Cable 0.75 m 45° 45° Hinge

Q: A 4-m-long quarter-circlular heavy gate of radius 3 m is hinged about its upper edge A, as shown in…

A: To Determine: (a) The hydrostatic force exerted by the fluid on the Gate. (b) Minimum weight of the…

Q: A water trough of semicircular cross section of radius 0.6 m consists of two symmetric parts hinged…

A: Given data as per question Diameter = 1.2 m

Q: The 18 -ft- long gate of Figure 1 is a quarter circle and it is hinged at H. Determine the…

A: For the curved surface, the force on the surface will be calculated. which we can find as follows…

Q: The tank in Fig. 1 is 3 m wide into the paper. Compute the hydrostatic (a) horizontal force…

A:

Q: A pipe of diameter (0.5 m) interferes with the bottom surface of a reservoir as shown below.…

A: The force of buoyancy on the cylinder can be determined as,

Q: The semicircular plate as shown in the figure is 4 ft long and acts as a gate in channel. Determine…

A:

Q: The semicircular plate in the picture is 5 [ft] long and acts as a gate in a channel. The fluid is…

A: Given:

Q: Using the piezometric concept, compute the magnitude of the resultant force on the indicated area…

A:

Q: Determine the location of the total hydrostatic force from thr bottom surface and the top surface…

A: Given DataPair=32kPaPoil=0.85×1000×9.81×1=8338.5Pa=8.338kPa…

Q: 4. Find the force on the following triangular submerged plate in water and location of its center of…

A: Introduction: The pressure produced by a fluid at equilibrium owing to gravity at a specific place…

Q: Consider a dam of width D and a water body of a depth of H, as shown in the figure below. Determine…

A: In this question we can consider dam wall as vertical surface submerged in water and by figure it is…

Q: A flotation buoy has mass 806 kg, volume 1.43 m, and is attached to the sea floor by a cable in such…

A: Given   Mass of buoy, m = 806 kg    Volume of buoy, V = 1.43 m3 Density of sea water = 1025 kg/m3…

Q: The two sides of a V-shaped water trough are hinged to each other at the bottom where they meet, as…

A: Given V shaped water trough: Here,Width of each side=l=0.75mThe two parts of trough are held…

Q: A rectangular plane surface b = 1 m and d = 3 + 0 lies in water such a way that its plane make an…

A:

Q: Gate ABC is a circular arc, sometimes called a Tainter gate ,which can be raised and lowered by…

A: Given data as per the question radius = 6 m calculations

Q: The cross section of a rectangular AB of width 2.5 m hinged along A is shown in the figure below.…

A: Calculated  the minimum force R at B to hold the gate.

Q: The hemispherical dome in Fig. (4) weighs 30 kN and is filled with water and attached to the floor…

A:

Q: Curved panel BC shown in the figure is a 60 arc, perpendicular to the bottom at C. If the panel is 5…

A: Given data: Radius r=3 m Angle θ=60° wide w=5 m

Q: tank holds water (density of 995.7 kg/m3) with a triangular gate located at the bottom right. The…

A:

Q: A tank holds water (density of 995.7 kg/m3) with a triangular gate located at the bottom right. The…

A: Given data, Density of water, ρ=995.7 kg/m3 Base of triangle, b=0.7 m height of triangle, h=1.4 m…

Q: 1.5 m H F A 4.2m water 30°

A:

Q: A semicircular 40-ft-diameter tunnel is to be built under a 150-ft-deep, 800-ft-long lake. Determine…

A: Given data: Depth of the lake, hd =150 ft Length of the lake, l = 800 ft Diameter of tunnel, d = 40…

Q: An open tank containing water has a bulge with R = 5ft in its vertical side that is semicircular in…

A: Given data,  R= 5 ft  S=11 ft                        ρω=62.4  lb/ft3   l=4 ft…

Q: The face of a dam adjacent to the water has the shape of an isosceles trapezoid of altitude 20 m,…

A:

Q: 1. An elliptical gate covers the end of a pipe 4 m in diameter. If the gate is hinged at the top,…

A:

Q: An elliptical gate covers the end of a pipe 4 m in diameter. If the gate is hinged at the top, what…

A: Diameter = 4m water is 8m deep find the normal force F

Q: The volume of the cylindrical body is 0.04 m³ and its total mass is M ... Kg. The base radius of the…

A:

Q: help me find a solution

A: Given Data Length of the each side is: L=0.75 m Angle at the hinge is: α=45° The width of the sides…

Q: In the set-up shown, a rectangular gate, ABCD, is used to store layers of oil and water. The weight…

A: Givenweight of the gat w=4kNforce exerted by the stopper on the gate F=30kN

Q: If the wall AB shown is 48 meter long calculate the total force (In the uhit of KN) on the wall due…

A:

Q: The two sides of a V-shaped water trough are hinged to each other at the bottom where they meet, as…

A: GIVEN :- θ=45°w=0.75 mLc=6 m   SOLUTION :- vertical height of inclined…

Q: The 2 m diameter and 3.6 m high cistern tank contains kerosen (s.g. =0.8), glycerin (s.g.=1.6) and…

A:

Q: The cover in the figure is hinged at the center O and has a fixed width w = 5 m. The equation of the…

A: Given data, Width of the cover, w = 5 m Equation of the surface, x=y23 Depth, D = 4 m To determine,…

Q: Evaluate the total force on the gate (unit width) and its direction. (specific weights of Water:…

A:

Q: An elliptical gate covers the end of a pipe 4 m in diameter. If the gate is hinged at the top., what…

A:

Q: The rectangular gate CD is 1.8 m wide and 2 m long as shown in the figure below. Water 2.0 m 2.0 m…

A:

Q: The massless, 4-ft-wide gate shown in the figure below pivots about the frictionless hinge O. It is…

A:

Q: A full cylindrical tank having a diameter equal to its height contains water with a total mass of…

A:

Q: The triangular gate shown in the figure has its 6-ft side parallel and 30 ft below the water…

A: Given: The base of the triangular gate is b = 6 ft. The total depth of the triangular gate is H =…

Q: A triangular wooden body (S=0.80) is placed in water in the position indicated in the figure. If the…

A:

Q: 3. The gate shown is a quarter circle 2.5m wide. Find the force F enough to prevent rotation about…

A:

Q: What vertical force is needed to keep the 2- m wide (into the paper) cylindrical gate closed as…

A: Given data as per question Radius of cylinder gate =3 ft =0.9144 m Length of cylinder =2 m the…

Q: A dam is used to store water, and a rectangular gate which is hinged at its bottom edge is used to…

A: Data given- Width = 1  h1 = 1 m h2 = 5 m  Alpha = 65°

Q: The gate shown is 3.0 wide. Find the value of the weight required for the gate to be in equilibrium.…

A: Given data :- Length of gate (l) = 5 m Height of water(h) = 4 m

Q: The Figure below shows a dam 30.5 m long that retains 8 m of fresh water and is inclined at an angle…

A:

Q: A homogeneous, 5-m wide, 4-m-long rectangular gate weighing 80 kN is held in place by a horizontal…

A: Given data: The width of the plate is w=5 m The weight of the rectangular gate is W=80 kN

Slope and Deflection

The slope in a deflected beam is described as an angle in radians made by the tangent of the section with the original axis of the beam. The deflection at any point on the axis of the beam is defined as the lateral displacement of the point before and after loading.