Calculate the following concentrations for an aluminum hydroxide Al(OH)3 solution containing 150 g of aluminum hydroxide in 150,000 g of water. Density of Aluminum Hydroxide is 2.42 g/mL and water as 1 g/mL. Molar Mass of Aluminum Hydroxide is 78.004 g/mol. A. Percent by Weight - %wt B. Percent by Volume - %vol C. PPT from %wt D. PPM from %wt E. PPB from %wt F. Molarity - M G. Molality - m H. Normality - N

Calculate the following concentrations for an aluminum hydroxide Al(OH)3 solution containing 150 g of aluminum hydroxide in 150,000 g of water. Density of Aluminum Hydroxide is 2.42 g/mL and water as 1 g/mL. Molar Mass of Aluminum Hydroxide is 78.004 g/mol. A. Percent by Weight - %wt B. Percent by Volume - %vol C. PPT from %wt D. PPM from %wt E. PPB from %wt F. Molarity - M G. Molality - m H. Normality - N

Introductory Chemistry For Today

8th Edition

ISBN:9781285644561

Author:Seager

Publisher:Seager

Chapter7: Solutions And Colloids

Section: Chapter Questions

Problem 7.30E

See similar textbooks

Similar questions

For each of the following pairs of solutions, select the solution for which solute solubility is greatest. a. Ammonia gas in water with P = 1 atm and T = 50C Ammonia gas in water with P = 1 atm and T = 90C b. Carbon dioxide gas in water with P = 2 atm and T = 50C Carbon dioxide gas in water with P = 1 atm and T = 50C c. Table salt in water with P = 1 atm and T = 60C Table salt in water with P = 1 atm and T = 50C d. Table sugar in water with P = 2 atm and T = 40C Table sugar in water with P = 1 atm and T = 70C
For each of the following pairs of solutions, select the solution for which solute solubility is greatest. a. Oxygen gas in water with P = 1 atm and T = 10C Oxygen gas in water with P = 1 atm and T = 20C b. Nitrogen gas in water with P = 2 atm and T = 50C Nitrogen gas in water with P = 1 atm and T = 70C c. Table salt in water with P = 1 atm and T = 40C Table salt in water with P = 1 atm and T = 70C d. Table sugar in water with P = 3 atm and T = 30C Table sugar in water with P = 1 atm and T = 80C
Calculate the concentration of concentrated HCl in molarity. Concentrated HCl has 38% (w/w) HCl and a density of 1.185 g cm-3. The MW of HCl is 36.46 g/mol.
If the atmospheric burden of CO2 increases by 27.0 Gt (gigatonnes, 1Gt= 1 x 1012kg) over a given period of time, starting now, and the current atmospheric CO2 is 408.3 ppm, what will the concentration of CO2 be (in ppm) after this increase? (Assume a total atmospheric mass of 5.10 x 1021 g and an average molar mass for air of 29.0 g/mol) 411.8 ppm 408.8 ppm 410.6 ppm 417.0 ppm
What concentration of AgNO3( in ppm) is present in 7.1*10^ -7 M AgNO3? The molar mass of AgNO3 is 170g / mol .
7a) Calculate the number of grams of hydrogen peroxide contained in 25.0 mL of a 3.60 M solution. 7b) What mass of a 30% (w/w) hydrogen peroxide solution is required to provide the mass calculated in question 7a? A w/w solution means g solute/100 g solution. Hint: You need to use your previous answer to 3 sig figs to get this answer to 3 sig figs. Your answer should have 3 sig figs.
The fish canning industry has a waste effluent with the specification as follows: BOD5 = 150 mg/L, COD = 230 mg/L, CaCO3 = 65 mg/L, pH = 7,0, Odor = 11 (TON, where every 1 mg/L ammonia-N equals to 2 TON), Oil = 300 mg/L. Give recommendation of what kind of treatment (physical and chemical steps) is required to treat the wastewater, and why do you select those steps.
Calculate the concentration of NH3, NH4+ and OH- in a solution made by dissolving 2.63 g of NH3 in water to give 786 mL of solution. (Kb of NH3 = 1.81 x 10-5)
A. FERMENTATION OF CANE SUGAR1. In a 500 mL Florence flask, place 50 gms of brown cane sugar and 1 gram ofdisodium phosphate.2. Dissolve 1 teaspoon of yeast in 15 mL of water. Add this to the sugar in the flasktogether with 150 mL water. Stir until the sugar is dissolved.3. Close the flask with a rubber stopper provided with a delivery tube so that theevolved gas will bubble through a solution of clear limewater.4. HAVE THE SET – UP CHECKED BY YOUR INSTRUCTOR.5. Keep the set – up inside the locker for 5 – 6 days at room temperature.Fermentation Set – up: ________________________________Write the equation for the hydrolysis of cane sugar _____________________________Write the equation for the fermentation of the simple sugars to alcohol __________6. At the end of the fermentation period, what is formed in the flask containinglimewater? _________________________________________________________________Write the equation for its formation ____________________________________________ C.…
From a 1000 ppm stock solution of Pb2+, 10 mL are pipetted into a 1000 mL volumetric flask, which is then filled with water. From this new solution, 25 mL are pipetted into a 100 mL flask, which is then filled with water. What is the concentration of the final solution?
1. Two ways the concentration of a solution can be reported are: 1) mass % and 2) molarity. The reagent bottle of concentrated HCl used in Exp. 5 gave a mass percent in the 36.5 – 38% (w/w) range. a.What is the mass % HCl of a 1.00 M HCl (aq) solution? The density of this solution is 1.02 g/mL. b. What volume of 1.00 M HCl would you measure to prepare a 0.300 M HCl solution in a 250-mL volumetric flask? c.Which piece of equipment from the lab drawer should be used to measure this volume to the appropriate degree of accuracy? Explain your reasoning.i.100-mL beaker with graduated markings every 25 mLii.100-mL graduated cylinder with graduated markings every 1 mLiii.100-mL volumetric flask with a calibration mark
What is Molarity of a 10.00% (v/v) acetic acid ? Density of pure acetic acid is 1.05 g/mL.