C1 (ii). Three ldentical capacitors are connected in delta to 435 Volts, F = 50 Hz, 3 phase supply. If the line current is 10 A. Calculate its reactance and capacitance value Reactance Xc is The capacitance of each capacitor, C

C1 (ii). Three ldentical capacitors are connected in delta to 435 Volts, F = 50 Hz, 3 phase supply. If the line current is 10 A. Calculate its reactance and capacitance value Reactance Xc is The capacitance of each capacitor, C

Electricity for Refrigeration, Heating, and Air Conditioning (MindTap Course List)

10th Edition

ISBN:9781337399128

Author:Russell E. Smith

Publisher:Russell E. Smith

Chapter8: Basic Electric Motors

Section: Chapter Questions

Problem 37RQ: Which of the following capacitors could be used to replace a 35-microfarad, 370-volt running...

See similar textbooks

Related questions

Q: Three coils connected in series across a 100 V, 50 Hz supply have the following parameters: R1 = 18…

Q: Two reactors are connected in series across a 10 V, 10 kHz source. They are spaced so that there is…

Q: C1 (ii). Three Identical capacitors are connected in star to 410 Volts, F = 50 Hz, 3 phase supply.…

A: Capacitor are connect in star Voltage 410V Line Current = 12A Reactance and capacitance?

Q: One needs a 100 kVAr A-connected TCR for a three-phase distribution system of 2.4 kVu, and 60 Hz.…

Q: A single core cable for use on 11 kV, 50 Hz system has conductor area of 0.645 cm² and internal…

A: We have a single-core cable for use on system having, Voltage (V) = 11 KV frequency (f) = 50 Hz…

Q: 2. The capacitances of a 3-core belted type cable are measured as detailed below: (i) Between three…

A: The solution is given below

Q: 435 volts, F = 50 Hz, 3 phase supply. If the line current is 38 A. Find the following below:…

A: For star connected system line current is equal to phase current ,phase voltage =line voltage 3…

Q: Calculate the capacitance and charging current of a single-core cable used on a 3-phase, 66 kV…

A: Given data, Length of cable l = 1 km. Core diameter D = 10 cm = 0.1 m Paper thickness d = 7 cm =…

Q: Given the circuit below operating at 60 Hz. Determine all relevant ;ILave=:ILpk=_ quantities.…

Q: In the circuit below, if the inductance L is large enough to operate in continuous current mode. a)…

Q: the diferent contrel strutegies. Emplain imith oppreprinte novoforme used for obtaining chopper. de…

Q: Short Problem: Given a series circuit comprised of the following element: 78.67-ohm resistor,…

Q: A three-phase motor is delta connected to a 415 V, 60 Hz line. If the line current is 25 A and the…

A: Line voltage is given, Line current is given, Power factor before correction is , Frequency,

Q: Short Problem: Given a series circuit comprised of the following element: 78.67-ohm resistor,…

Q: Three identical capacitors of 15 micro farad are connected in delta across a 435 volts, 50Hz, 3-…

A: Given Data: C=15μFV=435Vf=50Hz

Q: A 150 – microfarad capacitor is connected to a 220 – volt, 60 – cycle source. Calculate (a) the…

Q: CI (). Tre dentical capacitor are connected in delta to 430 Volts, = 50 Hz, 3 phase supply.If th…

Q: 34. A 200- ohm resistor, 130 millihenry inductor, and a 66 microfarad are placed in a parallel…

Q: magnitude of its equivalent impedance in ohms.

Q: Three identical capacitors of 25 micro farad are connected in delta across a 420 volts, 50HZ,…

A: Since we only answer up to 3 sub-parts, we’ll answer the first 3. Please resubmit the question and…

Q: Which of the following methods are used for controlling the VAR flow in a power network ? The…

A: Here, the objective is to determine the correct options for the controlling VAR flow.

Q: Q1: A 50HZ,11KV,3-ph,alternator with earthed neutral has a reactance of 50\ph and is connected to…

A: The power system has to transmit power from the generation side to the load side. For this purpose,…

Q: A capacitor is connected across a 120 V, 60 Hz supply. An ammeter indicates 5 A and a wattmeter…

Q: BA Each line of a 3-phase system is suspended by a string of 3 indentical insulators of…

A: Given Question related to application of guard ring, we need to determine the string efficiency.…

Q: Given: HW Rectifier; transformer secondary voltage=32V; Capacitance 4700 micro farads; average load…

A: The data given in the question are: Vs=32V,C=4700μF, Vdc=18V The peak voltage is given as: Vm=322V…

Q: Three identical capacitors of 10 micro farad are connected in delta across a 410 volts, 50HZ,…

A: Resistors, inductors and capacitors form an integral part of any electrical circuit. A source,…

Q: b) A capacitor C is connected in series with a 40 Q resistor across a supply of frequency 60 Hz. A…

A: R=40 Ω frequency=60 Hz current i=3A Impedance =50 Ω ω=2πf=376.8 rad/secZ=R2+XC2502-402=XC2XC=30…

Q: SECTION 10 Ss Assessment Student Handouts MODULE 4: INDUCTANCE AND CAPACITANCE Date: Student Name:…

A: Given two capacitance are connected in parallel. Parallel combination of capacitance is: CT=C1+C2

Q: an AC circuit containing resistance of 10 ohm and inductance of 0.3 in series with 50 Hz AC supply…

Q: Three identical capacitors of 5 micro farad are connected in star across a 415 volts, 50HZ, 3-phase…

A: Given 3 identical capacitors of 10 micro farad are connected in star connection VS=415 VLL rmsf=50…

Q: Electromagnetic interference .controls voltage at all level scarry inrush current for short period…

A: Electromagnetic interference=disturbance of frequency around 10MH Reactive power compensation=shunt…

Q: A 50 Hz, 11KV, 3-ph, alternator with earthed neutral has a reactance of 5 Ω\ ph and is connected to…

Q: (A) The capacitances of a 3-phase belted cable are 12-6 µF between the three cores bunched together…

A: Consider the given below diagram of the cable,

Q: 1) One needs a 100 kVAr A-connected TCR for a three-phase distribution system of 2.4 KVLL and 60 Hz.…

A: A delta connected TCR has 100kVAr capacity of reactive power for a three phase distribution system…

Q: (Q.4) (i) A circuit with capacitance per phase of 90 µF is disconnect source inductance is 2 mH. The…

A: According to question: The current at breakdown is calculated as…

Q: 3. For a parallel circuit of 20 ohms resistor and a 10 ohms inductor, is connected to a 110/60 cps…

A: We need to find out current for given circuit

Q: A 50 Hz, 22 kV generator is corrected to a power system. The system inductance (L) and capacitance…

Q: The capacitance of a single phase two-wire transmission line depends on: Select one: O a. All the…

A: Capacitance of a Single Phase Two Wire Line consisting of two parallel conductors A and B spaced d…

Q: 2. A resistor of 6 0 and an unknown impedance coil in series draw 12 amps from a 120 volts, 60 Hz…

Q: Directions: At the end of each solution (per item) should contain the signature (over printed name)…

Q: C1 (ii). Three lIdentical capacitors are connected in star to 415 Volts, F = 50 Hz, 3 phase supply.…

A: Given:-IL=12AVL=415voltF=50Hz

Q: Three identical capacitors of 10 micro farad are connected in delta across a 415 volts, 50HZ,…

Q: Given a series circuit comprised of the following element: 75.35-ohm resistor, practical inductor…

Q: e) State which part of the UPFC and HPFC is controlling the reactive power flow in the transmission…

A: This is a good problem on power system subject. Look below for the solution once.

Q: Three identical inductors are connected in delta to a 415 V, 50 Hz, 3-phase supply. If L = 0.17 H,…

A: We know that inductive reactance is 2πfL

Q: Two reactors are connected in series across a 10 V, 10 kHz source. They are spaced so that there is…

Q: Three identical capacitors are connected as three phase load to a 440 V, 50 Hz 3-phase supply. If…

Q: Q2: A 33 kV,3-phase underground feeder, 3.4 km long, uses three single core cable. Each cable has a…

A: The solution is given below

Concept explainers

Capacitor

The capacitor is an element used to store electrical energy in the electrical field. A capacitor is a form of passive energy.

Question

C1 (ii). Three Identical capacitors are
connected in delta to 435 Volts, F = 50 Hz, 3
phase supply. If the line current is 10 A.
Calculate its reactance and capacitance
value
Reactance Xc is
The capacitance of each capacitor, C

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step by step

Solved in 2 steps with 1 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, electrical-engineering and related others by exploring similar questions and additional content below.

Similar questions

Three Identical capacitors are connected in star to 435 volts, F = 50 Hz, 3 phase supply. If the line current is 38 A. Find the following below: Phase Voltage, VP in Volts Phase current, Ip in A Capacitive Reactance, Xc in ohms The capacitance of each capacitor, C in Farad
Which of the following capacitors could be used to replace a 188-microfarad, 250-volt starting capacitor? Select one: A. 188 MICROFARAD, 120 VOLT B. 259 MICROFARAD, 120 VOLT C. 200 MICROFARAD, 250 VOLT D. 300 MICROFARAD, 250 VOLT
Three identical capacitors are connected in delta to a 415V, 50 Hz, 3-phase supply. If the line current is 15 A, determine the capacitance of each capacitor.
Three identical capacitors of 5 micro farad are connected in star across a 430 volts, 50Hz, 3-phase supply. What value of capacitance must be connected in delta to take the same line current and line voltage? Phase current in star Phase current in delta Value of Xc in delta Capacitance in delta
A Coil of Resistance RQ and Inductance L in mH in series with a C in µF Capacitor, is connected to a Voltage V, frequency-f Hz supply.Calculate the: (a) Current flowing, (b) (b) Phase Difference between the Supply Voltage and Current, (c) Voltage across the Coil, and (d)Voltage across the Capacitor (e) Draw the circuit diagram (f) Phasor diagram. (Refer XL sheet)
An RG58 coaxial cable has a capacitance of 30 pF per foot and a characteristic impedance of 50 ohms. What is the inductance of the cable per foot.
Given a series circuit comprised of the following element: 53.06-ohm resistor, practical inductor with internal resistance of 0.52 ohm and reactance of 39.04 ohms; and a capacitor with reactance of 19.17 ohms. Compute for equivalent impedance angle in degrees. Note: No Scientific notation. Do not round off in the middle of calculation. Use stored values. Please round off to the nearest 4 decimal places for the final answer.
Given a series circuit comprised of the following element: 92.61-ohm resistor, practical inductor with internal resistance of 0.6 ohm and reactance of 78.43 ohms; and a capacitor with reactance of 7.55 ohms. Compute for the magnitude of its equivalent impedance in ohms. Compute to the nearest 4 decimal places. No Scientific notation. Do not round off in the middle of calculation.
A 230 kV, 3-phase, 50 Hz, 200 km transmission line has a capacitance to earth of 0.03 µF/km per phase. Calculate the inductance and kVA rating of the Peterson coil used for earthing the above system.
A 150 microfarad capacitor is connected to a 220 - volt, 60 - cycle source. Calculate (a) the capacitive reactance, (b) the current in the circuit, (c) the average power taken by the capacitor, and (d) the maximum power delivered to the capacitor.
A 150 – microfarad capacitor is connected to a 220 – volt, 60 – cycle source. Calculate (a) the capacitive reactance, (b) the current in the circuit, (c) the average power taken by the capacitor, and (d) the maximum power delivered to the capacitor. DRAW THE PHASOR DIAGRAM IF POSSIBLE. ROUND OFF TO FOUR DECIMAL PLACES
The resistance and inductance of a coil can be obtained by connecting the coil in series with a known resistance R and measuring the coil voltage Vcoil, the resistor voltage Vr and the total voltage V. The frequency must also be known, but the phase angles of the voltages are not known. Given that f = 60 Hz, R = 10 ohms, Vcoil = 22.4 V, Vr = 20 V and V = 36V. Calculate Xl and Xc