Calculate the average power absorbed by the load

Q: A 3 MW generation station has a load factor of 60 % and maximum load of 800 kw. The actual daily…

A: Given:- P=3MwLoad Factor=60100=0.06Maximum Load=800Kw

Q: . If x has units offeet and y has units of seconds, find the units of z in the following equations:…

A: “Since you have posted a question with multiple sub-parts, we will solve first three sub-parts for…

Q: Log600

A: Logarithm A logarithm is defined as the power to which a number must be raised in order to get some…

Q: Calculate the average power supplied by the source as shown below. * find the averaged power…

A: Given parameters: The series-parallel circuit consisting of R, L, and C components s shown below,…

Q: Find the average power absorbed by the 20-V resistor

A: It is given that:

Q: tariff is used when different consumers are charged at different rate per unit of energy consumed.…

A: - Flat rate tariff is used when different consumers are charged at different rates per unit energy…

Q: Find the average power absorbed by each resistor in the network. (10 points) 12/60° v (+

A:

Q: Y

A:

Q: (a) 50 MJ 400 MJ (b) 8 MJ (d) 6.25 MJ

A: According to the question we have to find the value of the stored energy.

Q: if the area of each p former oil.

A: Since you have asked a multiple question we will solve the first question for you, If you want any…

Q: For the following circuit, determine the average power supplied by the source to the net.

A:

Q: Determine the wind energy per unit mass if the winds speed is 38 Km/Hr.

A: Wind energy is a form of renewable source of energy. This form of energy is very critical as it…

Q: For the following circuit, determine the average power supplied by the source to the network.

A:

Q: 1020° y (rms) J2 2 J1.2 N

A:

Q: If the net flywheel hp of a tractor engine is 250, what is the estimated PTO hp? O 225 O 278

A: Power-take-off It is a device that transfer mechanical power to another piece of equipment

Q: a 20 bs V (0.01s+1) rad's

A: Given the block diagram: We need to find PID gain at peak overshoot=5 %.

Q: The load is given as 6+8j ohms in the system. If the apparent power of the load is 15 kVA, the…

A: Given, Load impedance, ZL=6+8j ohms Apparent power, S = 15 kVA

Q: An equipment that draws 9.4 kW at 0.83 power factor lag.  How much reactive power in kVAr is…

A: Reactive power = active power ×tan(power factor angle). Power factor angle = arc cos(power factor).…

Q: ac = 250 mnH if

A: To find the equivalent inductance across the terminal a-b

Q: Calculate the average power generated by the 10A

A: Given circuit,

Q: The effect of temperature rise in an overhead transmission line is: O a. Decreases the SAG and…

A: Choose the correct option The effect of temperature rise in an overhead transmission line?

Q: Q1 Electrical Tech

A: Hi! Thank you for the question, As per the honor code, we are allowed to answer three sub-parts at a…

Q: Find the average power absorbed by the load with Z = 21 + j24 ohms

A:

Q: IDm ALOO 100s2 Ikse

A: In the given circuit the three impedances 1000ohm, j100ohm, -j4ohm  are in parallel. We will first…

Q: Let the voltage passing through a resistance R = 1000 ± 20 ohm is 10.0 ± 0.1 Volt. The average power…

A:

Q: The average power:from dc supply. The average power.delivered to load from each supply Power…

A:

Q: Power of V1 = power of 1=

A: To solve above problem, we will use Ohm's law and Kirchhoff's law: Ohm's law state that in a current…

Q: average power dissipated in the resistor. Ai(t)

A:

Q: The load of 680 kVA with 0.75 power factor lagging, then the kW rating of the load is

A: Given S(apparant power)=680kVA , power factor=0.75  Find P( real power )

Q: Select in descending order based on percentage the primary energy use of the world O a. petroleum,…

A: There various of energy source in the world . Coal  Natural gas  Petroleum

Q: 2. Determine the average power absorbed by cach resistor, the total average power absorbed and the…

A: Given figure as- I1=12∠45°4I1=3∠45°I2=12∠45°2-j1Ω=12∠45°2.236∠-26.56°I2=5.366∠71.56° A

Q: 10 Ω 8 V

A:

Q: What is the per unit voltage of an electrical network, given an applied voltage of 150260 V and a…

A: In this question we will find per unit voltage with given data...

Q: The current in a single-phase motor lags 50° behind the voltage. What is the power factor of the…

A: Power factor pf = cosin of angle between voltage and current.

Q: (a) 8587.18 W

A:

Q: 1. Find the average power drawn by each charge. Total average power drawn by the load Find. 2. Find…

A: Node: The meeting point of more than two branches in a circuit is referred as a node. KCL: According…

Q: 25. The maximum instantaneous voltage and current output of an alternator are 300 V and 20 A,…

A:

Q: The equipment in a power station costs

A: It is given that: Initial cost of equipment=IDQ 30,000,000Salvage Value=IDQ 1,200,000Useful life=25…

Q: (9) 6 cos 100

A:

Q: What is the average power per sq. meter that can be produced by a tidal current of 1.5 m per second?…

A: Different energy sources are required in day-to-day life. These energy sources can be renewable or…

Q: (B 10 cos t

A:

Q: Total EMF generated in volt is

A:

Q: If power = .90

A: Statistical Power- The probability that test we are performing will reject hypothesis which is null…

Q: Calculate the average power dissipated

A:

Q: A 3 MW generation station has a load factor of 60 % and maximum load of 800 kw. The actual daily…

A: We’ll answer the first question since the exact one wasn’t specified. Please submit a new question…

Q: largest 999 FFF 900 None of the given answers

A:

Q: A generating station has a daily output of 280 MWh and uses 500 tonnes of coal in process. The coal…

A: from the conversion principle 1 tonne = 1000 kg. So 500 tonne= 500000 kg. Energy released per kg = 7…