Bể süre to specify states such as (aq) or (s). If a box is not needed leave it blank. When aqueous solutions of ammonium carbonate and chromium(II) iodide are combined, solid chromium(II) carbonate and a solution of ammonium iodide are formed. The net ionic equation for this reaction is: (Use the solubility rules provided in the OWL Preparation Page to determine the solubility of compounds.)

Bể süre to specify states such as (aq) or (s). If a box is not needed leave it blank. When aqueous solutions of ammonium carbonate and chromium(II) iodide are combined, solid chromium(II) carbonate and a solution of ammonium iodide are formed. The net ionic equation for this reaction is: (Use the solubility rules provided in the OWL Preparation Page to determine the solubility of compounds.)

Chemistry

10th Edition

ISBN:9781305957404

Author:Steven S. Zumdahl, Susan A. Zumdahl, Donald J. DeCoste

Publisher:Steven S. Zumdahl, Susan A. Zumdahl, Donald J. DeCoste

Chapter1: Chemical Foundations

Section: Chapter Questions

Problem 1RQ: Define and explain the differences between the following terms. a. law and theory b. theory and...

See similar textbooks

Similar questions

Arsenic(III) oxide (As2O3) is available in pure form and is a useful (but carcinogenic) primary standard for oxidizing agents such as MnO4-. The As2O3 is dissolved in base and then titrated with MnO4- in acidic solution. A small amount of iodide (I - ) or iodate (IO3-) is used to catalyze the reaction between H3AsO3 and MnO4-. As2O3 + 4 OH - 2 HAsO32- + H2OHAsO32- + 2 H+ H3AsO35 H3AsO3 + 2 MnO4- + 6 H+ 5 H3AsO4 + 2 Mn2+ + 3 H2O (a) A 3.209 g aliquot of KMnO4 (FM 158.034) was dissolved in 1.000 L of water, heated to cause any reactions with impurities to occur, cooled and filtered. What is the theoretical molarity of this solution if no MnO4- was consumed by impurities? M(b) What mass of As2O3 (FM 197.84) would be just sufficient to react with 25.00 mL of the KMnO4 solution in part (a)? g(c) It was found that 0.146 8 g of As2O3 required 29.98 mL of KMnO4 solution for the faint color of unreacted MnO4- to appear. In a blank titration, 0.03 mL of MnO4- was required to produce enough…
please help me The aluminum in a 1.200g sample of impure ammonium aluminum sulfate was precipitatedwith aqueous ammonia as the hydrous Al2O3 · XH2O. The precipitate was filtered and ignitedat 100°C to give anhydrous Al2O3, which weighed 0.2001 g. Express the result of this analysisin terms of % Al.
What weight of sample in gram containing 8.00 % Fe3O4 (MW= 231.53 g/mole) must be taken to obtain a precipitate of Fe (OH)3 (MW= 106.867 g/mol) that, when ignited to Fe2O3 (MW = 159.69 g/mole), weighs 150.0 mg
It is required to know the concentration of an aqueous solution of H2SO4 that appeared in the laboratoryChemistry III and it's unlabeled. To this end, a student of analytical chemistry carried out the followingProcedure: He took 5.00 mL of a fresh and standardized solution of 0.525M NaOH and brought them to a250.0 mL balloon to be completed with distilled water. Subsequently, he poured 15.00 mL of the solutionH2SO4 of unknown concentration in an Erlenmeyer flask and added 2 drops of phenolphthalein.Using a burette filled with the last NaOH solution, he noticed that when adding 39.40 mL of the hydroxidethe Erlenmeyer solution reached a faint but permanent pink. With the above dataDetermine the concentration and pH of the H2SO4 solution.
The concentration of CO in the air can be determined by passing a known volume of air through a tube containing I2O5, resulting in the formation of CO2 and I2. I2 is removed from the tube by distillation and collected in a solution containing excess KI, producing I3-. I3- is titrated with a standard solution of Na2S2O3. A 4.79 L air sample was sampled as described here, requiring 7.17 ml of 0.00329 M Na2S2O3 to reach the endpoint in a typical analysis. If the density of the air is 1.23×10^-3 g/ml, what is the amount of CO in the air in ppm? (CO: 28 g/ml)
The arsenic in a 1.22-g sample of a pesticide was converted toAsO43- by suitable chemical treatment. It was then titratedusing Ag+ to form Ag3AsO4 as a precipitate. (a) What is theoxidation state of As in AsO43-? (b) Name Ag3AsO4 by analogyto the corresponding compound containing phosphorusin place of arsenic. (c) If it took 25.0 mL of 0.102 M Ag+to reach the equivalence point in this titration, what is themass percentage of arsenic in the pesticide?
calculate the mass of Sn when 50 mL of a sample containing Sn2+ is titrated with 42.00 mL of 0.0150M MnO4- to reach endpoint
The hardness of water (hardness count) is usually expressed in parts per million (by mass) of CaCO3. What is the molar concentration of Ca2+ ions in a water sample with a hardness count of 175mg CaCO3il? How many milliliters of concentrated sulfuric acid, 94.0% (w/w), specific gravity of 1.831 are required to prepare 1 liter of a 0.100 M solution? The solubility-product constant for Ce(IO3)3 is 3.2x1010. What is the Ce3+ concentration in a solution prepared by mixing 50.0 ml of 0.0250 M Ce3.. with 50.00 ml of water?
Hydrogen peroxide solutions can easily be decomposed by dust, trace amounts of metals or light. It istherefore necessary to periodically determine the purity of the peroxide solutions.This can be done via a redox titration as follows: The density of a particular surgical grade hydrogen peroxide solution is 1.11g.cm-3. Exactly 10 mL of this solution was pipetted and quantitatively transferred, along with a sufficientamount of a dilute sulphuric acid solution, into a 250.00 mL volumetric flask and made up to the mark. A 25.00 mL portion of this diluted solution is pipetted into a conical flask, and titrated with a0.372 M KMnO4 solution. The endpoint of the titration is determined when the colourless solution in the conical flask turns apersistent bright pink due to the presence of excess permanganate ions. The average titration value is 26.20 mL of the KMnO4 solution 1.Determine the percentage of the hydrogen peroxide in the solution sample.2. Naturally occurring manganese…
Please answer this NEATLY, COMPLETELY, and CORRECTLY for an UPVOTE. Ni(NO3)2From the stock solution (1.0 M), determine the volume needed to prepare 0.00, 0.04, 0.08, 0.12 and 0.16 M Ni(NO3)2 solution in 50 mL volumetric flask. Obtain the calculated amounts, place in corresponding volumetric flasks and dilute to mark.
If you want to dissolve 0.225 grams of AgBr, what volume of 0.0138M Na2S2O3 in mililiters, should be used
(a) If the molar solubility of Cu3(PO4)2 at 25 oC is 1.67e-08 mol/L, what is the Ksp at this temperature?Ksp = _______(b) It is found that 1.75e-06 g of Cu3(AsO4)2 dissolves per 100 mL of aqueous solution at 25 oC. Calculate the solubility-product constant for Cu3(AsO4)2.Ksp = _______(c) The Ksp of ScF3 at 25 oC is 5.81e-24. What is the molar solubility of ScF3?solubility = ______ mol/L