Answered: (c) Given a solenoid with number of…

(c) Given a solenoid with number of turns = 50, length of 8 cm, radius of 1.5 cm and relative permeability of 4000, calculate the self-inductance per unit length, L'of the solenoid.

University Physics Volume 2

18th Edition

ISBN:9781938168161

Author:OpenStax

Publisher:OpenStax

Chapter14: Inductance

Section: Chapter Questions

Problem 7CQ: Discuss how you might determine the-inductance per unit length of a long, straight wire.

See similar textbooks

Related questions

Q: The self-inductance of a solenoid increases under which of the following conditions?

A: When an electric current is passed through a solenoid, a coil of insulated wire wound on a…

Q: Make a prediction: Increasing the number of coil windings around the iron bar will make the strength…

A: If we wind a wire around a iron bar then this behaves as solenoid with a medium.

Q: Calculate the magnetic field at a point b = 8 cm from one end of a solenoid consisting of 120 turns…

A: number of turns (N) = 120 Lo = 12 cm radius (a) = 4 cm distance of observation point (b) from one…

Q: Must every magnetic configuration have a north pole and a south pole? What about the field due to a…

A: In universe magnetic monopole does not exists. Hence, for any magnetic configuration North and South…

Q: When you turn the shaft of an electric motor by hand, what occurs in the interior coils of wire?

A: The coil of the wire rotates as you turn the shaft of an electric motor by hand.

Q: Would the self-inductance of a 1.0 m long, tightly wound solenoid differ from the self-inductance…

Q: Torque produced in a current carrying loop will be minimum if angle between magnetic field and…

Q: The strength of the magnetic field outside an infinite solenoid is: equal to the strength of the…

A: Ampere's law gives the magnitude of the magnetic field of a solenoid as Bl = μoNi where B =…

Q: (I) Neon signs require 12 kV for their operation. To operatefrom a 240-V line, what must be the…

A: The ratio of secondary to primary turns of the transformer can be obtained as…

Q: The wingspan of a metal aeroplane is 36 m. If the aeroplane is flying at 400 km/h, determine yhe emf…

Q: What would be the effect on B inside a long solenoid if(a) the diameter of all the loops was…

A: a) The magnetic field strength is not affected if the diameter of the loops doubles. ... (b) If the…

Q: A circular coil has a radius of 15.0 cm and carries a current of 2.90 A. If the perpendicular to the…

A: 1) Write the expression for the cross-sectional area.

Q: 6.6 Assume a nonlinear magnetization curve for a current transformer. Show that a percentage…

A: The percentage differential relay is defined as the relay that operates on the phase difference of…

Q: How does the induced magnetic field at the center of the solenoid change with the number of turns?

A: In this problem, it is asking how does the induced magnetic field at the center of the solenoid…

Q: A 24-V battery is connected in series with a resistor and aninductor, with R = 8.0 Ω and L = 4.0 H,…

A: Formula to calculate current at any time in a circuit is,

Q: A student asserted that if a permanent magnet is dropped down a vertical copper pipe, it eventually…

A: when a bar magnet is dropped down a vertical copper pipe due to field from magnet there will be a…

Q: A bar magnet falling inside a vertical metal tube reaches aterminal velocity even if the tube is…

A: A changing magnetic flux induces loops of electric current in a conductor known as the eddy current.…

Q: In what three ways can the strength of an induced current be increased?

A: Explanation: Induced Current(emf): When the conducting loop or coil of wire is placed in a…

Q: Why will there be no induced current for the second item?

A: Induced current due to magnetic field

Q: The following statements concern the magnetic field of a solenoid that has an iron core. Which one…

A: We have a solenoid of length say L, number of windings say N and current running through it is I. So…

Q: When the polarity of the voltage applied to a dc motor is reversed, the direction of motion does not…

A: Introduction: The DC motor is an electrical device that converts electrical energy into mechanical…

Q: How many coils must a loop have with a cross-sectional area of 0.50m? that is pulled through a…

Q: Two identical coaxial circular coils carry the same current I in the same direction. The magnitude…

A: Consider two coils 1 and 2 of radius R, placed coaxially to each other. The figure for the given…

Q: A step-up transformer increases voltage, or potential energy per unit charge. Howis this possible…

A: A transformer with more secondary windings than primary winding, so that it can increase voltage…

Q: How would you shape a given length of wire to give it the greatest self-inductance? The least?

A: The expression for the self inductance is,

Q: Torque produced in a current carrying loop will be maximum if angle between magnetic field and…

A: The torque acting on the wire is directly proportional to the force acting on the wire. The force…

Q: how does the direction of the induced magnetic moment in a conducting loop depend on the direction…

A: SOlution: To find how does the direction of the induced magnetic moment in a conducting loop depend…

Q: In what sense can a transformer be considered an electrical lever? What does it multiply? What does…

A: A transformer is a device that is used to increase or decrease the voltage as required. Since this…

Q: How is the magnetic field due to a solenoid carrying current affected if a soft iron bar is…

A: The strength of the magnetic field will gets increased when we place a core inside of a coil . Iron…

Q: The armature coil of a d.c. motor has a resistance of 0.2 N and is connected to a 120 V supply. Find…

A: Find the armature current. I=V-ER Here, V is the applied voltage, E is the emf, and R is the…

Q: Magnetic field lines can be entirely confined within the core of a toroid, but not within a straight…

A: Magnetic field(B) is given by μ0NI. Where I is the current. In torroid, the magnetic field due to…

Q: At some point, not close to its ends, within a solenoid of arbitrary length, calculate the…

Q: DLA bullet train iw traveling at 1d traveling at 320.0Km/hr a location Earth's magnetic Pield where…

A: Given: Velocity v=320 km/hr =88.88 m/s

Q: Is the maximum magnetic field strength doubled when exciting two coils at the same time? If not,…

A: Is the maximum magnetic field strength doubled when exciting two coils at the same time.

Q: - Consider a long solenoid with radius 1.2cm. A varying current runs through the solenoid to produce…

Q: At what angular velocity in rpm will the peak voltage of a generator be 480 V, if its 500-turn, 8.00…

A: Using the equation for the peak emf, ε=NABωω=εNAB=εNπd24B

Concept explainers

Voltage Across Inductor

An actor is a passive electrical component that consists of a coil bent in the form of wire which uses electromagnetism to produce electric current through the coil. When the electric current flows through a conductor that is the coil, a magnetic flux is developed around the conductor. This flow of current through the coil creates a magnetic field based on Fleming's Right-hand thumb rule. If there is any decrease in the current passing through the inductor, then the magnetic field will also decrease and energy is released through the generation of electric current. There is also a secondary voltage inducing in the same coil due to the magnetic flux, since it opposes any changes in the electric current flowing through the circuit. An inductor is also called choke, coil, or solenoid. A choke is designed to block certain frequencies when the DC current passes. A winding coil is coated with insulation to give extra insulation and protect the circuit. They are usually tightly wrapped around a central core which is cylindrical in nature so that the magnetic flux can be induced. The solenoid is a three-dimension coil that is used to exhibit electromagnetism when the magnetic field is developed due to the current flowing through the coil. The sign convention of the inductor is the same as the power dissipating device. When the current flows into the positive side of the voltage across the inductor, the value is positive and the inductor dissipates power whereas when the inductor releases the power back to the circuit, the current has a negative sign convention. 

Question

(c)
Given a solenoid with number of turns = 50, length of 8 cm, radius of 1.5 cm and
relative permeability of 4000, calculate the self-inductance per unit length, L'of the
solenoid.

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

This is a popular solution!

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step 3

VIEW

Trending now

This is a popular solution!

Step by step

Solved in 3 steps with 3 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, physics and related others by exploring similar questions and additional content below.

Similar questions

Show that the self-inductance per unit length of an infinite, straight, thin wire is infinite.
Check Your Understanding For the circuit of in Figure 14.12(b), show that when steady state is reached, the difference in the total energies produced by the battery and dissipated in the resistor is equal to the energy stored in the magnetic field of the coil.
How does the self- inductance per unit length near the center of a solenoid (away from the ends) compare with its value near the end of the solenoid?
Discuss how you might determine the-inductance per unit length of a long, straight wire.
Check Your Understanding Using Example 12.5, at what distance would you have to move the first coil to have zero measurable magnetic field at point P?
Check Your Understanding (a) Calculate the self-inductance of a solenoid that is tightly wound with wire of diameter 0.10 cm, has a cross-sectional area of 0.90 cm2, and is 40 cm long. (b) If the current through the solenoid decreases uniformly from 10 to 0 A in 0.10 s, what is the emf induced between the ends of the solenoid?
If emf of the battery of Figure 14.12(b) is reduced by a factor of 2, by how much does the steady-state energy stored in the magnetic field of the inductor change?
Would the self-inductance of a 1.0 m long, tightly wound solenoid differ from the self-inductance per meter of in infinite, but otherwise identical, solenoid?
Two infinite solenoids cross the plane of the circuit as shown below. The radii of the solenoids are 0.10 and 020 m, respectively, and the current in each solenoid is changing such that dB/dt50.0T/s . What are die currents in die resistors of the circuit?
A steady current flows through a circuit with a large induct3ve time constant. When a switch in the circuit is opened, a large spark across the terminals of the switch. Explain.
Solenoid A is tightly wound while solenoid B has windings that are evenly spaced with a gap equal to the diameter of the wire. The solenoids are otherwise identical. Determine the ratio of the energies stored per unit length of these solenoids when the same current flows through each.
Since the equation for torque on a current-carrying loop is =NIABsin, the units of N .m must equal units of A. m2T. Verify this.