Calculate the horizontal force P on the light 11° wedge necessary to initiate movement of the 38-kg cylinder. The coefficient of static friction for both pairs of contacting surfaces is 0.29. Also determine the friction force FB at point B. (Caution: Check carefully your assumption of where slipping occurs.) Calculate the horizontal force Pon the light 11° wedge necessary to initiate movement of the 38-kg cylinder. The coefficient of staticfriction for both pairs of contacting surfaces is 0.29. Also determine the friction force FR at point B. (Caution: Check carefully yourassumption of where slipping occurs.)38 kgAPAnswers:P =iNFB = iN

Given data: An angle, θ=11° The mass, m=38 kg The static friction, μ=0.29

Calculate the horizontal force Pon the light 11° wedge necessary to initiate movement of the 38-kg cylinder. The coefficient of static friction for both pairs of contacting surfaces is 0.29. Also determine the friction force Fg at point B. (Caution: Check carefully your assumption of where slipping occurs.) 38 kg P Answers: P = i N FB i N

Calculate the horizontal force Pon the light 11° wedge necessary to initiate movement of the 38-kg cylinder. The coefficient of static friction for both pairs of contacting surfaces is 0.29. Also determine the friction force Fg at point B. (Caution: Check carefully your assumption of where slipping occurs.) 38 kg P Answers: P = i N FB i N

University Physics Volume 1

18th Edition

ISBN:9781938168277

Author:William Moebs, Samuel J. Ling, Jeff Sanny

Publisher:William Moebs, Samuel J. Ling, Jeff Sanny

Chapter11: Angular Momentum

Section: Chapter Questions

Problem 11.1CYU: Check Your Understanding A hollow cylinder is on an incline at an angle of 60 . The coefficient of...

See similar textbooks

Similar questions

Check Your Understanding A car moving at 96.8 km/h travels around a circular curve of radius 182.9 m on a flat county road. What must be the minimum coefficient of static friction to keep the car from slipping?
If the coefficient of static friction between a car’s tires andthe pavement is 0.65, calculate the minimum torque thatmust be applied to the 66-cm-diameter tire of a 1080-kgautomobile in order to “lay rubber” (make the wheels spin,slipping as the car accelerates). Assume each wheel supportsan equal share of the weight.
A train, traveling at 66 mi/h, rounds a horizontal curve of 390 ft radius. A passengerstanding in the lounge notes that she mustlean inward to keep from falling. Let an angle leaning inward be positive and outward benegative.At what angle from vertical must she lean?Since the radius of the curve is much greaterthan the height of the passenger, neglecttorques. 1 mile = 5,280 ft.Answer in units of ◦.
‘or the given configuration minimum value of force ‘F* is applicd such that slipping start between B and C. Caleulate the aceeleration of block B for this condition and the value of F. A 10kg w E “'M‘L B 10kg — weol ¢ sky (@) 15m/5%, 250N ®)10m/s*,200N (©) Sm/st, 260N ()15 m/s*, 260N
A boat exerts a pull of 4000 N on its hawser which iswrapped about a capstan on the dock. If thecoefficient of friction is 0.3, how many turns must thehawser make around the capstan so that the pull at theother end does not exceed 50 N?
Climbers attempting to cross a stream place a 340-kg log against a vertical, frictionless ice cliff on the opposite side (as illustrated in the Figure below). The log slopes up at 27 degrees and its center of gravity is one-third of the way along its 6.3-m length (as marked in the Figure). If the coefficient of friction of the log and the ground is 0.92, what’s the maximum mass of climber and pack to cross without the log slipping?
Consider the 58.5kg mountain climber in the figure. Given Cos = 31 and Sin = 15. What is the minimum coefficient of static friction between her shoes and the cliff?
A yo-yo-shaped devicemounted on a horizontal frictionlessaxis is used to lift a 30 kgbox . Theouter radius R of the device is0.50 m, and the radius r of thehub is 0.20 m. When a constanthorizontal force of magnitude140 N is applied to a ropewrapped around the outside ofthe device, the box, which is suspendedfrom a rope wrappedaround the hub, has an upwardacceleration of magnitude 0.80m/s2.What is the rotational inertiaof the device about its axis of rotation?
What would be the maximum weight W of the block, shown in the following figure, so that the tension developed in any cable does not exeed 100 N
A uniform meter stick of weight W is held by a thumb pushing down at the 0-cm line and by fingers pushing up at the 5-cm line. What are both forces on the meter stick, the force of the thumb T and the force of the fingers F?
A trapeze artist, with swing, weighs 800 N; he is momentarily held to one side by his partner so that the swing ropes make an angle of 30.0° with the vertical. In such a condition of static equilibrium, what is the horizontal force being applied by the partner?
A uniform plank of length 2.00 m and mass 30.0 kg issupported by three ropes, as indicated by the blue vectors inFigure P8.27. Find the tension in each rope when a 700.-Nperson is d = 0.500 m from the left end.