Open tank (4.5 m long, 2.5 m height and 3 m wide) contains liquid (S-0.75) to height 1. m. If this tank is accelerated along its length on a horizontal truck at a constant value of 3.5 m/s, determine pressure at the bottom of the tank at front and rear edges (in kN/m). (take y=9.8 kN/m for water)

Open tank (4.5 m long, 2.5 m height and 3 m wide) contains liquid (S-0.75) to height 1. m. If this tank is accelerated along its length on a horizontal truck at a constant value of 3.5 m/s, determine pressure at the bottom of the tank at front and rear edges (in kN/m). (take y=9.8 kN/m for water)

International Edition---engineering Mechanics: Statics, 4th Edition

4th Edition

ISBN:9781305501607

Author:Andrew Pytel And Jaan Kiusalaas

Publisher:Andrew Pytel And Jaan Kiusalaas

Chapter8: Centroids And Distributed Loads

Section: Chapter Questions

Problem 8.122P: The 12-ft wide quarter-circular gate AB is hinged at A. Determine the contact force between the gate...

See similar textbooks

Related questions

Q: 2. A vertical, triangular gate with water on one side is shown in Figure. Determine the total…

A: To find: The total resultant force acting on the gate and location of the center of pressure. Given:…

Q: 1. A vertical parabolic plate whose height is 2 meters is submerged in a certain liquid (s.g. =…

Q: Open tank (4 m long, 3 m height and 3 m wide) contains liquid (S-0.8) to height 1.5 m. If this tank…

Q: A pipe of diameter (0.5 m) interferes with the bottom surface of a reservoir as shown below.…

A: The force of buoyancy on the cylinder can be determined as,

Q: Milk with a density of 1020 kg/m3 is transported on a level road in a 9-m-long, 3-m-diameter…

A: Given that,

Q: 2. A vertical, triangular gate with water on one side is shown in Figure. Determine the total…

A: Given:Width of the traingular gate, b=2 mheight of the triangular gate, h=3 m

Q: The curved surface given in the figure is defined by y = 3 x−−√x . Determine the horizontal force…

Q: If it is known that the air velocity in the duct is 750 ft/s, usethe mercury manometer measurement…

Q: The water in a 25-m-deep reservoir is kept inside by a 90-m-wide wall whose cross section is an…

A: Consider hc as the hydrostatic center of the water, b is the length of the side at which the…

Q: A 3-m-diameter, 7-m-long cylindrical tank is completely filled with water. The tank is pulled by a…

A: Consider the diagram shown below for the cylindrical tank.

Q: The truck carries an open rectangular container that is 3.9m wide, 3.0m deep and 5.0m long, contains…

A: Givenwidth of the tank w=3.9mdepth of the tank d=3mlength of the tank L=5mdensity of oil…

Q: A 3 m diameter , 7 m long cylindrical tank is completely filled with water. The tank is pulled by a…

Q: Consider a cubical water tank with a side length of 3 m. The tank is half filled with water, and is…

Q: A 4.5 m-diameter vertical cylindrical milk tank rotates at a constant rate of 15 rpm. If the…

A: Given:- The angular velocity of a cylinder is expressed by:

Q: b. A rectangular plane surface 3m wide and 4m deep lies in water in such a way that its plane makes…

A: Let Fp=Total pressure force g= acceleration due to gravity=10m/s2 A= Area of plate=3X4=12m2 ћ =Depth…

Q: A manometer of the shape shown in the figure has limb A filled with water and the limb B with oil…

Q: bläi 5 In the Fig. below is shown the * cross-section of the tank full of water under pressure. The…

Q: 3- The water in a 25-m-deep reservoir is kept inside by a 150-m-wide wall whose cross section is an…

A: Given:h=25 mb=150 mPatm=100 KPa

Q: (1) The gage pressure of the air in the tank shown in the figure is measured to be 40 kPa. Determine…

A: Fluid is a state of matter which deforms continuously on the application of force externally,…

Q: 24: A manometer of the shape shown in the figure has limb A filled with water and the limb B with…

Q: An open settling tank shown in the figure contains a liquid suspension. Determine the resultant…

A: Consider the small element of dy along the y-direction in the profile. θ=600

Q: The hydraulic lift in a car repair shop has an output diameter of 30 cm and is to lift cars up to…

Q: The flow of water from a reservoir is controlled by a 1.5 m wide L-shaped gate hinged at point A, as…

A: Area of plate,A=Width(w)×Height(h)⇒A=(1.5m)×(2.4m)=3.6 m2Vertical distance from top of water to…

Q: A vertical rectangular wall with a width of 20 m and a height of 12 m is holding a7-m-deep water…

A: Given data: H=12 mw=20 mh=7 m Need to determine the resultant hydrostatic force acting on this wall.

Q: A pipe of diameter 0.5 m interferes with .3 the bottom surface of a reservoir as shown below.…

A: Data given- d = 0.5 h = 4 m L = 5 m

Q: H.W.2/: The bottom quarter of a vertical cylindrical tank of total height 0.4 m and diameter 0.3 m…

A: Radius = R = D/2 = 0.3/2 = 0.15 m

Q: Q2) A cylindrical tank of (1.5 m) diameter and height (0.75) m has hemispherical dome Fig. The tank…

A: given relative density = 0.84 (oil) pressure = 50Kpa 4 bolts

Q: Find the location of resultant force( F)of the water on the triangular gate and the force(P)…

A: The force on a plate that is fully submerged in water can be evaluated using the formula given below…

Q: Consider two water tanks filled with water. The first tank is 8 m high and is stationary, while the…

A: Given: The height of the first tank is H=8 m. The height of the second tank is h=2 m. The…

Q: SS 3-35 An open tank is filled with water to the depth indicated. Atmospheric pressure acts on all…

Q: The density of a floating body can be determined by tying weights to the body until both the body…

Q: A 1.09-m-diameter cylindrical mass is connected to a 3-m-wide rectangular gate as shown. The gate is…

Q: Open tank (4.5 m long, 2.5 m height and 3 m wide) contains liquid (S-0.75) to height 1. m. If this…

Q: A flat steel plate is used to seal an opening 1 m wide by 2m high in the vertical wall of a large…

A: Given Data: The density of water is ρ=1000 kg/m3. The height of the opening is l = 2 m. The width…

Q: A vertical, rectangular gate with water on one side in shown in figure. Determine to total resultant…

Q: A 1-m-diameter cylindrical mass, M, is connected to a 2-m wide rectangular gate as shown in the…

Q: Q1: The flow of water from a reservoir is controlled by an L-shaped gate hinged at point A, as shown…

Q: Balloons are often filled with helium gas because it weights only about one seventh of what air…

A: The volume of the balloon can be determined as,

Q: A 5-m-long, 4-m-high tank contains 2.5-m-deep water when not in motion and is open to the atmosphere…

A: The diagram of the water level in case of acceleration in x-direction, The angle is calculated as,…

Q: Q4: A manometer of the shape shown in the figure has limb A filled with water and the limb B with…

Q: Open tank (4.5 m long. 2.5 m height and 3 m wide) contains liquid (S-0.75) to height 1. m. If this…

Q: The gage pressure of the air in the tank shown in the beside Figure is measured to be 65 kPa.…

Q: A 30-cm-diameter, 10-cm-high vertical cylindrical vessel equipped with a vertical tube at the edge…

A: Write the given information.

Q: "Consider a cubical water tank with a side length of 3 m. The tank is half filled with water, and is…

Q: A cannister contains water with a height level of 80 cm and is transported up a bu using a…

A: Givenh=80cm=0.8mwhen moving up a=3.8m/s2when moving downa=3.5m/s2

Q: 3- The water in a 25-m-deep reservoir is kept inside by a 150-m-wide wall whose cross section is an…

Q: The open tank filled with a liquid in full as shown in the figure below has the height of h = 6.00…

A: Height of water, h=6.00 mInclined angle of the wall, θ=45.00oThe width of the wall, w=20.00 mThe…

Q: 4. A 3-m-long and 1-m-wide rectangular gate AB is hinged at point A. The gage reads -110 mmHg while…

Q: AU tube, vertical arms of which have length I and radii r and r2 (r2 > r), is dipped in water with…

A: given data: radius of arm 1st=r1 radius of arm 2nd=r2 surface tention=σ density of liquid=ρ

Question

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Given

VIEW

Solution

VIEW

Page 2

VIEW

Step by step

Solved in 3 steps with 2 images

SEE SOLUTION Check out a sample Q&A here

Similar questions

Q4: The hydraulic lift in a car repair shop has an output diameter of 30 cm and is to lift cars up to 2000 kg. Determine the fluid gage pressure that must be maintained in the reservoir.
A closed tank rectangular in plane with vertical sides is 1.8m deep and contains water to a depth of 1.2m. Air is pumped into the space above the water until the air pressure is 35kN/m2. If the length of one wall of the tank is 3m, determine the resultant force on this wall and the height of the centre of pressure above the base
A tank of water 4 m deep receives a constant upwardacceleration a z . Determine ( a ) the gage pressure at the tankbottom if a z = 5 m 2 /s and ( b ) the value of a z that causes thegage pressure at the tank bottom to be 1 atm.
An open tank containing water is accelerated vertically at 5.8 If the motion is downward with positive acceleration, determine the pressure (kPa) 1.85 m below the surface.
A tank contains a liquid of relative density 0.80. The height of the tank is 4, and the width of the tank is 2m. The tank is subjected to the acceleration of 5m/s^2 along a 30o inclined plane in the upward direction. Under this condition, there is no loss of liquid. determine the slope of free surface determine the pressure at presure
The truck carries an open rectangular container that is 3.9m wide, 3.0m deep and 5.0m long, contains oil of density 811kg/m³ to a depth of 2.1m. If it has a constant acceleration of 6.9m/s². Determine the total force(in kN) acting at the rear wall of the container.
How long will it take the water surface in the tank shown to drop from h = 3 m to h = 50 cm?
For the tank of water shown below, the radius of the circular surface is R=1.0 m, h=1.0m, and the length of the tank is w=2.0 m. Determine (1) the correct expression of the area magnitude whose volume weight is equivalent to the vertical force exerted on the whole curved surfaces_________
The water in a 25-m-deep reservoir is kept inside by a 90-m-wide wall whose cross section is an equilateral triangle. Determine (a) the total force (hydrostatic + atmospheric) acting on the inner surface of the wall and its line of action and (b) the magnitude of the horizontal component of this force. Take Patm = 100 kPa.
The open tank filled with a liquid in full as shown in the figure below has the height of h = 6.00 m. The inclined angle of the inclined wall is = 45.00 °. The width (perpendicular to the screen) of the inclined wall is w = 20.00 m. The specific weight of the liquid is = 9.81 kN/m3. (1) For the inclined wall, determine the average pressure on it._________ (kPa)
A water tank, open at the top, consists of a right circular cylinder and a right circular cone, as shown. If the altitude of the cylinder is three times its radius, and the altitude of the cone is two times the same radius, find the altitude of the cylinder (1 gal=231 cu. in.).
A u_tube whose arms are open to the atmosphere. Now equal volumes of water and light oil. (density =49.4kg/m^3)are poured from different arms. A person blows from the oil side of the u_tube until the contact surface of the two fluid moves to the bottom u_tube, and thus the liquid levels in the two arms are the same .if the fluid height in each arm is 30in,Determine the gauge pressure the person exerts on the oil by blowing.