ton of cement. In addition, the plant uses 1.7 Million BTUs of energy per metric ton of cement. If the plant produces 180,000 metric tons of cement annually, how many metric tons of CO2e does it emit?
- The major objective of a roasting process is to eliminate the Sulphur contained in the concentrate andto provide a calcine. In a roasting plant, 1000 kg per hour of molybdenum(IV) sulphide (MoS2) is roastedwith 25 % excess air to obtain MoO3 calcine in a chamber-type roasting furnace. Preheated air entersthe reactor at 400 K while MoS2 enters at room temperature. After the process, the waste gases leavethe reactor at 1000 K, and the calcine leaves at 850 K.a) Draw process flowsheet and heat balance diagram (ref. temp is 298 K) b) Calculate the amount of off-gas per hour in moles. c) Calculate the amount of calcined MoO3 per hour in kg.
A 0.512 g sample of a commercial phosphate detergent was ignited at a red heat to destroy the organic matter. The residue was taken up in hot HCl, which converted the P to H3PO4. The phosphate was precipitated as MgNH4PO4.6H2O by addition of Mg2+ followed by aqueous NH3. After being filtered and washed the precipitate was converted to Mg2P2O7 by ignition at 1000 0C and the residue weighed 0.1151g. (a) What is the Gravimetric Factor to convert Mg2P2O7 to P? (b) Calculate the percent P in the sample could you type it out please
Soil Fertility Index and Soil Evaluation Factors, Are these equations suitable for alkaline soil? Soil Fertility Index (SFI) = pH + organic matter (%, dry soil basis) + available P (mg kg-1 dry soil) + exch K (cmolckg-1) + exch Ca (cmolckg-1) + exch Mg (cmolckg-1)-exch Al (cmolckg-1) Soil Evaluation Factor (SEF) = [Exch K (cmolckg-1) + Exch Ca (cmolckg-1) + Exch Mg (cmolckg-1)-log(1 + exch Al (cmolckg-1)] × organic matter (%, dry soil) + 5
A sample containing chlorophenol, C6H4ClOH, was analysed by gravimetric analysis. A 0.783-g of this sample goes through a chemical process allowing the chlorine in the chlorophenol to precipitate as silver chloride, weighing 0.271 g. Calculate the % (wt/wt) of the chlorophenol in the sample, assuming that chlorophenol is the only source of chlorine in the sample. Provide your answer to two decimal places and without units. Avoid using scientific notation.
Chlorodifluoromethane (CHF2Cl) was widely used in the compression/cooling circuits of refrigeration or air-conditioning systems. Since the discovery that such compounds (HCFCs and CFC's) released into the atmosphere were a major cause of depletion of stratospheric ozone, newer refrigeration systems make use of certain hydrofluorocarbons (HFCs), which are degraded in the lower atmosphere, instead. Often, mixtures of such compounds are used. Suppose a sample of refrigerant gas consisting of a simple mixture of the gases pentafluoroethane (C2HF5) and difluorormethane (CH2F2) has a density of 3.06 g/L at 14 °C and 0.974 atm. Calculate the average molecular mass for this sample
Chlorodifluoromethane (CHF2Cl) was widely used in the compression/cooling circuits of refrigeration or air-conditioning systems. Since the discovery that such compounds (HCFCs and CFC's) released into the atmosphere were a major cause of depletion of stratospheric ozone, newer refrigeration systems make use of certain hydrofluorocarbons (HFCs), which are degraded in the lower atmosphere, instead. Often, mixtures of such compounds are used. Suppose a sample of refrigerant gas consisting of a simple mixture of the gases pentafluoroethane (C2HF5) and difluorormethane (CH2F2) has a density of 1.43 g/L at 26 °C and 0.405 atm. Calculate the average molecular mass for this sample. Calculate the volume percentage of CH2F2 in the sample.