Calculate for the buffer capacity if 20 mL of 0.048 M hydrochloric acid is added to 500 mL of buffer solution that is prepared by mixing 315 mL of 1.2 M sodium acetate and 185 mL of 1.0 M acetic acid. (Ka=1.8 x 10- Note: Use complete values on your calculations. Only round off your answer for the buffer capacity. O 0.411 O 0.313 O 0.573 O 0.817

Calculate for the buffer capacity if 20 mL of 0.048 M hydrochloric acid is added to 500 mL of buffer solution that is prepared by mixing 315 mL of 1.2 M sodium acetate and 185 mL of 1.0 M acetic acid. (Ka=1.8 x 10- Note: Use complete values on your calculations. Only round off your answer for the buffer capacity. O 0.411 O 0.313 O 0.573 O 0.817

Introductory Chemistry For Today

8th Edition

ISBN:9781285644561

Author:Seager

Publisher:Seager

Chapter9: Acids, Bases, And Salts

Section: Chapter Questions

Problem 9.102E

See similar textbooks

Similar questions

A buffer is prepared such that [CH3COOH]0 = [CH3COO−]0 = 0.050 M. Calculate the volume of 0.10 M NaOH that can be added to 100.0 mL of the solution before its buffering capcaity is lost. Assume the buffer capacity is lost when the ratio [base]0/[acid]0 is less than 0.1 or greater than 10. Give your answer in mL.
A buffer solution was prepared by mixing 100. mL of 0.500M HF (Ka = 6.6 × 10-4) and 250. mL of 0.250M NaF. You plan to destroy this buffer by addition of KOH. What would be the minimum amount (in grams) of KOH to destroy this buffer?
A 5.145 g sample of a solid, weak, monoprotic acid is used to make a 100.0 mL solution. 27.00 mL of the resulting acid solution is then titrated with 0.09636 M NaOH. The pH after the addition of 16.00 mL of the base is 5.75, and the endpoint is reached after the addition of 45.85 mL of the base. (a) How many moles of acid were present in the 27.00 mL sample?4.42e-3 mol(b) What is the molar mass of the acid?314 g/mol(c) What is the pKa of the acid? (only confused on part c, answers for a and b are given)
1. A 200 ml buffer solution contains 36.342 μg Tris and 23.376 µg NaCl, respectively.Determine the molarities in micromolar (μM) of the above mentioned compounds in thebuffer solution. [Mw Tris = 121.14 g/mol and Mw NaCl = 58.44 g/mol] 2. What volume of cefoxitin (50 mg/ml) should be added to 500 ml of tryptone soya brothto yield a solution with a final concentration of 8 µg/ml?
3 A 0.6423 g sample that might contain NaOH, Na₂CO₃, NaHCO₃, or a permissible mixture of the bases is titrated with 0.1062 M HCl by the double indicator method. It is found that 40.83 mL of the acid are required to reach the phenolphthalein end point. Methyl orange is then added to the solution and the titration continued using an additional 12.38 mL of the acid. Calculate the percentage of each component in the sample.
A student added 501 mL of 0.35 M NaOH to a buffer solution made up of 0.500 mol of citrate (A-), 0.500 mol of citric acid to 1.5 L of water (total volume = 1.5 L) (Ka = 7.41 x 10-4). A.) Calculate the pH of the initial buffer solution (before the addition of the acid). B.) Calculate the pH of the solution after the addition of HCl referenced above. C.) Did the buffer solution exceed its buffer capacity?
A 5.296 g sample of a solid, weak, monoprotic acid is used to make a 100.0 mL solution. 30.00 mL of the resulting acid solution is then titrated with 0.09755 M NaOH. The pH after the addition of 21.00 mL of the base is 5.02, and the endpoint is reached after the addition of 46.38 mL of the base. (a) How many moles of acid were present in the 30.00 mL sample? 0.004524 mol(b) What is the molar mass of the acid?351.1 g/mol(c) What is the pKa of the acid? just need help with part C
A student added 501 mL of 0.35 M HCl to a buffer solution made up of 0.500 mol of citrate (A-), 0.500 mol of citric acid to 1.5 L of water (total volume = 1.5 L) (Ka = 7.41 x 10-4). A.) Calculate the pH of the initial buffer solution (before the addition of the acid). B.) Calculate the pH of the solution after the addition of HCl referenced above. C.) Did the buffer solution exceed its buffer capacity?
(a) Determine the pH of a buffer containing 0.12 M acetic acid (pKa = 4.76) and 0.078 M sodium acetate? (b) For 1.00 L of the buffer in part (a) of this question, estimate its buffer capacity if 14 mL of 1.0 M HCl is added to the buffer. (c) Calculate buffer capacity using the van Slyke equation and compare this value with the buffer capacity determined in part (b) of this question. (d) (i) Calculate the pH of a 55 mg mL-1 solution of ascorbic acid (pKa = 4.17, M = 176.1 g mol-1). (ii) What is the degree of ionization (in %) of a 55 mg mL-1 solution of ascorbic acid at a pH of 2.0 and at a pH of 7.0? (iii) Briefly explain how the differences in ionization values arise between these two pH values. (e) A 5% w/v solution of lignocaine hydrochloride (M = 270.79 g/mol) is prepared. The solubility of lignocaine (M = 234.34 g/mol), a weak organic base (pKa = 7.95 and M = 234.33 g/mol) is 3.81 mg/mL. Calculate the pH at which lignocaine will begin to precipitate out of this solution.
In a biochemistry laboratory, you are asked to prepare a buffer solution to be used as a solvent for isolation of an enzyme. On the shelf are the following solutions, all 1.00 M: formic acid (Ka = 1.8 × 10-4), acetic acid (Ka = 1.8 × 10-5), sodium formate (NaHCO2), and sodium acetate (NaCH3CO2). Describe how you would prepare 1.0 L of a pH = 4.65 buffer solution with total molarity of 0.32 M.
In a titration of 20.37 mL of 0.1773 M H2SO4, 35.89 mL of a NaOH solution are needed. What is the concentration (in mol/L) of the NaOH solution? Include only the numerical answer (no units). In carrying out the first standardization in this experiment, a student used 0.5067 g of potassium hydrogen phthalate (KHP) and 24.97 mL of a NaOH solution are needed to reach the equivalence point. What is the concentration (in mol/L) of the student's NaOH solution? Include only the numerical answer (no units).
Consider the titration of 60.00 mL 0.120 M NaHCO3 with 0.250 M KOH.a. Write the balanced reaction which occurs during the titration:Reaction:b. Determine the pH before NaOH has been added pH =c. Determine the pH after 15.00mL KOH has been added pH =Under each species in the equation, classify as a strong acid (SA), strong base (SB), weak acid (WA) or a weak base (WB) or neutral (N).this problem is continued on the next paged. Determine the pH at the equivalence point pH =e. Determine the pH when 35.0mL KOH has been added