Answered: What is the average power per sq. meter…

What is the average power per sq. meter that can be produced by a tidal current of 1.5 m per second? Take the sea water density as 1,220 kgm-3. Select one: O A. 4.11 MW O B. 2.01 MW O C. 411.7 kw

Power System Analysis and Design (MindTap Course List)

6th Edition

ISBN:9781305632134

Author:J. Duncan Glover, Thomas Overbye, Mulukutla S. Sarma

Publisher:J. Duncan Glover, Thomas Overbye, Mulukutla S. Sarma

Chapter2: Fundamentals

Section: Chapter Questions

Problem 2.15P: Let a voltage source v(t)=4cos(t+60) be connected to an impedance Z=230. (a) Given the operating...

See similar textbooks

Related questions

Q: A steam power station spends 83916 OMR per annum for coal used in the station. The coal has a…

Q: Wind-turbine units are rated at 8 KW in a rated wind speed of 14 m/s. The stage efficiencies are Cp…

A: Find the diameter of the wine turbine Output power P= 8kW Wind speed 14m/s Find the turbine…

Q: A wind turbine gives maximum output put of 1MW at a wind speed of 15m/s. Refer to the above wind…

A: To find the swept area by the wind turbine (A)

Q: Find the power supplied by the power company. Determine how it changes if the power factor is…

A: In this question, We need to determine the power supplied by the power company? If power factor…

Q: Find the total average power absorbed and the total average power supplied in the network from the…

A: Fig: Given circuit calculate z1…

Q: Read the question carefully and match the answer with its respective question: It has been predicted…

A: given present load factor = 0.67 present year maximum demand = 6 MW load factor = average…

Q: Problem 7.2 Given the circuit shown, find the average power supplied or absorbed by each element.…

Q: Consider the AC voltage shown below. (()v V ponif the frequency of the voltage in units of Hz. DO…

A: The given AC voltage is v1t=2cos50πt+π6 Volts. We need to determine the frequency of the voltage in…

Q: Calculate the rms value of the current shown in the Fig. below. I个 3A 1. VA 1A 2T

A: To find the RMS value of Current

Q: Find the average power absorbed by each element j2 Q 2 2 20/0° V 10/00 V I2 +2

A: Applying KCL at node P

Q: A Hydroelectric Plant has a Turbine and Generator with an efficiency of 86 %. If the dam has a head…

Q: A power station is to supply four regions of loads whose peak values are 10,000 kW, 5000 kW, 8000 kW…

A: Since nothing is given to answer which of the following question but I can find ink marked in Ques…

Q: An equipment that draws 9.4 kW at 0.83 power factor lag. How much reactive power in kVAr is…

A: Reactive power = active power ×tan(power factor angle). Power factor angle = arc cos(power factor).…

Q: URS has two ac generators operating in parallel, supply 2500kW to a load at a lagging power factor…

A: GivenTotal supply=2500 kw at 80% lagging power factorpower delivered by machine 1=1000 Kw at 95% lag

Q: If the potential drop across a circuit be represented by (40+ j25) ▼ with reference to the circuit…

Q: Findd the 2) and RMS valne 24 10 tG)

Q: Find the average power absorbed by the load with Z = 21 + j24 ohms

Q: IDm ALOO 100s2 Ikse

A: In the given circuit the three impedances 1000ohm, j100ohm, -j4ohm are in parallel. We will first…

Q: 15. A residential AC power line voltage is 230 V. What are the average and peak-to-peak voltages? a.…

A: In this question we will find average voltage and peak to peak value for given wave with line…

Q: The 2430 KW average power the plant sShown in fig to and the Power factor is o lo1 logging. The…

Q: For the circuit shown in Fig. find the power supplied by 12 Kv Fig 12kV rms ( 400 kw 0.707 PF lag

A: Given, cosϕ=0.707P=400 KW

Q: A utility company is running three generators (where the system demand for the current time period…

Q: 3. Find Pa, the average power absorbed by the 4-2 resistor c absorbed by the same elements due to vw…

Q: I, -j3 k2 j1 k. 500 2 ell 201, 4 k2 Ix 10 k2 0.2/0° V rms (t

Q: Find the power supplied by the power company. Determine how it changes if the power factor is…

A: This question belongs to circuit theory . It is based on the concept of power factor in the circuit…

Q: The load of 680 kVA with 0.75 power factor lagging, then the kW rating of the load is

A: Given S(apparant power)=680kVA , power factor=0.75 Find P( real power )

Q: Determine the average power absorbed by delta connected load Z, = 30+ j27 N. 100/0° V rms J0.5 Q ZA…

A: The average power is the power divided by the number of cycles. The ac current delivered to a…

Q: Calculate the average power transferred by the source in the circuit given below

A: According to question: The circuit is redrawn as The values of impedance Z1, Z2, Z3, and Z4 at…

Q: Q1: (A) Sketch (-10 cos 377t) with time in seconds.

Q: 2. Determine the average power absorbed by cach resistor, the total average power absorbed and the…

A: Given figure as- I1=12∠45°4I1=3∠45°I2=12∠45°2-j1Ω=12∠45°2.236∠-26.56°I2=5.366∠71.56° A

Q: An industry consumes (x+100) kW at 0.7 p.f. lagging with an annual consumption of 40,000 units. The…

Q: Find the power generated by a wind turbine. - Efficiency of the bearing = 90 - Density of air =…

Q: For the circuit shown in Fig. , find the power supplied by 12 Kv Fig 12kV rms ( 400 kw 0.707 PF lag

A: Let the voltage across the 400 kW load be V2. P=V2×I×Cosϕ400 kW=V2×I×0.707V2×I=4000002V2=4000002I

Q: he power company supplies 80 kW to an industrial load. The load draws 220 A rms from the…

A: At the load end Receiving voltage = 440 V Receiving current = 220 A Receiving pf = 0.8 lag. So…

Q: Given the following AC circuit, calculate the real, reactive, apparent, and complex power absorbed…

A: we need to determine active power, reactive power and complex or apparent power.

Q: Q4) branch. a) Find the average power, apparent power, reactive power, and power factor for each b)…

A: Ans (a) Average power in RC circuit = 12V×I1 Cosθ ------ 1) Current through RC circuit I1 = VZ =…

Q: Q1: If the power generated by a wind system at a height of 50 m is equal to 30 kw at a wind speed of…

A: Given that Pw1=30 KWh1=50 mh2=?v1=4m/sPw2=1.5Pw1v2=2v1 Although it is known that , in the case of…

Q: Calculate the wind power per meter square in Mirpur. Assume average wind speed in Mirpur is 21 km…

A: Given: Average wind speed, V=21 km/h Air density, ρ=1.3 kg/m3 For wind power per meter square, the…

Q: Atmospheric air is blowing at 55 km per hour in a windy province in Mindanao. A windturbine…

A: V=55km/hr=15.27m/secDiameter=20mPower generated=235.04 KW

Q: v1(t) = sin (200nt) v2(t) = sin (200nt + 45°) Specify the frequency of v1 (t) + v2(t) in units of…

Q: Estimate the power required in the United States during the year 2050, in GW, and the energy…

Q: 3. Determine the average power absorbed by each element. Also, determine the average power supplied…

Q: Calculate the power factor of the er source. What is the average power supplied by the 102 4020°…

Q: d.) Average power e.) f.) Power when t=1/480 sec, 1/240 sec, 1/90 sec. Draw voltage, current and…

A: In this question, We need to calculate the average power, power at different different time and…

Q: The power company supplies 80 kW to an industrial load. The load draws 220 A rms from the…

A: Explanation: The power supplied from the power company = 80 kW Load current I = 220 A (rms) Load…

Q: Wind-turbine units are rated at 6 KW in a rated wind speed of 8 m/s. The stage efficiencies are Cp =…

A: The efficiencies are cp = 0.32 ngb = 0.90 ng = 0.92 V = 8 m/s

Q: Let voltage across a load be v(t) = 20 + 40 cos(100t) volt and current through the load by i(t) =…

Q: Consider the following waveform. Volts 5 AA 12 t (sec) -5 Find the RMS value of the voltage…

A: RHS of common signals

Q: Complete the table giving your answers to two decimal places. Reactive Specific Power Power…

A: Milk shed: Given details are P1=6200W.pf=0.75 lagging. The reactive power is calculated as…

Q: The amplitude of the voltage available in the 60-Hz, 230-V power outlet in your home is what? A.…

A: In this we will find The amplitude of the voltage available in the 60-Hz, 230-V power outlet in…

Q: A power plant is characterized by an annual load factor of 60%. Assuming that the annual peak load…

A: Given load factor=60% Annual peak load=20000 kW

Q: 7. The incremental fuel costs for two generating units A and B of a power plant are given by the…

A: (a) For economic loading the incremental fuel cost of the two generating units should be equal. Thus…

Concept explainers

Electrical Energy

Energy is the ability to do work when energy is provided to an object. Everyone needs and uses energy every day, and energy is available in all forms. Electrical energy is stored in charged particles within an electric field. The electric field is just the area around the charged particles. In other words, the charged particles form powerful electric fields in other charged particles within the field. An electric field uses energy from charged particles, causing it to move - in other words, to perform a function.

Question

What is the average power per sq. meter that can be produced by a tidal current of 1.5 m per
second?
Take the sea water density as 1,220 kgm-3.
Select one:
O A. 4.11 MW
O B. 2.01 MW
O C. 411.7 kW

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step by step

Solved in 2 steps

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, electrical-engineering and related others by exploring similar questions and additional content below.

Similar questions

An industrial load connected to a 440 V, 60 Hz line takes 50 A. The current lags the voltage by 30 electrical degrees. What is the power factor of this circuit? Determine the apparent power, in volt-amperes and the true power, in watts
The power company supplies 80 kW to an industrial load. The load draws 220 A rms from the transmission line. If the load voltage is 440 V rms and the load power factor is 0.8 lagging, what is the value of the lost power in the transmission line?
Estimate the power required in the United States during the year 2050, in GW, and the energy consumed, in GJ, from the year 2010 to 2050 if the average consumption rate increases at an average rate of 3.2 percentage /year. Start with the 1980 annual consumption (78.067 quad at 1980 from Annual Energy Review 2011).
If ?(?) = 160cos50? V and ?(?) = −20sin(50? − 30°)A. Calculate the instantaneous power and average power.
The amplitude of the voltage available in the 60-Hz, 230-V power outlet in your home is what? A. 250 V B. 300 V C. 325 V D. 350 V
The power company must generate 100 kW to supply an industrial load with 90 kW through a transmission line with 0.1 ohm resistance. If the load power factor is 0.8 lagging, find the load voltage.
Type your question here An industrial consumer has a maximum demand of 120 kW and maintains a load factor of 80%. The tariff in force is Rs. 60 per kVA of maximum demand plus 8 paise per unit. If the average p.f. is 0·8 lagging, calculate the total energy consumed per annum and the annual bil
Find the average power delivered by the ideal current source in the circuit if ig=40cos 1250t mA.
URS has two ac generators operating in parallel, supply 2500kW to a load at a lagging power factor of 80 %. If one machine delivers 1000 kW to a load at a lagging p.f. of 95 %. At what power factor does it operate the second machine?[0.696 (lag)]
The voltage applied to a coil having R-2002 ohm, L-638 mH is represented by e=20sin 100 pi t. Find a corresponding expression for the current and calculate the average value of the power taken by the coil.
a hydroelectric generating station is supplied from a reservoir of capacity 8 × 106 cubic meters at a head of 400 meters. find the total energy available in kw-hr if the overall efficiency is 78% ?
15. A residential AC power line voltage is 230 V. What are the average and peak-to-peak voltages? a. 207.0727 and 414.1454 b. 207.0727 and 650.5385 c. 230 and 260 d. 325.2691 and 207.0727