H.WFrom: To:AE (m)o (m)BAB10.5090.006B5.3600.004CD-8.5230.005A.DA-7.3480.003BD-3.1670.004A15.8810.012Benchmark A has an elevation of 437.596 m.What are the most probable values for B, C, D?

Answered: Benchmark A has an elevation of 437.596…

Engineering

Civil Engineering

Benchmark A has an elevation of 437.596 m. What are the most probable values for B, C, D?

Structural Analysis

6th Edition

ISBN:9781337630931

Author:KASSIMALI, Aslam.

Publisher:KASSIMALI, Aslam.

Chapter2: Loads On Structures

Section: Chapter Questions

Problem 1P

See similar textbooks

Related questions

Q: STAKEVALUES GROUND HEIGHTS 1232,500 1233,253 1233,650 1234,000 1234,400 1234,855 1235,250 1235,752…

A: In the field, while surveying for road construction or similar ground formation work, we firstly…

Q: You are required to measure the area of a site by tape only. The needed length measurements are…

A: Given that: Length of sides are: A=12, B=30, C=25, D=25, E=22, F=20, G=25, H=35,…

Q: Situation 2] A surveyor was tasked to cut off a required area by a line through a given point. In…

Q: Determine the volume of the lake shown below. Contour interval is 5 meters. The areas bounded by…

A: Given data- A contour is given as shown- Contour Interval (D) = 5 m To Find- The volume of the…

Q: Calculate the total area (m2) of a cross section using Simpson's 1/3 Rule. Consider the following…

Q: Problem 5 Angles AOB, BOC, and COD are measured on the same angle at point O. Determine the most…

A: GIVEN : Measurement of Angles, number of measurements. REQUIRED : Most probable Angle, MPV

Q: The following perpendicular offset were taken from a chain line to the irregular boundary. Chainage…

A: We will solve this question in step no. 2

Q: Define Horizontal earth pressures

A: When a retaining wall retains a mass of soil at a higher level, the retained soil mass appears to…

Q: 2. The data tabulated represents earthwork quantities for a certain road extension project. STATION…

Q: The interior angles of a quadrilateral were observed to be: A = 103°33’10’’, B = 114°54’55’’, C =…

A: Given: The interior angle A is 103°33’10’’. The interior angle B is 114°54’55’’. The interior angle…

Q: Given a triangular lot ABC with the following data: SIDE BEARING DISTANCE АВ N 68° E 214.46 m BC S…

Q: 1. A square piece of land 60m x 60m is to be leveled down to a level coinciding to elevation zero.…

A: Excavation depth = average elevation - zero Determine Volume of cut, V = grid area * average…

Q: Q2) Using prismoidal formula to calculate total volume cut and fill when the ground area (50 m X 60…

A: Scale = Distance on the map Distance on the ground Area (sq.cm) Actual area (sq.m) 30 A1 = 750…

Q: A line was measured on a sloped ground to be 15.94 m long. If the vertical distance between the ends…

Q: Question 13 From a helicopter flying at 30,000 feet, the angles of depn two cities? 23,587.67 feet…

Q: Problem no. 8: Given the following cross-sectional notes below with side slopes of 1:1 and a same…

Q: Contour interval - 20 meters Figure above is a water table contour map 1- Mill River generally flows…

A: The correct direction of mill river is North East direction according to the given contour map.

Q: 2. The sides of triangle ABC were measured as follows: AB = 129.26m, BC = 258.73m, and AC = 211.25m.…

A: given sides of triangle are AB= c = 129.26 m BC = a = 258.73 m AC = b= 211.25 m let semi perimeter…

Q: An unknown line was paced by a surveyor and gathered the following data: 489, 482, 489, and 483. He…

A: Given: The paced data for the unknown line is 489, 482, 489, and 483. The distance of the new line…

Q: Problem no. 8: Given the following cross-sectional notes below with side slopes of 2:1 and a same…

Q: A surveyor made 4 different routes of level from Point A to Point B. The elevation at A is 250 m and…

A: Most probable value means the mean value of given data . Given Elevation of point A = 250m Point A…

Q: The cross-section notes shown below are for a ground excavation for a 10m wide roadway. STA 13+8300…

A: To Determine the cross sectional area at STA 13+8300.

Q: A vertical pole stands on a horizontal ground. A topographic geodetic engineer positioned due east…

A: We have to determine the value of height of the pole in m according the given data in the question.

Q: . A Geodetic Engineer used a 100 m. tape in measuring a line and recorded to be 1000.05 m long. The…

Q: Problem: The given data are obtained from the hydrographic survey of a reservoir. The accompanying…

A: Solution Scale = 1 cm = 5 m From the data given, identify the maximum and minimum elevation of…

Q: 2) Determine the total area: A 200 m 85° 25° 75° 40°

Q: How to calculate the mean elevation? The 200, how we arrive on that elevation

A: As we know that the mean elevation between the contours is mean of the elevation values of the index…

Q: he areas enclosed by contour lines at 5 m interval for a reservoir upto the face of the proposed dam…

A: h=5m To find volume of reservoir by prismoidal formula

Q: Show your complete solutions and underline/encirde your Final Answer. Example 9.2. From two…

A: We have to determine the value of coordinate of C as per the given data.

Q: Figure below represent contour lines for ground surface and wells located on it 50 w2 W1 fill table…

A: given-water table elevation of wells-W1=60W2=50W3=40

Q: Q:4) Draw a topographic profile and find out the different geological features on the map.consider 1…

A: Steps are given below; Draw parallel line CD Bring down the projection from line CD perpendicularly…

Q: The three angles of a triangle were measured with the following results: A = 42°05', B = 115°38',…

A: As per guidelines we have to answer only one question please upload the remaining question…

Q: From a transit line to the edge of a river a series of perpendicular offsets are measured. These…

Q: You are required to measure the area of a site by tape only. The measurements are provided as below:…

A: consider numbering of triangles : Triangle ABF is 1 Triangle FGE is 2 Triangle GDC is 3 Area of a…

Q: Define LATERAL EARTH PRESSURES

A: The horizontal pressure exerted by the soil is defined as the lateral earth pressure. The magnitude…

Q: 3. Find the area of a piece of land with an irregular boundary as follows: Station Offset Distance…

A: Given Values: Offset interval (d)=6 units Offset length (Oi) given in tabular form. (10 Values) To…

Q: Problem 2: The area bounded by the water line of a reservoir and the contours with a contour…

A: Diagram is drawn just for illustration and not as per the dimensions as the dimensions are not…

Q: 16. The areas bounded by the waterline of a lake and the contours with contour interval of 2m are as…

A: The volume, V according to prismoidal fromula is given by, V=h3((Sum of first and last ordinate)…

Q: H.W13/ The following offsets were taken from a chain line to a hedge: Distance (m) 0 10 20 30 40 80…

A: In trapezoidal rule Atotal= d [(h1+hn)/2 + h2+.......+hn-1] Where d is common difference And in…

Q: Situation D A transit line is established and the surveyor wants to determine the area bounded by…

Q: given below. Determine the most probable values of the elevation of the point. 1st Line: 2nd Line:…

A: Given data- To Find- The most probable value.

Q: The interior angles of a quadrangle were observed and recorded as follows: A = 108°25'10"…

A: To find most probable value of angle C

Q: a) What is the contour interval? b) What is the lowest elevation? c) What is the highest elevation?…

Q: Lines of levels between B and C are run over four different routes. B is at elevation 825 m and is…

Q: An unknown line was paced by a surveyor and gathered the following data: 489, 483, 488, and 482. He…

Q: Problem 6.3 In 1996, the observed compass bearing of a line was N 64 18' E. During observation, the…

Concept explainers

Site Plan Requirements

A site plan (also known as a plot plan) is a diagram or process to show the proposed improvements on an existing property. A site plan is important, as it provides information regarding the landscape features of a given plot of land. Zoning is done or can be understood with the help of a site plan.

Question

H.W
From: To:
AE (m)
o (m)
B
A
B
10.509
0.006
B
5.360
0.004
C
D
-8.523
0.005
A.
D
A
-7.348
0.003
B
D
-3.167
0.004
A
15.881
0.012
Benchmark A has an elevation of 437.596 m.
What are the most probable values for B, C, D?

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

This is a popular solution!

SEE SOLUTION Check out a sample Q&A here

Step 1: Answer

VIEW

Step 2:

VIEW

Trending now

This is a popular solution!

Step by step

Solved in 2 steps with 2 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, civil-engineering and related others by exploring similar questions and additional content below.

Similar questions

E =29000Ksi I =750inch^4
a = 4.5 mb = 3.8 mc = 43 kNd = 54 kN
ADDITIONAL INFO: KxLx=17.6, KyLy=10, phiPn of W10x77=869kips, phiPn of W12x53=167kips SHOW STEPS
Compute GCD of the following pair of numbers: 51 and 357 11571 and 1767
0 a 2178 kN O b. 3726 kN 1| select one: WG o weiox92
Hiii plz. Plz A
a = 41.60 kNb = 35.50 kN/mc = 19.00 kN/m
FIND THE MOST PROBABLE VALUE OF THE ELEVATION OF A, B, AND C.ELEVATION OF A= 15.727ELEVATION OF B = 18.850ELEVATION OF C = 10.361DIFFERENCE IN ELEVATION BETWEEN B AND A = 3.119 ( B above A)DIFFERENCE IN ELEVATION BETWEEN C AND C = 8.490 ( B above C)DIFFERENCE IN ELEVATION BETWEEN A AND C =5.369 ( A above C)SOLUTION:X = elevation of A X= 15.727 Y-X = 3.119y = elevation of B Y = 18.850 Y-Z = 5.369z = elevation of C Z = 10.361 X-Z = 5.369WRITE NORMAL EQUATIONS IN X, Y AND Z
Need solution, correct answer is -56.8268Mpa
A = 9 Y = 54
Assume P=12
Ʈallow (MPa)=95 Ø(rad)=0.015 a (mm)=80 d (mm)=40