The hemispherical dome in Fig. (4) weighs 30 kN and is filled with water and attached to the floor by six equally-spaced bolts. What is the force in each bolt required to hold the dome down?. (Note Y = 9.79 kN/m³) 3 cm Six bolts 2 m Water Fig. 4 O 97700 N 70900 N Nothing mentioned 90700 N 97000 N

The hemispherical dome in Fig. (4) weighs 30 kN and is filled with water and attached to the floor by six equally-spaced bolts. What is the force in each bolt required to hold the dome down?. (Note Y = 9.79 kN/m³) 3 cm Six bolts 2 m Water Fig. 4 O 97700 N 70900 N Nothing mentioned 90700 N 97000 N

International Edition---engineering Mechanics: Statics, 4th Edition

4th Edition

ISBN:9781305501607

Author:Andrew Pytel And Jaan Kiusalaas

Publisher:Andrew Pytel And Jaan Kiusalaas

Chapter8: Centroids And Distributed Loads

Section: Chapter Questions

Problem 8.122P: The 12-ft wide quarter-circular gate AB is hinged at A. Determine the contact force between the gate...

See similar textbooks

Related questions

Q: Example 3. Hydrostatic Force Acting on the Door of a Submeraed Car • A heavy car plunges into a lake…

Q: A circular plate of 9m radius is submerged vertically in a tank of water so that its top is 4m to…

A: Given data: The radius of the circular plate is r=9 m, The mass density of the water is ρ=1000…

Q: In the Figure below, the cover gate AB closesa circular opening 80 cm in diameter. The gate is held…

A: Given data: Diameter of opening, d = 80 cm. Mass of load, m = 200 kg. The specific weight of water,…

Q: A triangular lamina is immersed vertically in water in such a way that its 6m wide horizontal base…

Q: A block of wood is 30 cm log and has a square vertical section 15 cm on the edge. For it to float in…

Q: Problem 3 A gate is 1.5m in width and hinged at point A. Another point on the gate, B, is resting…

Q: The surface tension of water in air is approximately 0.0072lbf/ft. If the atmospheric pressure is…

Q: Example (4): A hollow cube 1.0 m on each side weighs 2.4 kN. The cube is tied to a solid concrete…

Q: The gate is 160 cm wide, is hinged at point B, and rests against a smooth wall at point A. what is…

Q: 6. For the gate shown, a = 45°C, yı = 1 m, and y2 = 3 m. Will the gate fall or stay in position…

Q: from old wreacks is to attach an inflatable balloon filed with air. Assume that the cannon is a…

Q: Q2/ In the Figure below, gate AB is 4 ft wide into the paper, and stop B will break if the water…

Q: al cm and a thickness of 0.1 mm floats on a fluidic surface and bends the surface 3. A thin metal…

Q: A block with specific gravity of SG= 1.45 and volume V= 0.75m3, is attached to a spring scale. The…

A: Given:- A block with specific gravity of SG= 1.45 Hence density of the block = 1450 kg/m3 (as…

Q: Q2/ The dam in Fig. below is a quarter circle 50 m wide into the paper. Determine the horizontal and…

A: Given data specific weight of water (γwater) = 9790 N/m3 radius of quarter circle (r) = 20 m Width…

Q: PROBLEM # 3 1. A solid block is 70 cm wide, 80 cm long and 20 cm tall, and has a mass of 6700 gm.…

Q: A Triangular gate having a horizontal base of 1.30 m and an altitude of 2 m is inclined 45o from the…

Q: In Fig., the hydrostatic force F is the same on thebottom of all three containers, even though the…

A: Hydrostatic force It is the resultant force which is caused due to pressure loading acted by liquid…

Q: Watersurface. -3 m hinged. gate P 3 m

A: Given data:-specific weight of water, ω=9810N/m3weight of gate, W=800NNow,length of the gate,…

Q: Q3: A square gate (AB) mass (200 kg), resting on smooth bottom (B) and hinge at (A). For what water…

A: Length of AB = 1.3 m inclined at 45 so vertical distance of gate = 1.3sin45 m=0.92 m ;centre of…

Q: Suppose the U-tube in figure is not translated but rather rotated about its right leg at 95 rpm.…

A: Given data: The rotation speed of the right side, ω = 95 rpm. Length of base of the manometer, L =…

Q: A triangular lamina is immersed vertically in water in such a way that its 6 m wide horizontal base…

Q: A graduated cylinder filled with water. A cube is dropped into the cylinder and the water rises. See…

A: Given data, a= side of the cube =3.7 cm γwater= Specific weight of water=9.81x103 N/m3 From the…

Q: Q2/ The dam in Fig. below is a quarter circle 50 m wide into the paper. Determine the horizontal and…

Q: H.W2: The tank in Fig. is 40cm wide. Determine the hydrostatic forces on horizontal plan BC and AD?…

Q: A sliding gate of height 1.4m and width 2.8m lies in vertical plane that weighs 25kN. When the gate…

Q: A concrete cube 25 cm on each side is to be held in equilibrium under water by attaching a…

A: Concrete cube side = 25cm = 0.25m Specific weight Yconcreate= 24 Kn/m2 Yfoam= 0.5 Kn/m2 Ywater =…

Q: Consider the slanted plate AB of length L in Fig. .( a ) Is the hydrostatic force F on the plate…

A: No, the hydrostatic pressure here is not equal to the missing water above the plate. Understand the…

Q: A rectangular watertight box (of treasure) is 660mm long. 520mm wide and 310mm deep. It weighs 323N.…

A: Given Length L= 660 mmW=520mmd=310 mmWeight Wt=323 N

Q: A 0.5-m diameter helium (Density of He = 0.18 kg/m3) balloon is attached by a rope to the bottom of…

Q: 15 ft 2 ft A

Q: 3. For the gate shown, α = 45°, Y₁ = 1 m, and y₂ = 4 m. Will the gate fall or stay in position under…

A: Please find the solution below

Q: Dam ABC in Fig. is 30 m wide into the paper andmade of concrete (SG =2.4). Find the hydrostatic…

A: The centroid of rod AB from the free surface is at 40 m. Now determine the resultant…

Q: A triangular lamina is immersed vertically in water in such a way that its 6 m wide horizontal base…

A: Here, b=6 m, h=4.5 m ∴ Distance of centriod from free surface, x¯=8-13h=8-13×4.5=6.5 m

Q: In Fig. , a one-quadrant spherical shell of radius R issubmerged in liquid of specifi c weight γ and…

A: Given Radius = R Specific weight = γ Depth h >R To find Expression for the resultant hydrostatic…

Q: An open cylinder tank, D= 1.0m, h=1.5m, contain water at depth 1.0m. If this tank rotate about its…

A: Given data:

Q: A cylinder is formed by bolting two semicylindrical channelstogether on the inside, as shown in Fig.…

A: Apply the Bernoulli equation to find surface pressure.

Q: A tank of water (SG = 1.0) has a gate in its vertical wall 5 mhigh and 3 m wide. The top edge of the…

A: Here b=width of gate=3mh=height of gate=5 mSo the area of the gate isA=b×hA=3×5A=15 m2Centroid is…

Q: The cap at point B on the 5-cm-diameter tube in Fig.will be dislodged when the hydrostatic force on…

A: Given data: The diameter of the smaller tube, d = 5 cm. Force acting to dislodged the cap at point…

Q: Problem 3 A gate is 1.5m in width and hinged at point A. Another point on the gate. B. is resting…

A: GIVEN :- Width of the gate : b=1.5 m specific gravity of sea water : sg=1.03 SOLUTION :-…

Q: Proof that a solid aluminum block of 4 mm x 3 mm x 3 mm, such as shown in Figure QI (a), can float…

A: The surface tension of water at 20 degrees Celsius is 0.072 N/m.

Q: A vertical circular gate ABC is 4 m in diameter and is hinged at B, the middle of the gate. When h =…

Q: A plane area of 80 cm 80 cm acts as an escape hatch on a submersible in the Great Lakes. If it is on…

Q: The hemispherical dome in Fig. weighs 30 kN and isfi lled with water and attached to the fl oor by…

A: Assuming no leakage, the hydrostatic force required equals the weight of missing water,…

Q: What vertical force is needed to keep the 2- m wide (into the paper) cylindrical gate closed as…

A: Given data as per question Radius of cylinder gate =3 ft =0.9144 m Length of cylinder =2 m the…

Q: 3. For the gate shown, a = 45°, Y₁ = 1 m, and y₂ = 4 m. Will the gate fall or stay in position under…

Q: ô FLUID 100cm Figure Q1b 200cm Fluid with weight of 25 kN is filled into a container of width 100 cm…

A: Given data, Fluid weight = 25 KN, width = 100 cm, We have to find density and specific weight of…

Question

Choose the correct answer

The hemispherical dome in Fig. (4) weighs 30 kN and is filled with water and attached to
the floor by six equally-spaced bolts. What is the force in each bolt required to hold the
dome down?. (Note Y = 9.79 kN/m³)
3 cm
Six
bolts
2 m
Water
Fig. 4
O 97700 N
70900 N
Nothing mentioned
90700 N
97000 N

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

This is a popular solution!

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step 3

VIEW

Trending now

This is a popular solution!

Step by step

Solved in 3 steps with 3 images

SEE SOLUTION Check out a sample Q&A here

Similar questions

Derive a formula for capillary rise (h) between two concentric glass tubes of radiuses RI and R2. determine its value for water if (G. = 0.072 N/m, RI=30mm, & R2=36mm) (Take smooth and very clean glass tubes).
A cylindrical disk ofwood weighing 45.0 N and having adiameter of 30.0 cm floats on a cylinderof oil of density 0.850 g /cm3(Fig.). The cylinder of oilis 75.0 cm deep and has a diameterthe same as that of the wood.(a) What is the gauge pressure at thetop of the oil column? (b) Supposenow that someone puts a weightof 83.0 N on top of the wood, butno oil seeps around the edge of thewood. What is the change in pressureat (i) the bottom of the oil and(ii) halfway down in the oil?
Consider the slanted plate AB of length L in Fig. .( a ) Is the hydrostatic force F on the plate equal to theweight of the missing water above the plate? If not, correctthis hypothesis. Neglect the atmosphere. ( b ) Can a “missingwater” theory be generalized to curved surfaces of this type?
To what height will 68˚F ethyl alcohol rise in a 0.005 in internal diameter glass capillary tube? The density of the alcohol is 49 lbm/ft3 note ? = 0.00156 ???/ ?? and ? = 0°.
In Fig. , vertical, unsymmetrical trapezoidal panelABCD is submerged in fresh water with side AB 12 ft belowthe surface. Since trapezoid formulas are complicated,( a ) estimate, reasonably, the water force on the panel, in lbf,neglecting atmospheric pressure. For extra credit, ( b ) lookup the formula and compute the exact force on the panel.
The semi-circular plate in Fig. Q3 is 4 m long and acts as a gate in a channel. Determinethe resultant force the water pressure exerts on the plate, and then find thecomponents of reaction at the hinge (pin) B and at the smooth support A. Neglect theweight of the plate.
The 45 ° V-tube in Fig. contains water and is open atA and closed at C . What uniform rotation rate in r/minabout axis AB will cause the pressure to be equal at pointsB and C ? For this condition, at what point in leg BC will thepressure be a minimum?
For the inverted manometer shown in the figure, all the fluid are at 20 0C. If PB - PA = 687 kPa, What must the height H be in cm. Take water density = 1000kg/m3 Mercury density = 13600kg/m3
A closed cylindrical vessel, 2m in diameter & 4m high is fully filled with water & rotated to its vertical axis at a constant speed of 12.2 rad/sec. The top is pressurized by 180 KPa. (a) What is the pressure at the center bottom of the cylinder? (b) What is the pressure at the circumference bottom of the cylinder? (c) What is the total hydrostatic force at the sides of the cylinder?
The pressure at a point “m” in the figure shown was increased from 70 kPa to 105 kPa. This causedthe top level of mercury to move 20 cm in the sloping tube. What is the inclination, θ?
A cylinder is formed by bolting two semicylindrical channelstogether on the inside, as shown in Fig. Thereare 10 bolts per meter of width on each side, and the insidepressure is 50 kPa (gage). Using potential theory for theoutside pressure, compute the tension force in each bolt ifthe fluid outside is sea-level air.
Gate ABC is a circular arc, sometimes called a Tainter gate ,which can be raised and lowered by pivoting about point O .See Fig.. For the position shown, determine ( a ) thehydrostatic force of the water on the gate and ( b ) its line ofaction. Does the force pass through point O ?