Calculate the concentration of a solution of peptide AWSME, in mM if the absorbance at 280 nm for the solution is 0.6 absorbance units, and a 0.2-cm cuvette is used. For the extinction coefficient, take into account that e280(Trp) = 5690 M-1 cm-1 and e280(Tyr) = 1280 M-1 cm-1. Round your answer to two decimals.

Calculate the concentration of a solution of peptide AWSME, in mM if the absorbance at 280 nm for the solution is 0.6 absorbance units, and a 0.2-cm cuvette is used. For the extinction coefficient, take into account that e280(Trp) = 5690 M-1 cm-1 and e280(Tyr) = 1280 M-1 cm-1. Round your answer to two decimals.

Fundamentals Of Analytical Chemistry

9th Edition

ISBN:9781285640686

Author:Skoog

Publisher:Skoog

Chapter24: Introduction To Spectrochemical Methods

Section: Chapter Questions

Problem 24.16QAP

See similar textbooks

Similar questions

Calculate the absorbance at 280 nm that is expected for a 17 microM solution of peptide GRAYISH, if a 10-cm cuvette is used. For the extinction coefficient, take into account that e280(Trp) = 5690 M-1 cm-1 and e280(Tyr) = 1280 M-1 cm-1.
A solution of Tryptophan has an absorbance at 280 nm of 0.54 in a 0.5 cm length cuvette. Given the absorbance coefficient of trp is 6.4 x 103 Lmol-1cm-1. What is the concentration of solution?
The absorption coefficient of rhodopsin at 496 nm is 40,000 M-1cm-1. If you have a 1M solution of rhodopsin, how many times will you dilute the solution so that the diluted solution will give you an absorption reading at 496 nm that is in the range of 0.1-1.0. And what will be the absorption by the diluted solution?
Please complete Table 2 and show the calculations for protein concentration and the concentration of the undiluted sample. a). Using Excel software, enter data from Table 1 to plot a standard curve (corrected average absorbance on Y-axis and protein concentrations on X-axis). The standard curve must contain correct labels on both axes. b). From the standard curve, obtain a best fit line and equation. c). Use the best fit equation and data from Table 2 to find the concentrations of proteins in sample A2-D2 and E1. [onto your plotted standard curve, indicate where A595 of A2-D2 and E1 are located] d). Calculate the concentrations of proteins in undiluted samples A to E. Thank you very much.
A solution of KMnO4 with a concentration of 8.25 x 10-5 M yields an absorbance value of 0.1302 when measured in a 5.60 cm cuvette, set at a wavelength of 725 nm. Compute for the Molar Absorptivity Coefficient of the sample. Choices: a. 2.8182x10-8 c. 4.8182x10-8 b. 3.8182x10-8 d. 5.8182x10-8
In an experiment you measure a solution absorbance of .2 with a path length of 1cm. If the molar absorptivity coefficient is 59cm-1 M-1 what is the concentration in molarity.
What is the concentration of a tyrosine solution when the absorbance at 280 nm is 1.5 using a 1 cm cuvette and the molar extinction coefficient is 1405 L/mol·cm?
Calculate the (a) Linearity constant (r), (b) y-intercept, (c) Slope, and (d) Protein content of an unknown sample having an absorbance of 0.325.
You obtained the following raw data when setting up a Bradford standard curve: BSA (mg/ml) Absorbancy 595nm 0 0.225 1 0.310 2 0.420 3 0.510 4 0.610 5 0.720 6 0.810 7 0.915 8 0.950 9 0.980 10 0.990 After blanking against a bradford-dH2O sample, the protein concentration of an unknown sample was determined using the same method and an absorbancy of 0.523 was obtained. Set up a standard curve, excluding outliers (experimental and statistical) and determine the protein concentration in the unknown sample in mg / ml (up to 3 significant figures).
When we perform Bradford Assay to measure protein concentration, the spectrophotometer is set 595 nm because: a. the excitation peak of Coomassie Blue is best observed at 595 nm b. when Coomassie Blue binds to proteins, its maximum absorbance shifts to 595 nm c. the reducing effects of Coomassie Blue shifts the protein's maximum absorbance to 595 nm d. myoglobin is best observed at 595 nm
A solution of Tryptophan has an absorbance at 280 nm of 0.54 in a 0.5 cm length cuvette. Given the absorbance coefficient of trp is 6.4 x 103 Lmol-1cm-1. What is the concentration of solution? The answers are as follows A)0.17x10-3mol/L B)2.57x10-3mol/L C)0.17x10+3mol/L D)2.57x10+3mol/L
A protein consists of two types of peptide chains (A and B) with an unknown stoichiometry (AxBy). When you ran this protein directly on reversed phase-HPLC with UV monitor set at 280 nm, two peaks were resolved. Mass spec determined that the peaks represented Chain A and Chain B, respectively. The peak area is 500,000 for Peak A (Chain A) and 100,000 for Peak B (Chain B). The molecular masses of Chain A and Chain B are 25,000 and 5000, respectively. The extinction coefficients for Chain A and Chain B are 1 mL/mg.cm and 0.5 mL/mg.cm, respectively. Please calculate x/y.